Fabrication of conducting polymer/noble metal composite nanorings and their enhanced catalytic properties

2015 ◽  
Vol 3 (1) ◽  
pp. 83-86 ◽  
Author(s):  
Liu Yang ◽  
Zhen Zhang ◽  
Guangdi Nie ◽  
Ce Wang ◽  
Xiaofeng Lu
Keyword(s):  
Conducting Polymer ◽  
Noble Metal ◽  
Catalytic Properties ◽  
Soft Template ◽  
Template Method ◽  
Metal Composite ◽  
One Pot ◽  
The One ◽  
Metal Nanocomposites

We have described a soft-template method that allows the one-pot fabrication of ring-like conducting polymer/noble metal nanocomposites.

scholarly journals Structural, Textural, and Catalytic Properties of Ni-CexZr1−xO2 Catalysts for Methane Dry Reforming Prepared by Continuous Synthesis in Supercritical Isopropanol

Energies ◽  
2020 ◽  
Vol 13 (14) ◽  
pp. 3728
Author(s):  
Svetlana Pavlova ◽  
Marina Smirnova ◽  
Aleksei Bobin ◽  
Svetlana Cherepanova ◽  
Vasily Kaichev ◽  
...  
Keyword(s):  
Nickel Nanoparticles ◽  
Catalytic Properties ◽  
Dry Reforming ◽  
High Dispersion ◽  
Incipient Wetness Impregnation ◽  
One Pot ◽  
Methane Dry Reforming ◽  
Continuous Synthesis ◽  
The One ◽  
Supercritical Isopropanol

A series of 5%Ni-CexZr1−xO2 (x = 0.3, 0.5, 0.7) catalysts has been prepared via one-pot solvothermal continuous synthesis in supercritical isopropanol and incipient wetness impregnation of CexZr1−xO2 obtained by the same route. The textural, structural, red-ox, and catalytic properties in methane dry reforming (MDR) of Ni-modified Ce-Zr oxides synthesized by two routes have been compared. It was shown by XRD, TEM, and Raman spectroscopy that the method of Ni introduction does not affect the phase composition of the catalysts, but determines the dispersion of NiO. Despite a high dispersion of NiO and near-uniform distribution of Ni within Ce-Zr particles observed for the one-pot catalysts, they have shown a lower activity and stability in MDR as compared with impregnated ones. This is a result of a low Ni concentration in the surface layer due to segregation of Ce and decoration of nickel nanoparticles with support species.

scholarly journals Solid Acid Catalysts Based on Niobium and Zirconium Oxides for Hydrolysis-Dehydration of Cellulose Into Glucose and 5-Hydroxymethylfurfural. Impact of Preparation Technique on Catalytic Properties

2020 ◽  
pp. 283-296
Author(s):  
Nikolay V. Gromov ◽  
Irina S. Yakovleva ◽  
Lubov A. Isupova ◽  
Valentin N. Parmon ◽  
Oxana P. Taran
Keyword(s):  
Catalytic Properties ◽  
Total Yield ◽  
Preparation Technique ◽  
One Pot ◽  
Solid Catalysts ◽  
Zirconium Oxides ◽  
Component Systems ◽  
Two Component Systems ◽  
The One ◽  
The Impact

The impact of the preparation techniques of niobium oxide and two-component systems based on niobium and zirconium oxides on the catalytic properties was studied in the one-pot hydrolysisdehydration of cellulose into glucose and 5-hydroxymethylfurfural. Cellulose transformation was performed in an autoclave at 180 °С under argon atmosphere. The most promising methods for the preparation of solid catalysts were found to be microwave heating and mechanical activation. Glucose and 5-hydroxymethylfurfural can be produced with total yield equal to 20-21 % in the presence of catalysts prepared using these techniques

Insights on the One‐Pot Formation of 1,5‐Pentanediol from Furfural with Co−Al Spinel‐based Nanoparticles as an Alternative to Noble Metal Catalysts

ChemCatChem ◽  
2019 ◽  
Vol 11 (19) ◽  
pp. 4944-4953 ◽  
Author(s):  
L. Gavilà ◽  
A. Lähde ◽  
J. Jokiniemi ◽  
M. Constanti ◽  
F. Medina ◽  
...  
Keyword(s):  
Noble Metal ◽  
Metal Catalysts ◽  
One Pot ◽  
Noble Metal Catalysts ◽  
The One

Self-assembly directed synthesis of Au nanorices induced by polyaniline and their enhanced peroxidase-like catalytic properties

2017 ◽  
Vol 5 (30) ◽  
pp. 7465-7471 ◽  
Author(s):  
Wei Song ◽  
Maoqiang Chi ◽  
Mu Gao ◽  
Bing Zhao ◽  
Ce Wang ◽  
...  
Keyword(s):  
Self Assembly ◽  
Catalytic Properties ◽  
One Pot ◽  
One Pot Synthesis ◽  
Directed Synthesis ◽  
The One

We describe a self-assembly directed method that allows the one-pot synthesis of Au/polyaniline nanorices with enhanced peroxidase-like activity.

A Series of Metal-Organic Frameworks for Selective CO2 Capture and Catalytic Oxidative Carboxylation of Olefins

2018 ◽  
Author(s):  
Huong T. D. Nguyen ◽  
Y B. N. Tran ◽  
Hung N. Nguyen ◽  
Tranh C. Nguyen ◽  
Felipe Gándara ◽  
...  
Keyword(s):  
Room Temperature ◽  
Gas Adsorption ◽  
New Materials ◽  
One Pot ◽  
Acid Gas ◽  
Naphthalene Diimide ◽  
Styrene Carbonate ◽  
Metal Organic ◽  
Adsorption Of Co ◽  
The One

<p>Three novel lanthanide metal˗organic frameworks (Ln-MOFs), namely MOF-590, -591, and -592 were constructed from a naphthalene diimide tetracarboxylic acid. Gas adsorption measurements of MOF-591 and -592 revealed good adsorption of CO<sub>2</sub> (low pressure, at room temperature) and moderate CO<sub>2</sub> selectivity over N<sub>2</sub> and CH<sub>4</sub>. Accordingly, breakthrough measurements were performed on a representative MOF-592, in which the separation of CO<sub>2</sub> from binary mixture containing N<sub>2</sub> and CO<sub>2</sub> was demonstrated without any loss in performance over three consecutive cycles. Moreover, MOF-590, MOF-591, and MOF-592 exhibited catalytic activity in the one-pot synthesis of styrene carbonate from styrene and CO<sub>2</sub> under mild conditions (1 atm CO<sub>2</sub>, 80 °C, and solvent-free). Among the new materials, MOF-590 revealed a remarkable efficiency with exceptional conversion (96%), selectivity (95%), and yield (91%). </p><br>

A Study on the Rearrangement of Dialkyl 1-Aryl-1-hydroxymethylphosphonates to Benzyl Phosphates

2020 ◽  
Vol 24 (4) ◽  
pp. 465-471 ◽  
Author(s):  
Zita Rádai ◽  
Réka Szabó ◽  
Áron Szigetvári ◽  
Nóra Zsuzsa Kiss ◽  
Zoltán Mucsi ◽  
...  
Keyword(s):  
Quantum Chemical ◽  
Room Temperature ◽  
Phase Transfer ◽  
One Pot ◽  
Substrate Dependence ◽  
Triethylbenzylammonium Chloride ◽  
One Step ◽  
The Pudovik Reaction ◽  
The One ◽  
Solid Liquid

The phospha-Brook rearrangement of dialkyl 1-aryl-1-hydroxymethylphosphonates (HPs) to the corresponding benzyl phosphates (BPs) has been elaborated under solid-liquid phase transfer catalytic conditions. The best procedure involved the use of triethylbenzylammonium chloride as the catalyst and Cs2CO3 as the base in acetonitrile as the solvent at room temperature. The substrate dependence of the rearrangement has been studied, and the mechanism of the transformation under discussion was explored by quantum chemical calculations. The key intermediate is an oxaphosphirane. The one-pot version starting with the Pudovik reaction has also been developed. The conditions of this tandem transformation were the same, as those for the one-step HP→BP conversion.

An Overview of the One-pot Synthesis of Imidazolines

2020 ◽  
Vol 24 (20) ◽  
pp. 2341-2355
Author(s):  
Thaipparambil Aneeja ◽  
Sankaran Radhika ◽  
Mohan Neetha ◽  
Gopinathan Anilkumar
Keyword(s):  
Asymmetric Catalysis ◽  
Organic Compounds ◽  
Ring Opening ◽  
Ecological Impact ◽  
Chiral Auxiliary ◽  
One Pot ◽  
One Pot Synthesis ◽  
The One ◽  
Synthetic Intermediate ◽  
Heterocyclic Moiety

One-pot syntheses are a simple, efficient and easy methodology, which are widely used for the synthesis of organic compounds. Imidazoline is a valuable heterocyclic moiety used as a synthetic intermediate, chiral auxiliary, chiral catalyst and a ligand for asymmetric catalysis. Imidazole is a fundamental unit of biomolecules that can be easily prepared from imidazolines. The one-pot method is an impressive approach to synthesize organic compounds as it minimizes the reaction time, separation procedures, and ecological impact. Many significant one-pot methods such as N-bromosuccinimide mediated reaction, ring-opening of tetrahydrofuran, triflic anhydrate mediated reaction, etc. were reported for imidazoline synthesis. This review describes an overview of the one-pot synthesis of imidazolines and covers literature up to 2020.

Synthesis and Kinetics of Highly Substituted Piperidines in the Presence of Tartaric Acid as a Catalyst

2018 ◽  
Vol 21 (4) ◽  
pp. 302-311
Author(s):  
Younes Ghalandarzehi ◽  
Mehdi Shahraki ◽  
Sayyed M. Habibi-Khorassani
Keyword(s):  
Ambient Temperature ◽  
Tartaric Acid ◽  
Aromatic Aldehydes ◽  
One Pot ◽  
Rate Determining Step ◽  
State Approximation ◽  
Solvent Free Conditions ◽  
Steady State Approximation ◽  
Absorbance Changes ◽  
The One

Aim & Scope: The synthesis of highly substituted piperidine from the one-pot reaction between aromatic aldehydes, anilines and β-ketoesters in the presence of tartaric acid as a catalyst has been investigated in both methanol and ethanol media at ambient temperature. Different conditions of temperature and solvent were employed for calculating the thermodynamic parameters and obtaining an experimental approach to the kinetics and mechanism. Experiments were carried out under different temperature and solvent conditions. Material and Methods: Products were characterized by comparison of physical data with authentic samples and spectroscopic data (IR and NMR). Rate constants are presented as an average of several kinetic runs (at least 6-10) and are reproducible within ± 3%. The overall rate of reaction is followed by monitoring the absorbance changes of the products versus time on a Varian (Model Cary Bio- 300) UV-vis spectrophotometer with a 10 mm light-path cell. Results: The best result was achieved in the presence of 0.075 g (0.1 M) of catalyst and 5 mL methanol at ambient temperature. When the reaction was carried out under solvent-free conditions, the product was obtained in a moderate yield (25%). Methanol was optimized as a desirable solvent in the synthesis of piperidine, nevertheless, ethanol in a kinetic investigation had none effect on the enhancement of the reaction rate than methanol. Based on the spectral data, the overall order of the reaction followed the second order kinetics. The results showed that the first step of the reaction mechanism is a rate determining step. Conclusion: The use of tartaric acid has many advantages such as mild reaction conditions, simple and readily available precursors and inexpensive catalyst. The proposed mechanism was confirmed by experimental results and a steady state approximation.

A Simple Approach to the One-Pot Three Component Synthesis of 4Hpyrimido [2,1-b] benzothiazole Derivatives Using Polyethylene Glycol (PEG-400)

2015 ◽  
Vol 12 (3) ◽  
pp. 197-204 ◽  
Author(s):  
Prabhakar Rairala ◽  
Bandi Yadagiri ◽  
Rajashaker Bantu ◽  
Vijayacharan Guguloth ◽  
Lingaiah Nagarapu
Keyword(s):  
Polyethylene Glycol ◽  
Simple Approach ◽  
One Pot ◽  
Benzothiazole Derivatives ◽  
Peg 400 ◽  
The One
Sign in / Sign up

Export Citation Format

Share Document