A facile synthesis of flower-shaped TiO2/Ag microspheres and their application in photocatalysts

RSC Advances ◽  
2014 ◽  
Vol 4 (97) ◽  
pp. 54463-54468 ◽  
Author(s):  
Li Zhang ◽  
Lei Chen ◽  
Liangwei Chen ◽  
Guang Zhu
Keyword(s):  
Photocatalytic Activity ◽  
Surface Area ◽  
Light Absorption ◽  
Ag Nanoparticles ◽  
Light Irradiation ◽  
Facile Synthesis ◽  
Electron Hole ◽  
Composite Microspheres ◽  
Electron Hole Pair ◽  
Prepared Composite

Novel flower-shaped microspheres (FSMP) TiO2/Ag nanoparticles composites were fabricated by the facile tyrosine-reduced method and used as a photocatalyst for the degradation of MB under light irradiation. The results indicate that as-prepared composite microspheres have a superior photocatalytic activity attributed to higher surface area, increased light absorption capability, the reduction of electron–hole pair recombination.

A simple method to synthesise Ag-doped TiO2 photocatalysts with different Ag0:Ag2O atomic ratios for enhancing visible-light photocatalytic activity

2017 ◽  
Vol 41 (8) ◽  
pp. 475-483 ◽  
Author(s):  
C. Chen ◽  
X. F. Lei ◽  
M. Z. Xue
Keyword(s):  
Electron Microscopy ◽  
Photocatalytic Activity ◽  
Visible Light ◽  
Visible Light Irradiation ◽  
Light Absorption ◽  
Separation Efficiency ◽  
Visible Region ◽  
Light Irradiation ◽  
Electron Hole ◽  
X Ray

Pure anatase TiO2 photocatalysts with different Ag contents were prepared via a simple sol-gel method. The as-prepared anatase Ag-doped TiO2 photocatalysts were characterised by X-ray diffraction, transmission electron microscopy, UV-Vis diffuse reflectance spectra, photoluminescence spectroscopy, X-ray photoelectron spectroscopy, thermal gravity and differential thermal analysis, scanning electron microscopy and N2 adsorption–desorption measurements (BET). Compared with pure TiO2, Ag-doped anatase TiO2 photocatalysts exhibited not only increases in light absorption in the visible region, the separation efficiency of electron–hole pairs and surface area, but also inhibition of the titania phase transition from anatase to rutile. Photoreduction results showed that Ag-doped anatase TiO2 photocatalysts have greatly improved photocatalytic activity, compared with pure TiO2, and the reduction of Cr(VI) under visible light irradiation was much higher than that of pure TiO2. The optimum Ag content was 1.0 mol%, which led to the complete reduction of Cr(VI) under visible light irradiation (λ > 420 nm) for 4 h. The enhanced photocatalytic activity was attributed to the synergic effect of the pure anatase structure, and the increased light absorption in the visible region, separation efficiency of electron–hole pairs and atomic ratio of Ag0:Ag2O.

Facile synthesis of meso-porous ZnO nano-triangular prisms with enhanced photocatalytic activity

RSC Advances ◽  
2015 ◽  
Vol 5 (38) ◽  
pp. 30120-30124 ◽  
Author(s):  
K. Vignesh ◽  
Sora Kang ◽  
Byeong Sub Kwak ◽  
Misook Kang
Keyword(s):  
Photocatalytic Activity ◽  
Transfer Process ◽  
Light Irradiation ◽  
Solar Light ◽  
Schematic Diagram ◽  
Facile Synthesis ◽  
Electron Hole ◽  
Hole Transfer ◽  
Simulated Solar Light ◽  
Solar Light Irradiation

A schematic diagram of the electron–hole transfer process in ZnO-nt under simulated solar light irradiation.

Ti3C2-MXene/Bismuth Ferrite Nanohybrids for Efficient Degradation of Organic Dye and Colorless Pollutant

2019 ◽  
Author(s):  
Ayesha Tariq ◽  
M. Abdullah Iqbal ◽  
S. Irfan Ali ◽  
Muhammad Z. Iqbal ◽  
Deji Akinwande ◽  
...  
Keyword(s):  
Surface Area ◽  
Low Cost ◽  
Bismuth Ferrite ◽  
Organic Dye ◽  
Two Dimensional ◽  
Electron Hole ◽  
Photocatalytic Application ◽  
Electron Hole Pair ◽  
Pair Generation ◽  
Photocatalytic Applications

<p>Nanohybrids, made up of Bismuth ferrites/Carbon allotropes, are extensively used in photocatalytic applications nowadays. Our work proposes a nanohybrid system composed of Bismuth ferrite nanoparticles with two-dimensional (2D) MXene sheets namely, the BiFeO<sub>3</sub> (BFO)/Ti<sub>3</sub>C<sub>2</sub> (MXene) nanohybrid for enhanced photocatalytic activity. We have fabricated the BFO/MXene nanohybrid using simple and low cost double solvent solvothermal method. The SEM and TEM images show that the BFO nanoparticles were attached onto the MXene surface and in the inter-layers of two-dimensional (2D) MXene sheets. The photocatalytic application is tested for the visible light irradiation which showed the highest efficiency among all pure-BFO based photocatalysts, i.e. 100% degradation in 42 min for organic dye (Congo Red) and colorless aqueous pollutant (acetophenone) in 150 min, respectively. The present BFO-based hybrid system exhibited the large surface area of 147 m<sup>2</sup>g<sup>-1</sup>measured via Brunauer-Emmett-Teller (BET) sorption-desorption technique, and is found to be largest among BFO and its derivatives. Also, the photoluminescence (PL) spectra indicate large electron-hole pair generation. Fast and efficient degradation of organic molecules is supported by both factors; larger surface area and lower electron-hole recombination rate. The BFO/MXene nanohybrid presented here is a highly efficient photocatalyst compared to other nanostructures based on pure BiFeO<sub>3</sub> which makes it a promising candidate for many future applications.</p>

Few-Layered MoS2 Nanostructures for Highly Efficient Visible Light Photocatalysis

NANO ◽  
2016 ◽  
Vol 11 (10) ◽  
pp. 1650114 ◽  
Author(s):  
Dan Li ◽  
Jianwei Li ◽  
Caiqin Han ◽  
Xinsheng Zhao ◽  
Haipeng Chu ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Photocatalytic Activity ◽  
Visible Light ◽  
Electrochemical Impedance ◽  
X Ray Diffraction ◽  
Electron Hole ◽  
Electrochemical Impedance Spectra ◽  
X Ray ◽  
Transmission Electron ◽  
Electron Hole Pair

Few-layered MoS2 nanostructures were successfully synthesized by a simple hydrothermal method without the addition of any catalysts or surfactants. Their morphology, structure and photocatalytic activity were characterized by X-ray diffraction, scanning electron microscopy, energy dispersive X-ray spectroscopy, transmission electron microscopy, electrochemical impedance spectra and UV-Vis absorption spectroscopy, respectively. These results show that the MoS2 nanostructures synthesized at 180[Formula: see text]C exhibit an optimal visible light photocatalytic activity (99%) in the degradation of Rhodamine B owing to the relatively easier adsorption of pollutants, higher visible light absorption and lower electron–hole pair recombination.

Facile synthesis of novel Roe-like TiO2 hollow nanospheres with mesoporous cavity for improved photocatalytic activity

2017 ◽  
Vol 10 (03) ◽  
pp. 1750028 ◽  
Author(s):  
Yan Zhu ◽  
Xiaoxia Yan ◽  
Yuanxin Ge ◽  
Shumin Wang ◽  
Dongmei Deng ◽  
...  
Keyword(s):  
Photocatalytic Activity ◽  
Specific Surface ◽  
Surface Area ◽  
Specific Surface Area ◽  
Self Assembly ◽  
Charge Separation ◽  
Synergistic Effects ◽  
Assembly Process ◽  
Hollow Nanospheres ◽  
Facile Synthesis

A facile approach was developed to synthesize novel Roe-like TiO2 hollow nanospheres via a template-assisted self-assembly process. These TiO2 nanospheres possessing mesoporous cavity manifest significantly improved photocatalytic activity owing to the synergistic effects of increased charge separation, more efficient use of the light and specific surface area.

Sign in / Sign up

Export Citation Format

Share Document