Preparation of waterborne polyurethanes based on the organic solvent-free process

2016 ◽  
Vol 18 (2) ◽  
pp. 412-416 ◽  
Author(s):  
Yao Xiao ◽  
Xiaowei Fu ◽  
Yanyan Zhang ◽  
Zhimeng Liu ◽  
Liang Jiang ◽  
...  
Keyword(s):  
Organic Solvent ◽  
Solvent Free ◽  
Waterborne Polyurethanes ◽  
Free Process

Green WPU was prepared based on the organic solvent-free process, where water was only used to dissolve the solid reactants and reduce the viscosity.

scholarly journals Organic Solvent Free Process to Fabricate High Performance Silicon/Graphite Composite Anode

2021 ◽  
Vol 5 (7) ◽  
pp. 188
Author(s):  
Chen Fang ◽  
Haiqing Xiao ◽  
Tianyue Zheng ◽  
Hua Bai ◽  
Gao Liu
Keyword(s):  
Organic Solvent ◽  
High Performance ◽  
Low Cost ◽  
Solvent Free ◽  
Styrene Butadiene Rubber ◽  
Butadiene Rubber ◽  
Composite Electrodes ◽  
Graphite Composite ◽  
Free Process ◽  
Composite Anodes

Cycling stability is a key challenge for application of silicon (Si)-based composite anodes as the severe volume fluctuation of Si readily leads to fast capacity fading. The binder is a crucial component of the composite electrodes. Although only occupying a small amount of the total composite mass, the binder has major impact on the long-term electrochemical performance of Si-based anodes. In recent years, water-based binders including styrene-butadiene rubber (SBR) and carboxymethyl cellulose (CMC) have attracted wide research interest as eco-friendly and low-cost alternatives for the conventional poly(vinylidene difluoride) (PVDF) binder in Si anodes. In this study, Si-based composite anodes are fabricated by simple solid mixing of the active materials with subsequent addition of SBR and CMC binders. This approach bypasses the use of toxic and expansive organic solvents. The factors of binder, silicon, and graphite materials have been systematically investigated. It is found that the retained capacities of the anodes are more than 440 mAh/g after 400 cycles. These results indicate that organic solvent free process is a facile strategy for producing high performance silicon/graphite composite anodes.

UV grafting: surface modification of cellulose nanofibers without the use of organic solvents

2019 ◽  
Vol 21 (17) ◽  
pp. 4619-4624 ◽  
Author(s):  
Xianpeng Yang ◽  
Ting-Hsuan Ku ◽  
Subir K. Biswas ◽  
Hiroyuki Yano ◽  
Kentaro Abe
Keyword(s):  
Surface Modification ◽  
Organic Solvent ◽  
Organic Solvents ◽  
Uv Irradiation ◽  
Cellulose Nanofibers ◽  
Solvent Free ◽  
Free Process

Polymers were grafted from the surfaces of cellulose nanofibers by UV irradiation with an organic solvent-free process.

scholarly journals Encapsulation of Curcumin-Loaded Liposomes for Colonic Drug Delivery in a pH-Responsive Polymer Cluster Using a pH-Driven and Organic Solvent-Free Process

Molecules ◽  
2018 ◽  
Vol 23 (4) ◽  
pp. 739 ◽  
Author(s):  
Vincenzo De Leo ◽  
Francesco Milano ◽  
Erminia Mancini ◽  
Roberto Comparelli ◽  
Livia Giotta ◽  
...  
Keyword(s):  
Drug Delivery ◽  
Organic Solvent ◽  
Solvent Free ◽  
Ph Responsive ◽  
Colonic Drug Delivery ◽  
Free Process ◽  
Responsive Polymer

scholarly journals Chelating Fabrics Prepared by an Organic Solvent-Free Process for Boron Removal from Water

Polymers ◽  
2021 ◽  
Vol 13 (7) ◽  
pp. 1163
Author(s):  
Hiroyuki Hoshina ◽  
Jinhua Chen ◽  
Haruyo Amada ◽  
Noriaki Seko
Keyword(s):  
Aqueous Solution ◽  
Organic Solvent ◽  
Graft Polymerization ◽  
Gamma Ray ◽  
Acid Catalyst ◽  
Solvent Free ◽  
Boron Removal ◽  
Batch Mode ◽  
Free Process ◽  
High Boron

A chelating fabric was prepared by graft polymerization of glycidyl methacrylate (GMA) onto a nonwoven fabric, followed by attachment reaction of N-methyl-D-glucamine (NMDG) using an organic solvent-free process. The graft polymerization was performed by immersing the gamma-ray pre-irradiated fabric into the GMA emulsion, while the attachment reaction was carried out by immersing the grafted fabric in the NMDG aqueous solution. The chelating capacity of the chelating fabric prepared by reaction in the NMDG aqueous solution without any additives reached 1.74 mmol/g, which further increased to above 2.0 mmol/g when surfactant and acid catalyst were added in the solution. The boron chelation of the chelating fabric was evaluated in a batch mode. Fourier transform infrared spectrophotometer (FTIR) was used to characterize the fabrics. The chelating fabric can quickly chelate boron from water to form a boron ester, and a high boron chelating ability close to 18.3 mg/g was achieved in the concentrated boron solution. The chelated boron can be eluted completely by HCl solution. The regeneration and stability of the chelating fabric were tested by 10 cycles of the chelation-elution operations. Considering the organic solvent-free preparation process and the high boron chelating performance, the chelating fabric is promising for the boron removal from water.

Highly-efficient production of spherical co-agglomerates of drugs via an organic solvent-free process and a mechanism study

2021 ◽  
Author(s):  
Mengmeng Sun ◽  
Yanbo Liu ◽  
Hui Yan ◽  
Mingyang Chen ◽  
Junbo Gong
Keyword(s):  
Organic Solvent ◽  
Solvent Free ◽  
Efficient Technique ◽  
Efficient Production ◽  
Mechanism Study ◽  
Highly Efficient ◽  
Free Process

This work aims at developing a green and highly-efficient technique, which enables co-crystallization and co-agglomeration of drugs, or the crystallization of one drug and simultaneous agglomeration with another drug, in...

An organic solvent free process for the demethylation of 4-(4-methoxyphenyl)butanoic acid

2006 ◽  
Vol 8 (2) ◽  
pp. 181-182 ◽  
Author(s):  
Laurent Delhaye ◽  
Khalid Diker ◽  
Thomas Donck ◽  
Alain Merschaert
Keyword(s):  
Organic Solvent ◽  
Solvent Free ◽  
Butanoic Acid ◽  
Free Process

scholarly journals Development of rapid and selective epoxidation of α-pinene using single-step addition of H2O2 in an organic solvent-free process

RSC Advances ◽  
2021 ◽  
Vol 11 (52) ◽  
pp. 33027-33035
Author(s):  
Mohamad Faiz Mukhtar Gunam Resul ◽  
Abdul Rehman ◽  
Ana María López Fernández ◽  
Valentine C. Eze ◽  
Adam P. Harvey
Keyword(s):  
Hydrogen Peroxide ◽  
Organic Solvent ◽  
Single Step ◽  
Solvent Free ◽  
Campholenic Aldehyde ◽  
Free Process

Products obtained from the oxidation of α-pinene with hydrogen peroxide (H2O2) in the presence of tungsten-based polyoxometalates (α-pinene 1, α-pinene oxide 2, pinanediol 3, campholenic aldehyde 4, sobrerol 5, verbenol 6 and verbenone 7).

Sign in / Sign up

Export Citation Format

Share Document