Abstract
Serious environmental deterioration caused by synthetic waste plastics, and the pollution of freshwater resources are the most alarming and remarkable challenges of the 21st century. Therefore, immense scientific efforts are being paid towards the management of waste plastics and treatment of polluted water. The current study is report the utilization of waste polyethylene terephthalate (wPET) and waste polystyrene (wPS) for fabrication of activated carbon (AC) and its application for the removal of hazardous polycyclic aromatic hydrocarbons (PAHs) pollutants from water. AC was prepared from wPET and wPS by carbonization under N2 atmosphere followed by chemical activation with 1M KOH and 1M HCl. The AC was characterized by SEM, surface area analysis (SAA), and FT-IR spectroscopy. Adsorption of PAHs from aqueous solutions through AC was examined by batch adsorption tests. The optimum parameters for maximum adsorption of PAHs were found to be; initial PAHs concentration 40 ppm, 2 h contact time, pH 3, 5, and 7, 50 °C temperature and adsorbent dose of 0.8 g. Kinetic and isotherm models were applied to evaluate the adsorbent capacity for PAHs adsorption. The kinetic study shows that the adsorption of these PAHs onto AC follows the pseudo-second-order kinetics. The experimental results demonstrated that Langmuir isotherm model best fitted the data. The thermodynamic factors calculated such as entropy change (ΔS°), enthalpy change (ΔS°) and free energy change (ΔG°) show that the adsorption process is non-spontaneous and endothermic in nature. Results were also compared with the efficiencies of some commercial adsorbents used in practice. This examination revealed that the novel plastic derived AC possesses a large potential for elimination and recovery of PAHs elimination from industrial wastewater.
Nanosized Iron Oxide Uniformly Distributed on 3D Carbon Nanosheets: Efficient Adsorbent for Methylene Blue