Preparation and application of amorphous Fe–Ti bimetal oxides for arsenic removal

RSC Advances ◽  
2015 ◽  
Vol 5 (109) ◽  
pp. 89545-89551 ◽  
Author(s):  
Pinhua Rao ◽  
Zhaowei Sun ◽  
Wenqi Zhang ◽  
Wei Yao ◽  
Luanjiao Wang ◽  
...  
Keyword(s):  
Arsenic Removal ◽  
Precipitation Method ◽  
Co Precipitation

A series of Fe–Ti bimetal oxides for As(iii) and As(v) removal were synthesized through a co-precipitation method.

scholarly journals Evaluation of Fe-Mg Binary Oxide for As (III) Adsorption—Synthesis, Characterization and Kinetic Modelling

Nanomaterials ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 805
Author(s):  
Saif Ullah Khan ◽  
Rumman Zaidi ◽  
Feroz Shaik ◽  
Izharul Haq Farooqi ◽  
Ameer Azam ◽  
...  
Keyword(s):  
Arsenic Removal ◽  
Kinetic Modelling ◽  
Arsenic Concentration ◽  
Experimental Studies ◽  
Precipitation Method ◽  
Arsenic Adsorption ◽  
Adsorbent Dosage ◽  
X Ray ◽  
Co Precipitation ◽  
Contaminated Waters

Nanotechnology has received much attention in treating contaminated waters. In the present study, a facile co-precipitation method was employed to synthesize a novel iron and magnesium based binary metal oxide using a stoichiometrically fixed amount of FeNO3.9H2O and MgNO3.6H2O in a proportion of molar concentration 1:1 and was later evaluated in removing As (III) from contaminated waters. Characterization of the prepared nanomaterial was done using X-ray diffraction (XRD), scanning electron microscopy (SEM), Energy Dispersive X-Ray Analysis (EDAX) and ultraviolet–visible spectrophotometry (UV-VIS). Experimental studies on batch scale were carried out, examining the effect of varying initial concentrations of metal, adsorbent dosage, application time and initial pH on removal efficiency. Arsenic removal increased on increasing adsorbent dosage (0.1–1 g/L) but trend reversed on increasing initial arsenic concentration attaining qmax of 263.20 mg/g. Adsorption was quite efficient in pH range 4–8. Freundlich fitted better for adsorption isotherm along with following Pseudo-2nd order kinetics. The reusability and effect of co-existing ions on arsenic adsorption, namely SO42−, CO32− and PO43− were also explored with reusability in 1st and 2nd cycles attained adsorptive removal up to 77% and 64% respectively. The prepared nano-adsorbent showed promising results in terms of high arsenic uptake (qmax of 263.20 mg/g) along with facile and cost-effective synthesis. Thus, the co-precipitation technique used in this work is a simple one step procedure without any use of any precursor as compared to most of the other procedures used for synthesis.

scholarly journals Arsenic removal from water by Zr-γ- FeOOH nanoparticles

2019 ◽  
Vol 2 (1) ◽  
pp. 112-120
Author(s):  
Nguyen Dinh Trung ◽  
Le Thi Ha Lan
Keyword(s):  
Ammonium Chloride ◽  
Arsenic Removal ◽  
Precipitation Method ◽  
Freundlich Isotherms ◽  
Langmuir And Freundlich Isotherms ◽  
Adsorption Data ◽  
Wide Ph Range ◽  
Ph Range ◽  
Co Precipitation ◽  
Competitive Ions

Zr-γ-FeOOH nanoparticle adsorbent for As(V) and As(III) removal was prepared by a chemical co-precipitation method. Compared with γ-FeOOH, the addition of Zr enhanced the adsorptive capacities of As(V) and As(III). The maximum adsorptive capacities for As(V) and As(III) were 69.81 and 94.25 mg/g, respectively (rate Fe:Zr =1:0.5) at pH= 7.0. The adsorption data accorded with Langmuir and Freundlich isotherms. The adsorption of As(III) by Zr- γ-FeOOH was found to be effective in wide pH range of 6–8. Competitive ions hindered the adsorption according to the decreasing sequence phosphate, sulfate, ammonium, chloride, magnesium and calcium. The high adsorptive capability and good performance on other aspects make the Zr-γ- FeOOH nanorods a promissing adsorbent for the removal of As(V) and As(III) from groundwater.

Magnetic and dielectric properties of BiFeO3 nanoparticles

2015 ◽  
Vol 7 (2) ◽  
pp. 1393-1403
Author(s):  
Dr R.P VIJAYALAKSHMI ◽  
N. Manjula ◽  
S. Ramu ◽  
Amaranatha Reddy
Keyword(s):  
Diffuse Reflectance Spectrum ◽  
Precipitation Method ◽  
Secondary Phases ◽  
X Ray Diffraction ◽  
Bifeo3 Nanoparticles ◽  
Transmission Electron ◽  
Multiferroic Bifeo3 ◽  
Pure Phase ◽  
Simple Chemical ◽  
Co Precipitation

Single crystalline nano-sized multiferroic BiFeO3 (BFO) powders were synthesized through simple chemical co-precipitation method using polyethylene glycol (PEG) as capping agent. We obtained pure phase BiFeO3 powder by controlling pHand calcination temperature. From X-ray diffraction studies the nanoparticles were unambiguously identified to have a rhombohedrally distorted perovskite structure belonging to the space group of R3c. No secondary phases were detected. It indicates single phase structure. EDX spectra indicated the appearance of three elements Bi, Fe, O in 1:1:3. From the UV-Vis diffuse reflectance spectrum, the absorption cut-off wavelength of the BFO sample is around 558nm corresponding to the energy band gap of 2.2 eV. The size (60-70 nm) and morphology of the nanoparticles have been analyzed using transmission electron microscopy (TEM).   Linear M−H behaviour and slight hysteresis at lower magnetic field is observed for BiFeO3 nanoparticles from Vibrating sample magnetometer studies. It indicates weak ferromagnetic behaviour at room temperature. From dielectric studies, the conductivity value is calculated from the relation s = L/RbA Sm-1 and it is around 7.2 x 10-9 S/m.

Exploring the characterization of Ni doped MgO nanoparticles using co-precipitation method

2020 ◽  
Vol 3 (1) ◽  
pp. 30-33
Author(s):  
Muthulakshmi M ◽  
Madhumitha G
Keyword(s):  
Magnesium Oxide ◽  
Analytical Techniques ◽  
Nickel Chloride ◽  
Precipitation Method ◽  
Crystalline Powder ◽  
High Melting Point ◽  
Design Synthesis ◽  
Mgo Nanoparticles ◽  
Co Precipitation

Nanotechnology is a field of applied science focused on design, synthesis and characterization of nanomaterials. The nickel and magnesium have improved their applications in transparent electrodes and nano electronics. In addition, magnesium oxide has moisture resistance and high melting point properties. In the present work has been carried out in the development of green crystalline powder of nickel doped magnesium oxide nanoparticles by Co-precipitation method, from the mixture of nickel chloride and magnesium chloride with KOH as solvent. From the XRD results, crystalline size of the particle can be observed. Spherical structure of Ni doped MgO nanoparticles were indicated by SEM results and powdered composition of samples were obtained from FTIR. EDAX represents the peak composition of the nanoparticle. The above analytical techniques have confirmed that the Ni doped MgO nanoparticles obtained from the mixture of NiCl2 and MgCl2.

Diseases Prevention by Water Defluoridation Using Hydrotalcites as Decontaminant Materials

2017 ◽  
Vol 68 (1) ◽  
pp. 168-171 ◽  
Author(s):  
Letitia Doina Duceac ◽  
Cristina Elena Dobre ◽  
Ioana Pavaleanu ◽  
Gabriela Calin ◽  
Simona Nichitus ◽  
...  
Keyword(s):  
Dental Fluorosis ◽  
Precipitation Method ◽  
Original Structure ◽  
Fluoride Removal ◽  
Major Goal ◽  
Bone Stiffness ◽  
Morphological Aspects ◽  
Adsorption Capacities ◽  
Interlayer Structure ◽  
Co Precipitation

Preventing diseases is deemed to be the major goal of our century especially when an excessive fluoride in drinking water can cause dental fluorosis, bone stiffness, rheumatism and skeletal fluorosis. Fluoride uptake from groundwater implies a worldwide multidisciplinary effort in order to develop renewable, cheap, human friendly materials. Among other materials, hydrotalcites could be good candidates for an efficient fluoride removal from water due to their adsorption, anion exchange and reconstruction properties. These nanostructured materials were synthesized using co-precipitation method in controlled conditions. Presence of anions in the interlayer structure and morphological aspects were performed by FTIR and SEM techniques. Thermal treatment of hydrotalcites showed good adsorption capacities for water defluoridation mostly due to their tendency to restore the original structure.

Synthesis of highly sinterable YAG nanopowders by a modified co-precipitation method

2007 ◽  
Vol 433 (1-2) ◽  
pp. 328-331 ◽  
Author(s):  
Zhi-Hui Chen ◽  
Yun Yang ◽  
Zhang-Gui Hu ◽  
Jiang-Tao Li ◽  
Shu-Li He
Keyword(s):  
Precipitation Method ◽  
Co Precipitation

scholarly journals Photoluminescent Properties of Hydroxyapatite and Hydroxyapatite/Multi-Walled Carbon Nanotube Composites

Crystals ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 832
Author(s):  
Edna X. Figueroa-Rosales ◽  
Javier Martínez-Juárez ◽  
Esmeralda García-Díaz ◽  
Daniel Hernández-Cruz ◽  
Sergio A. Sabinas-Hernández ◽  
...  
Keyword(s):  
Carbon Nanotube ◽  
Hexagonal Phase ◽  
Precipitation Method ◽  
X Ray Diffraction ◽  
X Ray ◽  
Multi Walled Carbon Nanotube ◽  
Nanotube Composites ◽  
Carbon Nanotube Composites ◽  
Co Precipitation ◽  
Functionalized Mwcnts

Hydroxyapatite (HAp) and hydroxyapatite/multi-walled carbon nanotube (MWCNT) composites were obtained by the co-precipitation method, followed by ultrasound-assisted and microwave radiation and thermal treatment at 250 °C. X-ray diffraction (XRD) confirmed the presence of a hexagonal phase in all the samples, while Fourier-transform infrared (FTIR) spectroscopy elucidated the interaction between HAp and MWCNTs. The photoluminescent technique revealed that HAp and the composite with non-functionalized MWCNTs present a blue luminescence, while the composite with functionalized MWCNTs, under UV-vis radiation shows an intense white emission. These findings allowed presentation of a proposal for the use of HAp and HAp with functionalized MWCNTs as potential materials for optoelectronic and medical applications.

Sign in / Sign up

Export Citation Format

Share Document