scholarly journals Core expansion of bis-calix[4]arene-supported clusters

2016 ◽  
Vol 52 (99) ◽  
pp. 14246-14249 ◽  
Author(s):  
Marco Coletta ◽  
Ross McLellan ◽  
Amy Waddington ◽  
Sergio Sanz ◽  
Kevin J. Gagnon ◽  
...  
Keyword(s):  
Magnetic Properties ◽  
Supported Clusters

Stoichiometric control allows for remarkable expansion of the cores of two known bis-calix[4]arene-supported clusters, with concomitant changes to the magnetic properties.

Magnetism of free and supported clusters: a comparative study

Open Physics ◽  
2009 ◽  
Vol 7 (2) ◽  
Author(s):  
OndÅ™ej Å ipr ◽  
Ján Minár ◽  
Hubert Ebert
Keyword(s):  
Magnetic Properties ◽  
Distribution Function ◽  
Electronic Structure ◽  
Spectral Distribution ◽  
Cluster Size ◽  
Size Range ◽  
Magnetic Moments ◽  
Spectral Distribution Function ◽  
Spin Polarized ◽  
Supported Clusters

AbstractThe presented work investigates the differences in magnetic properties of free and supported clusters via ab-initio calculations. The electronic structure of the clusters was calculated using a spin polarized relativistic multiple-scattering Green’s function formalism. We focus on Fe clusters of 2–9 atoms, either free or supported by Ni(001), and on Co clusters of 2–7 atoms, either free or supported by Au(111). For the supported clusters, the spin and orbital magnetic moments depend on the cluster size nearly monotonically, while for the free clusters large quasi-oscillations of magnetic moments with the cluster size were observed. Similarly, for supported clusters, the local spin magnetic moments decrease nearly linearly with increasing coordination number, while for free clusters of the same size range the trend is much more complicated. These findings are consistent with the fact that the spectral distribution function contains much sharper features for free clusters than for supported clusters.

AEM analysis of crystallization in Ti-based amorphous alloys

1983 ◽  
Vol 41 ◽  
pp. 270-271
Author(s):  
A.R. Pelton ◽  
A.F. Marshall ◽  
Y.S. Lee
Keyword(s):  
Magnetic Properties ◽  
Amorphous Alloys ◽  
Amorphous Materials ◽  
Isothermal Annealing ◽  
Amorphous Matrix ◽  
Nucleation And Growth ◽  
Current Interest ◽  
Amorphous Films ◽  
Electrical And Magnetic Properties

Amorphous materials are of current interest due to their desirable mechanical, electrical and magnetic properties. Furthermore, crystallizing amorphous alloys provides an avenue for discerning sequential and competitive phases thus allowing access to otherwise inaccessible crystalline structures. Previous studies have shown the benefits of using AEM to determine crystal structures and compositions of partially crystallized alloys. The present paper will discuss the AEM characterization of crystallized Cu-Ti and Ni-Ti amorphous films.Cu60Ti40: The amorphous alloy Cu60Ti40, when continuously heated, forms a simple intermediate, macrocrystalline phase which then transforms to the ordered, equilibrium Cu3Ti2 phase. However, contrary to what one would expect from kinetic considerations, isothermal annealing below the isochronal crystallization temperature results in direct nucleation and growth of Cu3Ti2 from the amorphous matrix.

Microstructure in soft magnetic E3 (S1, Al) (Sendust) alloys

1988 ◽  
Vol 46 ◽  
pp. 770-771
Author(s):  
June D. Kim
Keyword(s):  
Electron Microscopy ◽  
Magnetic Properties ◽  
Ternary Phase Diagram ◽  
Vertical Tube ◽  
Vacuum Induction Melting ◽  
Induction Melting ◽  
Soft Magnetic ◽  
Quenching Temperature ◽  
Thin Foils ◽  
Vertical Tube Furnace

Iron-base alloys containing 8-11 wt.% Si, 4-8 wt.% Al, known as “Sendust” alloys, show excellent soft magnetic properties. These magnetic properties are strongly dependent on heat treatment conditions, especially on the quenching temperature following annealing. But little has been known about the microstructure and the Fe-Si-Al ternary phase diagram has not been established. In the present investigation, transmission electron microscopy (TEM) has been used to study the microstructure in a Sendust alloy as a function of temperature.An Fe-9.34 wt.% Si-5.34 wt.% Al (approximately Fe3Si0.6Al0.4) alloy was prepared by vacuum induction melting, and homogenized at 1,200°C for 5 hrs. Specimens were heat-treated in a vertical tube furnace in air, and the temperature was controlled to an accuracy of ±2°C. Thin foils for TEM observation were prepared by jet polishing using a mixture of perchloric acid 15% and acetic acid 85% at 10V and ∼13°C. Electron microscopy was performed using a Philips EM 301 microscope.

Magnetic properties of new charge-transfer complexes based on manganese porphyrins

1997 ◽  
Vol 90 (3) ◽  
pp. 407-413
Author(s):  
MARC KELEMEN ◽  
CHRISTOPH WACHTER ◽  
HUBERT WINTER ◽  
ELMAR DORMANN ◽  
RUDOLF GOMPPER ◽  
...  
Keyword(s):  
Magnetic Properties ◽  
Charge Transfer ◽  
Charge Transfer Complexes ◽  
Manganese Porphyrins

Influence of Ni-substitution on magnetic properties of annealed FeNiNbCuSiB alloys

1998 ◽  
Vol 08 (PR2) ◽  
pp. Pr2-111-Pr2-114 ◽  
Author(s):  
P. Vojtaník ◽  
E. Komová ◽  
R. Varga ◽  
R. Matejko ◽  
R. Grössinger ◽  
...  
Keyword(s):  
Magnetic Properties ◽  
Ni Substitution
Sign in / Sign up

Export Citation Format

Share Document