Unlocking the effects of ancillary electron-donors on light absorption and charge recombination in phenanthrocarbazole dye-sensitized solar cells

2016 ◽  
Vol 4 (2) ◽  
pp. 519-528 ◽  
Author(s):  
Heng Wu ◽  
Lin Yang ◽  
Yang Li ◽  
Min Zhang ◽  
Jing Zhang ◽  
...  

We scrutinize the effects of ancillary electron-donors on light absorption and charge recombination in phenanthrocarbazole dye-sensitized solar cells.

2021 ◽  
Vol 5 (4) ◽  
pp. 1171-1183 ◽  
Author(s):  
Alessio Dessì ◽  
Dimitris A. Chalkias ◽  
Stefania Bilancia ◽  
Adalgisa Sinicropi ◽  
Massimo Calamante ◽  
...  

In this paper, we present the design and synthesis of three organic dyes specially developed for the fabrication of dye-sensitized solar cells with potential application in greenhouses cladding.


2012 ◽  
Vol 125 (3) ◽  
pp. 1007-1009 ◽  
Author(s):  
Emanuele Maggio ◽  
Natalia Martsinovich ◽  
Alessandro Troisi

RSC Advances ◽  
2017 ◽  
Vol 7 (67) ◽  
pp. 42013-42023 ◽  
Author(s):  
Ting-Kuang Chang ◽  
Yun Chi

The sensitizer TF-tBu_C3F7 has shown the highest overall efficiencies of JSC = 18.47 mA cm−2, VOC = 767 mV, FF = 0.71 and PCE = 10.05% under simulated one sun irradiation, due to the fine balance between dye loading and reduced charge recombination.


RSC Advances ◽  
2015 ◽  
Vol 5 (103) ◽  
pp. 84959-84966 ◽  
Author(s):  
Dong-Li Gao ◽  
Yi Wang ◽  
Ping Zhang ◽  
Li-Min Fu ◽  
Xi-Cheng Ai ◽  
...  

Charge recombination takes place, respectively, within the frameworks of transfer- and transport-limited recombination mechanisms, at low and high electron density.


Author(s):  
Suping Jia ◽  
Tong Cheng ◽  
Huinian Zhang ◽  
Hao Wang ◽  
Caihong Hao

Defect states in the TiO2 nanoparticles can cause severe charge recombination and poor electron-transport efficiency when used as a photoanode in dye-sensitized solar cells (DSSCs). Herein, we report a simple and practical way to passivate the surface defects of TiO2 through hydrothermal treating with acetic acid and H2SO4, introducing a high percentage of 101 facets and sulfonic acid functional groups on the TiO2 surface. A high efficiency of 8.12% has been achieved, which is 14% higher than that of untreated TiO2 under the same condition. EIS results prove that the multiacid-treated TiO2 can promote electron transport and reduce charge recombination at the interface of the TiO2 and electrolyte. This work provides an efficient approach to engineer the electron-transport pathway in DSSCs.


2019 ◽  
Vol >15 (5) ◽  
pp. 501-505 ◽  
Author(s):  
Mohammad Rezaul Karim ◽  
Muhammad Ali Shar ◽  
Syed Abdullah

Background: Energy crisis is a vital issue worldwide and it will be increased tremendously in future. Alternative energy sources have been sought for the betterment of the future world. Solar energy is an alternative energy resource with plenty of opportunities. To make user- friendly and cheaper solar cells, dye-sensitized solar cells are tried to develop in this aspect. Objective: Single dye is not good enough to capture a wide range of solar light. The blending of different dyes is an alternative approach to harvest a wider range of solar lights on solar cells. Here, N719 and IR dyes were utilized to get UV-VIS and NIR ranges of solar lights in dye-sensitized solar cells. Methods: Dye-sensitized solar cells (DSSCs) were fabricated by using mixed dyes with various combinations of N719 (dye A) and IR dyes (dye B). The mixed dyes solutions were adsorbed on titanium dioxide (TiO2) and revealed significant light absorption & photosensitization compared with the individual dye solutions. The DSSCs fabricated with more percentage of IR dyes exhibited the best sensitization and broader spectrum. Results: The light absorption spectrum of the blended dyes solutions was confined peaks resultant of both N719 and IR dyes. The maximum efficiencies of 7.91% and 7.77% were obtained with 70% and 80% of IR dyes, respectively. Conclusion: Both N719 and IR mixed dyes solar cells were fabricated successfully for the first time. The relevant reasons behind the working of N719 and IR mixed dyes solar cells have been discussed. It was also noted that only IR dyes sensitized cells did not function under the simulated sunlight.


Nanomaterials ◽  
2019 ◽  
Vol 9 (12) ◽  
pp. 1645 ◽  
Author(s):  
Seong Il Cho ◽  
Hye Kyeong Sung ◽  
Sang-Ju Lee ◽  
Wook Hyun Kim ◽  
Dae-Hwan Kim ◽  
...  

At an elevated temperature of 90 °C, a chemical bath deposition using an aqueous solution of Zn(NO3)2·6H2O and (CH2)6N4 resulted in the formation of both nanoflowers and microrods of ZnO on F-doped SnO2 glass with a seed layer. The nanoflowers and microrods were sensitized with dyes for application to the photoelectrodes of dye-sensitized solar cells (DSSCs). By extending the growth time of ZnO, the formation of nanoflowers was reduced and the formation of microrods favored. As the growth time was increased from 4 to 6 and then to 8 h, the open circuit voltage (Voc) values of the DSSCs were increased, whilst the short circuit current (Jsc) values varied only slightly. Changes in the dye-loading amount, dark current, and electrochemical impedance were monitored and they revealed that the increase in Voc was found to be due to a retardation of the charge recombination between photoinjected electrons and I3− ions and resulted from a reduction in the surface area of ZnO microrods. A reduced surface area decreased the dye contents adsorbed on the ZnO microrods, and thereby decreased the light harvesting efficiency (LHE). An increase in the electron collection efficiency attributed to the suppressed charge recombination counteracted the decreased LHE, resulting in comparable Jsc values regardless of the growth time.


2020 ◽  
Vol 49 (11) ◽  
pp. 6317-6324
Author(s):  
Wei-Qiang Zhu ◽  
Yin-Bu Mao ◽  
Yi-Zhi Chang ◽  
Wen-Jie Fan ◽  
Da-Zhi Tan ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document