Preparation of nitrogen-doped microporous modified biochar by high temperature CO2–NH3 treatment for CO2 adsorption: effects of temperature

RSC Advances ◽  
2016 ◽  
Vol 6 (100) ◽  
pp. 98157-98166 ◽  
Author(s):  
Xiong Zhang ◽  
Jing Wu ◽  
Haiping Yang ◽  
Jingai Shao ◽  
Xianhua Wang ◽  
...  

Nitrogen-rich agricultural waste, soybean straw, was used as a raw material to prepare high efficiency CO2 adsorbents (nitrogen-doped porous modified biochars).

2010 ◽  
Vol 160-162 ◽  
pp. 307-313
Author(s):  
Zhong Hua Tang

Polyacrylamide after the molecule degradation is used as dispersant and the coal gangue as the raw material to prepare the nanometer Al (OH)3 powder in this paper. Calcining at high temperature to activate coal gangue and controlling the change of C2S crystal were adopted to prepare the self-pulverized material of coal gangue. When the aluminum component part is distilled with NaAlO2 form from the self-pulverized material of coal gangue by using 8% Na2CO3 solution, the high-pure superfine aluminum hydroxide powder is prepared by using the high efficiency dispersant carbonization method. When the influence factor that the high efficiency dispersant carbonization method prepares high-pure superfine aluminum hydroxide powder has been studied, it has been found that the optimum condition of the high efficiency dispersant carbonization method can prepare the high-pure superfine aluminum hydroxide powder. The average granularity of aluminum hydroxide powder that has been prepared is less than 100 nm and the purity is more than 99.9%, for a new way has been opened up for the high value utilization of coal gangue.


2021 ◽  
Author(s):  
Ance Pļavniece

Studies have shown that high-efficiency micro- and mesoporous activated carbon with high added value can be obtained on the basis of lignocellulose biomass in a three-stage thermochemical process. A methodology has been developed for the synthesis of nitrogen-doped activated carbon by synthesis with dicyandiamide in dimethylformamide suspension as a raw material using wood, its processing residues and wood char.


2018 ◽  
Author(s):  
Matthias May ◽  
Kira Rehfeld

Greenhouse gas emissions must be cut to limit global warming to 1.5-2C above preindustrial levels. Yet the rate of decarbonisation is currently too low to achieve this. Policy-relevant scenarios therefore rely on the permanent removal of CO<sub>2</sub> from the atmosphere. However, none of the envisaged technologies has demonstrated scalability to the decarbonization targets for the year 2050. In this analysis, we show that artificial photosynthesis for CO<sub>2</sub> reduction may deliver an efficient large-scale carbon sink. This technology is mainly developed towards solar fuels and its potential for negative emissions has been largely overlooked. With high efficiency and low sensitivity to high temperature and illumination conditions, it could, if developed towards a mature technology, present a viable approach to fill the gap in the negative emissions budget.<br>


2018 ◽  
Author(s):  
Matthias May ◽  
Kira Rehfeld

Greenhouse gas emissions must be cut to limit global warming to 1.5-2C above preindustrial levels. Yet the rate of decarbonisation is currently too low to achieve this. Policy-relevant scenarios therefore rely on the permanent removal of CO<sub>2</sub> from the atmosphere. However, none of the envisaged technologies has demonstrated scalability to the decarbonization targets for the year 2050. In this analysis, we show that artificial photosynthesis for CO<sub>2</sub> reduction may deliver an efficient large-scale carbon sink. This technology is mainly developed towards solar fuels and its potential for negative emissions has been largely overlooked. With high efficiency and low sensitivity to high temperature and illumination conditions, it could, if developed towards a mature technology, present a viable approach to fill the gap in the negative emissions budget.<br>


2021 ◽  
Vol 414 ◽  
pp. 128760
Author(s):  
Wen-Bo Li ◽  
Di Zhou ◽  
Wen-Feng Liu ◽  
Jin-Zhan Su ◽  
Fayaz Hussain ◽  
...  

PeerJ ◽  
2019 ◽  
Vol 6 ◽  
pp. e6186 ◽  
Author(s):  
Ting-Ting Jiang ◽  
Yan Liang ◽  
Xiang Zhou ◽  
Zi-Wei Shi ◽  
Zhi-Jun Xin

Background Sweet sorghum bagasse (SSB), comprising both a dermal layer and pith, is a solid waste generated by agricultural activities. Open burning was previously used to treat agricultural solid waste but is harmful to the environment and human health. Recent reports showed that certain techniques can convert this agricultural waste into valuable products. While SSB has been considered an attractive raw material for sugar extraction and the production of value-added products, the pith root in the SSB can be difficult to process. Therefore, it is necessary to pretreat bagasse before conventional hydrolysis. Methods A thorough analysis and comparison of various pretreatment methods were conducted based on physicochemical and microscopic approaches. The responses of agricultural SSB stem pith with different particle sizes to pretreatment temperature, acid and alkali concentration and enzyme dosage were investigated to determine the optimal pretreatment. The integrated methods are beneficial to the utilization of carbohydrate-based and unknown compounds in agricultural solid waste. Results Acid (1.5−4.5%, v/v) and alkali (5−8%, w/v) reagents were used to collect cellulose from different meshes of pith at 25–100 °C. The results showed that the use of 100 mesh pith soaked in 8% (w/v) NaOH solution at 100 °C resulted in 32.47% ± 0.01% solid recovery. Follow-up fermentation with 3% (v/v) acid and 6.5% (w/v) alkali at 50 °C for enzymolysis was performed with the optimal enzyme ratio. An analysis of the surface topography and porosity before and after pretreatment showed that both the pore size of the pith and the amount of exposed cellulose increased as the mesh size increased. Interestingly, various compounds, including 42 compounds previously known to be present and 13 compounds not previously known to be present, were detected in the pretreatment liquid, while 10 types of monosaccharides, including D-glucose, D-xylose and D-arabinose, were found in the enzymatic solution. The total monosaccharide content of the pith was 149.48 ± 0.3 mg/g dry matter. Discussion An integrated technique for obtaining value-added products from sweet sorghum pith is presented in this work. Based on this technique, lignin and hemicellulose were effectively broken down, amorphous cellulose was obtained and all sugars in the sweet sorghum pith were hydrolysed into monosaccharides. A total of 42 compounds previously found in these materials, including alcohol, ester, acid, alkene, aldehyde ketone, alkene, phenolic and benzene ring compounds, were detected in the pretreatment pith. In addition, several compounds that had not been previously observed in these materials were found in the pretreatment solution. These findings will improve the transformation of lignocellulosic biomass into sugar to create a high-value-added coproduct during the integrated process and to maximize the potential utilization of agricultural waste in current biorefinery processing.


Author(s):  
Hassan Qandil ◽  
Weihuan Zhao

A novel non-imaging Fresnel-lens-based solar concentrator-receiver system has been investigated to achieve high-efficiency photon and heat outputs with minimized effect of chromatic aberrations. Two types of non-imaging Fresnel lenses, a spot-flat lens and a dome-shaped lens, are designed through a statistical algorithm incorporated in MATLAB. The algorithm optimizes the lens design via a statistical ray-tracing methodology of the incident light, considering the chromatic aberration of solar spectrum, the lens-receiver spacing and aperture sizes, and the optimum number of prism grooves. An equal-groove-width of the Poly-methyl-methacrylate (PMMA) prisms is adopted in the model. The main target is to maximize ray intensity on the receiver’s aperture, and therefore, achieve the highest possible heat flux and output concentration temperature. The algorithm outputs prism and system geometries of the Fresnel-lens concentrator. The lenses coupled with solar receivers are simulated by COMSOL Multiphysics. It combines both optical and thermal analyses for the lens and receiver to study the optimum lens structure for high solar flux output. The optimized solar concentrator-receiver system can be applied to various devices which require high temperature inputs, such as concentrated photovoltaics (CPV), high-temperature stirling engine, etc.


2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Noémie Deldicq ◽  
Dewi Langlet ◽  
Camille Delaeter ◽  
Grégory Beaugrand ◽  
Laurent Seuront ◽  
...  

AbstractHeatwaves have increased in intensity, duration and frequency over the last decades due to climate change. Intertidal species, living in a highly variable environment, are likely to be exposed to such heatwaves since they can be emerged for more than 6 h during a tidal cycle. Little is known, however, on how temperature affects species traits (e.g. locomotion and behaviour) of slow-moving organisms such as benthic foraminifera (single-celled protists), which abound in marine sediments. Here, we examine how temperature influences motion-behaviour and metabolic traits of the dominant temperate foraminifera Haynesina germanica by exposing individuals to usual (6, 12, 18, 24, 30 °C) and extreme (high; i.e. 32, 34, 36 °C) temperature regimes. Our results show that individuals reduced their activity by up to 80% under high temperature regimes whereas they remained active under the temperatures they usually experience in the field. When exposed to a hyper-thermic stress (i.e. 36 °C), all individuals remained burrowed and the photosynthetic activity of their sequestered chloroplasts significantly decreased. Recovery experiments subsequently revealed that individuals initially exposed to a high thermal regime partially recovered when the hyper-thermic stress ceased. H. germanica contribution to surface sediment reworking substantially diminished from 10 mm3 indiv−1 day−1 (usual temperature) to 0 mm3 indiv−1 day−1 when individuals were exposed to high temperature regimes (i.e. above 32 °C). Given their role in sediment reworking and organic matter remineralisation, our results suggest that heatwaves may have profound long-lasting effects on the functioning of intertidal muddy ecosystems and some key biogeochemical cycles.


2020 ◽  
pp. 128346
Author(s):  
Yuandong Yang ◽  
Shun Yao ◽  
Yingchao Hu ◽  
Jian Sun ◽  
Qiuwan Li ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document