Interface engineering and efficiency improvement of monolayer graphene–silicon solar cells by inserting an ultra-thin LiF interlayer

RSC Advances ◽  
2015 ◽  
Vol 5 (58) ◽  
pp. 46480-46484 ◽  
Author(s):  
Dikai Xu ◽  
Xuegong Yu ◽  
Lijian Zuo ◽  
Deren Yang
Keyword(s):  
Solar Cells ◽  
Surface Recombination ◽  
Silicon Solar Cells ◽  
Back Surface ◽  
Monolayer Graphene ◽  
Efficiency Improvement ◽  
Interface Engineering ◽  
Si Solar Cells

A thin LiF layer can suppress the back surface recombination and improve the efficiency of Gr–Si solar cells.

The Effect of Al-BSF on Seff and Rb in Industrialized Mono-Silicon Solar Cells

2012 ◽  
Vol 472-475 ◽  
pp. 1846-1850
Author(s):  
Shan Shan Dai ◽  
Gao Jie Zhang ◽  
Xiang Dong Luo ◽  
Jing Xiao Wang ◽  
Wen Jun Chen ◽  
...  
Keyword(s):  
Solar Cells ◽  
Spectral Response ◽  
Short Circuit ◽  
Rear Surface ◽  
Surface Recombination ◽  
Short Circuit Current ◽  
Open Circuit ◽  
Surface Recombination Velocity ◽  
Silicon Solar Cells ◽  
Back Surface

In this work, the effect of aluminum back surface field formed by screen printed various amount of Al paste on the effective rear surface recombination velocity (Seff) and the internal rear reflectance coeffeicient (Rb) of commercial mono-silicon solar cells was investigated. We demonstrated the effect of Seffand Rbon the performance of Al-BSF solar cells by simulating them with PC1D. The simulated results showed that the lower Seffcould get higher open circuit voltage (Voc), at the same time, the larger Rbcould get higher short-circuit current (Isc). Experimentally, we investigated the Seffand Rbthrough depositing Al paste with various amount (3.7, 5, 6, and 8 mg/cm2) for fabricating Al-BSF mono-silicon solar cells. Four group cells were characterized by light I-V, spectral response, hemispherical reflectance and scanning electron microscope (SEM) measurements. It was found that, a minimum Seffof 350 cm/s was gotten from the cells with Al paste of 8 mg/cm2, which was extracted by matching quantum efficiency (QE) from 800 nm to 1200 nm with PC1D, and a maximum Rbof 53.5% was obtained from Al paste of 5 mg/cm2by calculating at 1105 nm with PC1D. When the amount of Al paste was higher than 5mg/cm2, there were less Seffand lower Rb. On the other hand, when Al amount was 3.7mg/cm2, it was too little to form a closed BSF. Based on the SEM graphs and simulations with PC1D, a simple explaination was proposed for the experimental results.

Low effective back‐surface recombination velocity by boron implantation on 0.3‐Ω‐cmp‐type silicon solar cells

1988 ◽  
Vol 63 (9) ◽  
pp. 4683-4687 ◽  
Author(s):  
Leendert A. Verhoef ◽  
Albert Zondervan ◽  
Fredrik A. Lindholm ◽  
Mark B. Spitzer ◽  
Christopher J. Keavney
Keyword(s):  
Solar Cells ◽  
Surface Recombination ◽  
Surface Recombination Velocity ◽  
Silicon Solar Cells ◽  
Back Surface ◽  
Type Silicon ◽  
Boron Implantation ◽  
Recombination Velocity

Screen-printed n-type Si solar cells with laser-doped selective back surface field

Solar Energy ◽  
2021 ◽  
Vol 220 ◽  
pp. 211-216
Author(s):  
H.P. Yin ◽  
W.S. Tang ◽  
J.B. Zhang ◽  
W. Shan ◽  
X.M. Huang ◽  
...  
Keyword(s):  
Solar Cells ◽  
Back Surface ◽  
Back Surface Field ◽  
Si Solar Cells ◽  
Surface Field ◽  
Screen Printed

Enhancement of efficiency in graphene/porous silicon solar cells by co-doping graphene with gold nanoparticles and bis(trifluoromethanesulfonyl)-amide

2017 ◽  
Vol 5 (35) ◽  
pp. 9005-9011 ◽  
Author(s):  
Ju Hwan Kim ◽  
Dong Hee Shin ◽  
Ha Seung Lee ◽  
Chan Wook Jang ◽  
Jong Min Kim ◽  
...  
Keyword(s):  
Gold Nanoparticles ◽  
Solar Cells ◽  
Porous Silicon ◽  
Au Nanoparticles ◽  
Silicon Solar Cells ◽  
Porous Si ◽  
Co Doping ◽  
Si Solar Cells ◽  
First Time

The co-doping of graphene with Au nanoparticles and bis(trifluoromethanesulfonyl)-amide is employed for the first time to enhance the performance of graphene/porous Si solar cells.

Sign in / Sign up

Export Citation Format

Share Document