Characterization of the telomerization reaction path for vinylidene fluoride with ĊCl3radicals

2012 ◽  
Vol 3 (3) ◽  
pp. 652-657 ◽  
Author(s):  
Patrick Laflamme ◽  
François Porzio ◽  
Bruno Ameduri ◽  
Armand Soldera
Keyword(s):  
Vinylidene Fluoride ◽  
Reaction Path ◽  
Telomerization Reaction

Preparation and Characterization of Modified PVDF-g-PSSA Membrane

2010 ◽  
Vol 152-153 ◽  
pp. 44-50 ◽  
Author(s):  
Gui Bao Guo ◽  
Er Ding Han ◽  
Sheng Li An
Keyword(s):  
Relative Humidity ◽  
Sodium Silicate ◽  
Room Temperature ◽  
Proton Exchange Membrane ◽  
Vinylidene Fluoride ◽  
Proton Exchange ◽  
Poly Vinylidene Fluoride ◽  
Relative Humidity Range ◽  
Exchange Membrane

A new method based on a solution graft technique was used to prepare poly (vinylidene fluoride) grafted polystyrene sulfonated acid (PVDF-g-PSSA) proton exchange membrane. Polystyrene is grafted into PVDF modified by plain sodium silicate (Na4SiO4). There is a linear relationship between the degree of grafting and the content of Na4SiO4. Fourier transform infrared spectroscopy is used to characterize changes of the membrane's microstructures after grafting and sulfonation. The morphology of the membrane's microstructures after grafting and sulfonation is studied by scanning electrolytic microscope (SEM). The effect of plain sodium silicate (Na4SiO4) concentration and relative humidity on the conductivity of the electrolyte was investigated by the impedance at room temperature. The results show that the styrene has been grafted into PVDF. The conductivity of PVDF-g-PSSA electrolyte doped 10% plain sodium silicate (Na4SiO4) is 0.016 S/cm at room temperature. The conductivity of the electrolyte changes slightly at a relative humidity range of 20%-70%. The weightlessness of PVDF-g-PSSA electrolyte heated to 40°C was less than 2%, which indicated that water capacity was good.

Fabrication and Characterization of Ferroelectric Polymer/TiO2/Al-doped ZnO Structures

2008 ◽  
Vol 1071 ◽  
Author(s):  
Koji Aizawa
Keyword(s):  
Leakage Current ◽  
Vinylidene Fluoride ◽  
Ferroelectric Properties ◽  
Hysteresis Loops ◽  
Tio2 Films ◽  
Gate Leakage Current ◽  
Poly Vinylidene Fluoride ◽  
Doped Zno ◽  
Fabrication And Characterization

AbstractCharacterization of 700-nm-thick poly(vinylidene fluoride/trifluoroethylene) [P(VDF/TrFE)]/TiO2/Al-doped ZnO (AZO) structures on a glass substrate were investigated. In this study, the sputtered TiO2 films as insulator were used for the reduction of leakage current. The leakage current density of the fabricated Pt/P(VDF/TrFE)/AZO and Pt/P(VDF/TrFE)/170-nm-thick TiO2/AZO structures were approximately 8.7 and 3.9 nA/cm2 at the applied voltage of 10 V, respectively. In the polarization vs. voltage characteristics, the fabricated Pt/P(VDF/TrFE)/TiO2/AZO structures showed hysteresis loops caused by ferroelectric polarization. The remnant polarization (2Pr) and coercive voltage (2Vc) measured from a saturated hysteresis loop at the frequency of 50 Hz were approximately 12 μC/cm2 and 105 V, respectively. These results suggest that the insertion of TiO2 film is available for reducing the gate leakage current without changing the ferroelectric properties.

Preparation and characterization of poly (vinylidene fluoride) ultrafiltration membrane with organic and inorganic porogens

Desalination ◽  
2014 ◽  
Vol 336 ◽  
pp. 1-7 ◽  
Author(s):  
Yan Jin ◽  
Ying Hua ◽  
Pin Zhang ◽  
Yanbin Yun ◽  
Panyue Zhang ◽  
...  
Keyword(s):  
Vinylidene Fluoride ◽  
Ultrafiltration Membrane ◽  
Poly Vinylidene Fluoride
Sign in / Sign up

Export Citation Format

Share Document