Porous graphene oxide chemi-capacitor vapor sensor array

2017 ◽  
Vol 5 (5) ◽  
pp. 1128-1135 ◽  
Author(s):  
Nagappa L. Teradal ◽  
Sharon Marx ◽  
Ahiud Morag ◽  
Raz Jelinek
Keyword(s):  
Graphene Oxide ◽  
Gas Sensor ◽  
Sensor Array ◽  
Porous Graphene ◽  
New Type ◽  
Vapor Sensor

A new type of cross-selective gas sensor has been developed, based on a vapor-induced capacitance modulation of chemically-functionalized porous graphene oxide (pGO).

Carbon Nanotube Gas Sensor Fabricated on Anodic Aluminum Oxide

2007 ◽  
Vol 124-126 ◽  
pp. 1309-1312
Author(s):  
Nguyen Duc Hoa ◽  
Nguyen Van Quy ◽  
Gyu Seok Choi ◽  
You Suk Cho ◽  
Se Young Jeong ◽  
...  
Keyword(s):  
Carbon Nanotubes ◽  
Carbon Nanotube ◽  
Gas Sensor ◽  
Chemical Vapor ◽  
Fast Response ◽  
Device Fabrication ◽  
Alumina Oxide ◽  
Response And Recovery ◽  
New Type ◽  
P Type

A new type of gas sensor was realized by directly depositing carbon nanotube on nano channels of the anodic alumina oxide (AAO) fabricated on p-type silicon substrate. The carbon nanotubes were synthesized by thermal chemical vapor deposition at a very high temperature of 1200 oC to improve the crystallinity. The device fabrication process was also developed. The contact of carbon nanotubes and p-type Si substrate showed a Schottky behavior, and the Schottky barrier height increased with exposure to gases while the overall conductivity decreased. The sensors showed fast response and recovery to ammonia gas upon the filling (400 mTorr) and evacuation.

scholarly journals Gold and ZnO-Based Metal-Semiconductor Network for Highly Sensitive Room-Temperature Gas Sensing

Sensors ◽  
2019 ◽  
Vol 19 (18) ◽  
pp. 3815
Author(s):  
Renyun Zhang ◽  
Magnus Hummelgård ◽  
Joel Ljunggren ◽  
Håkan Olin
Keyword(s):  
Solar Cells ◽  
Gas Sensor ◽  
Network Structure ◽  
Room Temperature ◽  
Gas Sensing ◽  
Zno Nanowires ◽  
Gold Particles ◽  
Highly Sensitive ◽  
Semiconductor Electronics ◽  
New Type

Metal-semiconductor junctions and interfaces have been studied for many years due to their importance in applications such as semiconductor electronics and solar cells. However, semiconductor-metal networks are less studied because there is a lack of effective methods to fabricate such structures. Here, we report a novel Au–ZnO-based metal-semiconductor (M-S)n network in which ZnO nanowires were grown horizontally on gold particles and extended to reach the neighboring particles, forming an (M-S)n network. The (M-S)n network was further used as a gas sensor for sensing ethanol and acetone gases. The results show that the (M-S)n network is sensitive to ethanol (28.1 ppm) and acetone (22.3 ppm) gases and has the capacity to recognize the two gases based on differences in the saturation time. This study provides a method for producing a new type of metal-semiconductor network structure and demonstrates its application in gas sensing.

scholarly journals Functionalized Reduced Graphene Oxide Thin Films for Ultrahigh CO2 Gas Sensing Performance at Room Temperature

Nanomaterials ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 623
Author(s):  
Monika Gupta ◽  
Huzein Fahmi Hawari ◽  
Pradeep Kumar ◽  
Zainal Arif Burhanudin ◽  
Nelson Tansu
Keyword(s):  
Thin Films ◽  
Graphene Oxide ◽  
Reduced Graphene Oxide ◽  
Gas Sensor ◽  
Functional Groups ◽  
Recovery Time ◽  
Room Temperature ◽  
Co2 Gas ◽  
Reduced Graphene ◽  
Response And Recovery

The demand for carbon dioxide (CO2) gas detection is increasing nowadays. However, its fast detection at room temperature (RT) is a major challenge. Graphene is found to be the most promising sensing material for RT detection, owing to its high surface area and electrical conductivity. In this work, we report a highly edge functionalized chemically synthesized reduced graphene oxide (rGO) thin films to achieve fast sensing response for CO2 gas at room temperature. The high amount of edge functional groups is prominent for the sorption of CO2 molecules. Initially, rGO is synthesized by reduction of GO using ascorbic acid (AA) as a reducing agent. Three different concentrations of rGO are prepared using three AA concentrations (25, 50, and 100 mg) to optimize the material properties such as functional groups and conductivity. Thin films of three different AA reduced rGO suspensions (AArGO25, AArGO50, AArGO100) are developed and later analyzed using standard FTIR, XRD, Raman, XPS, TEM, SEM, and four-point probe measurement techniques. We find that the highest edge functionality is achieved by the AArGO25 sample with a conductivity of ~1389 S/cm. The functionalized AArGO25 gas sensor shows recordable high sensing properties (response and recovery time) with good repeatability for CO2 at room temperature at 500 ppm and 50 ppm. Short response and recovery time of ~26 s and ~10 s, respectively, are achieved for 500 ppm CO2 gas with the sensitivity of ~50 Hz/µg. We believe that a highly functionalized AArGO CO2 gas sensor could be applicable for enhanced oil recovery, industrial and domestic safety applications.

scholarly journals LOCATING GAS SOURCES USING A GAS SENSOR ARRAY

1991 ◽  
Vol 7 (Supple) ◽  
pp. 1565-1568 ◽  
Author(s):  
Yukio Hiranaka ◽  
Hiro Yamasaki
Keyword(s):  
Gas Sensor ◽  
Sensor Array ◽  
Gas Sensor Array

Identification and detection of bioactive compounds in turmeric (Curcuma longa L.) using gas sensor array based on molecularly imprinted polymer quartz crystal microbalance

2021 ◽  
Author(s):  
Fajar IAIN Hardoyono ◽  
Kikin Windhani
Keyword(s):  
Gas Sensor ◽  
Bioactive Compounds ◽  
Quartz Crystal Microbalance ◽  
Molecularly Imprinted Polymer ◽  
Quartz Crystal ◽  
Sensor Array ◽  
Curcuma Longa ◽  
Imprinted Polymer ◽  
Molecularly Imprinted ◽  
Gas Sensor Array

This study aimed to identify four bioactive compounds in turmeric (Curcuma longa L.) using gas sensor array based on molecularly imprinted polymer-quartz crystal microbalance (MIP-QCM). Four QCM sensors coated with...

Sign in / Sign up

Export Citation Format

Share Document