Graphene supported α-MnO2 nanotubes as a cathode catalyst for improved power generation and wastewater treatment in single-chambered microbial fuel cells

RSC Advances ◽  
2013 ◽  
Vol 3 (21) ◽  
pp. 7902 ◽  
Author(s):  
Santimoy Khilari ◽  
Soumya Pandit ◽  
M. M. Ghangrekar ◽  
Debabrata Das ◽  
Debabrata Pradhan
Keyword(s):  
Power Generation ◽  
Wastewater Treatment ◽  
Fuel Cells ◽  
Microbial Fuel Cells ◽  
Cathode Catalyst

scholarly journals Carbon Nanotube/Pt Cathode Nanocomposite Electrode in Microbial Fuel Cells for Wastewater Treatment and Bioenergy Production

2021 ◽  
Vol 13 (14) ◽  
pp. 8057
Author(s):  
Mostafa Ghasemi ◽  
Mehdi Sedighi ◽  
Yie Hua Tan
Keyword(s):  
Electron Microscopy ◽  
Power Generation ◽  
Wastewater Treatment ◽  
Carbon Nanotube ◽  
Microbial Fuel Cells ◽  
Energy Production ◽  
Catalytic Properties ◽  
Internal Resistance ◽  
Cod Removal ◽  
Cathode Catalyst

In this paper, we reported the fabrication, characterization, and application of carbon nanotube (CNT)-platinum nanocomposite as a novel generation of cathode catalyst in microbial fuel cells (MFCs) for sustainable energy production and wastewater treatment. The efficiency of the carbon nanocomposites was compared by platinum (Pt), which is the most effective and common cathode catalyst. This nanocomposite is utilized to benefit from the catalytic properties of CNTs and reduce the amount of required Pt, as it is an expensive catalyst. The CNT/Pt nanocomposites were synthesized via a chemical reduction technique and the electrodes were characterized by field emission scanning electron microscopy, electronic dispersive X-Ray analysis, and transmission electron microscopy. The nanocomposites were applied as cathode catalysts in the MFC to obtain polarization curve and coulombic efficiency (CE) results. The catalytic properties of electrodes were tested by linear sweep voltammetry. The CNT/Pt at the concentration of 0.3 mg/cm2 had the highest performance in terms of CE (47.16%), internal resistance (551 Ω), COD removal (88.9%), and power generation (143 mW/m2). In contrast, for the electrode with 0.5 mg/L of Pt catalyst, CE, internal resistance, COD removal, and power generation were 19%, 810 Ω, 96%, and 84.1 mW/m2, respectively. So, it has been found that carbon nanocomposite cathode electrodes had better performance for sustainable clean energy production and COD removal by MFC.

scholarly journals Enhanced and Effective Degradation of Waste Water Treatment for Hydrogen and Bioelectricity Production

2020 ◽  
Vol 2 (1) ◽  
pp. 85
Keyword(s):  
Waste Water ◽  
Power Generation ◽  
Wastewater Treatment ◽  
Fuel Cells ◽  
Microbial Fuel Cells ◽  
Electricity Generation ◽  
Waste Water Treatment ◽  
Electrical Power ◽  
Microbial Environment ◽  
Free Environment

This paper summarises different methods used for the Electrical power generation using microorganisms in Microbial Fuel Cell (MFC), where power generation is done in a microbial environment. Microorganisms are used as catalysts to degrade the supplied source effectively. This bioelectricity production is carried out in an enhanced way in a pollution-free environment. This paper addresses different aspects of electricity generation with the help of microorganisms. Various types of Microbial fuel cells have been described based on their constructional details. One of the different power generation methods is wastewater treatment. Also, hydrogen is generated in this environment, which can be used in fuel cells. Different factors and catalysts used to produce bioelectricity are identified and analyzed. Finally, the power produced in those methods had been compared, and the best method is cited.

COD Removal and Electricity Generation From Domestic Wastewater Using Different Anode Materials in Microbial Fuel Cells

2019 ◽  
Vol 8 (1) ◽  
pp. 1-12
Author(s):  
G. Shyamala ◽  
N. Saravanakumar ◽  
E. Vamsi Krishna
Keyword(s):  
Power Generation ◽  
Wastewater Treatment ◽  
Fuel Cells ◽  
Microbial Fuel Cells ◽  
Treatment Plant ◽  
Oxygen Demand ◽  
Domestic Wastewater ◽  
Salt Bridge ◽  
Anode Chamber ◽  
Cathode Chamber

Microbial fuel cells (MFCs) set a new trend of converting chemical energy or bio energy to electricity from wastewater (domestic and industries) at the same time removal of chemical oxygen demand (COD) from the wastewater. Electrical energy generated from microbial fuel cell could be used for small electrical device example biosensors. The main components of MFCs are the anode, and the cathode salt bridge. It contains an anode chamber and a cathode chamber which separate electrodes for the production of electricity, using wastewater in an anaerobic chamber helps grow native microorganisms. Adding substrates increases productivity of the electrons that are moving from the anode chamber to the cathode chamber by help of the salt bridge. Bioreactors based on power generation in MFCs are a new approach to wastewater treatment. Power generation and current is modulated in this system. If it is optimised, MFCs would prove to be new method to offset wastewater treatment plant operating costs.

New insights in light-assisted microbial fuel cells for wastewater treatment and power generation: A win-win cooperation

2021 ◽  
Vol 501 ◽  
pp. 230000
Author(s):  
Zhicheng Xu ◽  
Shiyu Chen ◽  
Siyuan Guo ◽  
Dan Wan ◽  
Hao Xu ◽  
...  
Keyword(s):  
Power Generation ◽  
Wastewater Treatment ◽  
Fuel Cells ◽  
Microbial Fuel Cells
Sign in / Sign up

Export Citation Format

Share Document