A BSA coated NOA81 PCR chip for gene amplification

2016 ◽  
Vol 8 (12) ◽  
pp. 2584-2591 ◽  
Author(s):  
Kuiwei Qin ◽  
Xuefei Lv ◽  
Qiaorui Xing ◽  
Rui Li ◽  
Yulin Deng
Keyword(s):  
Gene Amplification ◽  
Pcr Efficiency ◽  
Coating Method

We fabricated a NOA81 PCR chip (NP-chip) and first proposed a simple BSA coating method to successfully overcome the low PCR efficiency induced by the inhibition of the NP-chip which seriously impacted its application in the area of gene amplification.

Reevaluation of gene amplification in medulloblastomas

2004 ◽  
Vol 216 (03) ◽  
Author(s):  
T Lenschen ◽  
J Mühlisch ◽  
H Jürgens ◽  
C Plass ◽  
D Smiraglia ◽  
...  
Keyword(s):  
Gene Amplification

HER-2 gene amplification in pancreatic cancer

2004 ◽  
Vol 42 (05) ◽  
Author(s):  
K Borka ◽  
A Kiss ◽  
A Tőkés ◽  
P Kaliszky ◽  
P Kupcsulik ◽  
...  
Keyword(s):  
Pancreatic Cancer ◽  
Gene Amplification ◽  
Her 2

Effect of coating method on release of Glimepiride from porosity osmotic pump tablets (POPTs)

2020 ◽  
pp. 37-45
Keyword(s):  
In Vitro Release ◽  
Osmotic Pump ◽  
Release Time ◽  
Once Daily ◽  
Coating Solution ◽  
Continuous Release ◽  
Red Color ◽  
Coating Method ◽  
Osmotic Agent

In this study, once-daily porosity osmotic pump tablets (POPTs) of Glimepiride were prepared using HPMC K100M (61%), osmotic agent (30% NaCl) coated using two different coating techniques spraying and dipping methods. The coating solution composed of ethyl cellulose (7.5%) w\w in ethanol (90%), castor oil (2%) as water-insoluble plasticizer and Gingo red color (0.5% w\w). In both techniques, the coating level was adjusted to give a 10% increase in the weight of the tablets. The effect of the coating by dipping technique with an increase in the weight of tablet (10 %, 20% & 50%) was also investigated to see the effect coating level on the percentage of drug release from POPTs. The results of the in vitro release of Glimepiride from tablets coated by the spraying method showed longer release time (24 hrs) than those coated with dipping method. On the other hand, increasing the coating level by dipping method retarded the release of the drug from tablets. However, the same retardation effect on release as shown with the spraying technique was only obtained by increasing the coating level with a 50% increase in the weight of the tablet. Thus, coating by spraying is more efficient to prepare POPTs to give a continuous release of Glimepiride from once daily table with the lowest increase in the total weight of the tablet.

Development of High Accuracy Spray Coating Method using Multi-layer Coat

2013 ◽  
Vol 133 (5) ◽  
pp. 170-176 ◽  
Author(s):  
Mikio Akamatsu ◽  
Kyohei Terao ◽  
Hidekuni Takao ◽  
Fusao Simokawa ◽  
Fumikazu Oohira ◽  
...  
Keyword(s):  
Spray Coating ◽  
High Accuracy ◽  
Coating Method

Porous Gel Coatings Obtained by Phase Separation in ORMOSIL System

2000 ◽  
Vol 628 ◽  
Author(s):  
Kazuki Nakanishi ◽  
Souichi Kumon ◽  
Kazuyuki Hirao ◽  
Hiroshi Jinnai
Keyword(s):  
Phase Separation ◽  
Reaction Time ◽  
Volume Fraction ◽  
Sol Gel ◽  
Reaction Times ◽  
Dip Coating ◽  
Coating Solution ◽  
Coating Method ◽  
Gel Phase ◽  
Dip Coating Method

ABSTRACTMacroporous silicate thick films were prepared by a sol-gel dip-coating method accompanied by the phase separation using methyl-trimethoxysilane (MTMS), nitric acid and dimethylformamide (DMF) as starting components. The morphology of the film varied to a large extent depending on the time elapsed after the hydrolysis until the dipping of the coating solution. On a glass substrate, the films prepared by early dipping had inhomogeneous submicrometer-sized pores on the surface of the film. At increased reaction times, relatively narrow sized isolated macropores were observed and their size gradually decreased with the increase of reaction time. On a polyester substrate, in contrast, micrometer-sized isolated spherical gel domains were homogeneously deposited by earlier dippings. With an increase of reaction time, the volume fraction of the gel phase increased, then the morphology of the coating transformed into co-continuous gel domains and macropores, and finally inverted into the continuous gel domains with isolated macropores. The overall morphological variation with the reaction time was explained in terms of the phase separation and the structure freezing by the forced gelation, both of which were induced by the evaporation of methanol during the dipping operation.

Development of Molybdenum trioxide (MoO3) by spin coating method for photovoltaic application

2012 ◽  
pp. 1805-1808 ◽  
Author(s):  
L. Chibane ◽  
M.S. Belkaid ◽  
M. Pasquinelli ◽  
H. Derbal-Habak ◽  
J.J. Simon ◽  
...  
Keyword(s):  
Spin Coating ◽  
Molybdenum Trioxide ◽  
Spin Coating Method ◽  
Photovoltaic Application ◽  
Coating Method

PREPARATION AND CHARACTERIZATION OF POLYVINYL ALCOHOL THIN FILMS FOR ORGANIC THIN FILM TRANSISTORS AND BIOMEDICAL APPLICATIONS

2018 ◽  
Vol 5 (2) ◽  
pp. 16-18
Author(s):  
Chandar Shekar B ◽  
Ranjit Kumar R ◽  
Dinesh K.P.B ◽  
Sulana Sundar C ◽  
Sunnitha S ◽  
...  
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Thin Film Transistors ◽  
Gravimetric Method ◽  
Dip Coating ◽  
Organic Thin Film Transistors ◽  
Poly Vinyl Alcohol ◽  
Organic Thin Film ◽  
Glass Substrates ◽  
Coating Method

Thin films of poly vinyl alcohol (PVA) were prepared on pre-cleaned glass substrates by Dip Coating Method. FTIR spectrum was used to identify the functional groups present in the prepared films. The vibrational peaks observed at 1260 cm-1 and 851 cm-1 are assigned to C–C stretching and CH rocking of PVA.The characteristic band appearing at 1432 cm-1 is assigned to C–H bend of CH2 of PVA. The thickness of the prepared thin films were measured by using an electronic thickness measuring instrument (Tesatronic-TTD20) and cross checked by gravimetric method. XRD spectra indicated the amorphous nature of the films.Surface morphology of the coated films was studied by scanning electron microscope (SEM). The surface revealed no pits and pin holes on the surface. The observed surface morphology indicated that these films could be used as dielectric layer in organic thin film transistors and as drug delivery system for wound healing.

A PILOT STUDY OF HER-2/NEU GENE AMPLIFICATION ASSESSED BY FLUORESCENCE IN SITU HYBRIDIZATION (FISH) IN GASTRIC CANCER

2014 ◽  
pp. 15-20
Author(s):  
Van Huy Tran ◽  
Thi Minh Thi Ha ◽  
Trung Nghia Van ◽  
Viet Nhan Nguyen ◽  
Phan Tuong Quynh Le ◽  
...  
Keyword(s):  
Gastric Cancer ◽  
In Situ Hybridization ◽  
Fluorescence In Situ Hybridization ◽  
Cancer Patients ◽  
Gene Amplification ◽  
Cancer Tissue ◽  
Tissue Samples ◽  
Her 2 ◽  
Gastric Cancer Patients

Background: HER-2/neu is a predictive biomarker for treatment of gastric cancer using trastuzumab in combination with chemotherapy. This study aimed to evaluate the status of HER-2/neu gene amplification using fluorescence in situ hybridization (FISH) in gastric cancer. Patients and methods: thirty six gastric cancer patients were assessed HER-2/neu gene amplification by FISH using PathVysionTM HER-2 DNA Probe kit (including HER-2/neu probe and CEP-17 probe) with biopsy and surgical specimens. Results: The HER-2/neu gene amplification was observed in three cases (8.3%), the HER-2/neu gene amplification rate in Lauren’s intestinal-type and diffuse-type were 11.8% and 5.2%, respectively. Conclusion: We applied successfully FISH technique with gastric cancer tissue samples. This technique could be performed as routine test in gastric cancer in order to select patients that benefit from trastuzumab in combination with chemotherapy.

Sign in / Sign up

Export Citation Format

Share Document