Validation of isotopic analysis of depleted, natural and enriched uranium using high resolution ICP-OES

2011 ◽  
Vol 26 (2) ◽  
pp. 293-299 ◽  
Author(s):  
Michael Krachler ◽  
Paul Carbol
2013 ◽  
Vol 110 ◽  
pp. 425-434 ◽  
Author(s):  
Michael Krachler ◽  
Rafael Alvarez-Sarandes ◽  
Paul Carbol ◽  
Rikard Malmbeck ◽  
Stefaan Van Winckel

2016 ◽  
Vol 125 ◽  
pp. 196-202 ◽  
Author(s):  
Michael Krachler ◽  
Rafael Alvarez-Sarandes

2021 ◽  
Vol 25 (2) ◽  
pp. 98-109
Author(s):  
P. A. Otopkova ◽  
◽  
A. M. Potapov ◽  
A. I. Suchkov ◽  
A. D. Bulanov ◽  
...  

In order to study the isotopic effects in semiconductor materials, single crystals of high chemical and isotopic purity are required. The reliability of the obtained data on the magnitude and the direction of isotopic shifts depends on the accuracy of determining the concentration of all stable isotopes. In the isotopic analysis of enriched “silicon-28” with a high degree of enrichment (> 99.99%), it is necessary to determine the impurities of 29Si and 30Si isotopes at the level of 10-3 ¸ 10-5 at. %. At this concentration level, these isotopes can be considered as impurities. It is difficult to achieve high measurement accuracy with simultaneous registration of the main and “impurity” isotopes in such a wide range of concentrations. The registration of analytical signals of silicon isotopes must be carried out in the solutions with different matrix concentrations. The use of the solutions with the high concentration of the matrix element requires the introduction of corrections for matrix noise and the drift of the instrument sensitivity during the measurement. It is possible to reduce the influence of the irreversible non-spectral interference and sensitivity drift by using the method of internal standardization. The inconsistency of the literature data on the selection criteria for the internal standard required studying the behavior of the signals of the “candidates for the internal standard” for the ELEMENT 2 single-collector high-resolution inductively coupled plasma mass spectrometer on the matrix element concentration and the nature of the solvent, as well as on the solution nebulizing time. Accounting for the irreversible non-spectral matrix noise and instrumental drift in isotopic analysis of enriched “silicon-28” and initial 28SiF4 by inductively coupled plasma mass spectrometry had allowed us to reduce by 3-5 times the random component and by more than an order of magnitude the systematic component of the measurement error in comparison with the external standard method. This made it possible to carry out, with sufficient accuracy, the operational control of the isotopic composition of enriched “silicon-28”, both in the form of silicon tetrafluoride and polycrystalline silicon obtained from it, using a single serial device in the range of isotopic concentrations 0.0001–99.999%.


2015 ◽  
Vol 15 (8) ◽  
pp. 4373-4387 ◽  
Author(s):  
H. L. DeWitt ◽  
S. Hellebust ◽  
B. Temime-Roussel ◽  
S. Ravier ◽  
L. Polo ◽  
...  

Abstract. Diesel-powered passenger cars currently outnumber gasoline-powered cars in many countries, particularly in Europe. In France, diesel cars represented 61% of light duty vehicles in 2011 and this percentage is still increasing (French Environment and Energy Management Agency, ADEME). As part of the September 2011 joint PM-DRIVE (Particulate Matter – DiRect and Indirect on-road Vehicular Emissions) and MOCOPO (Measuring and mOdeling traffic COngestion and POllution) field campaign, the concentration and high-resolution chemical composition of aerosols and volatile organic carbon species were measured adjacent to a major urban highway south of Grenoble, France. Alongside these atmospheric measurements, detailed traffic data were collected from nearby traffic cameras and loop detectors, which allowed the vehicle type, traffic concentration, and traffic speed to be quantified. Six aerosol age and source profiles were resolved using the positive matrix factorization model on real-time high-resolution aerosol mass spectra. These six aerosol source/age categories included a hydrocarbon-like organic aerosol (HOA) commonly associated with primary vehicular emissions, a nitrogen-containing aerosol with a diurnal pattern similar to that of HOA, oxidized organic aerosol (OOA), and biomass burning aerosol. While quantitatively separating the influence of diesel from that of gasoline proved impossible, a low HOA : black carbon ratio, similar to that measured in other high-diesel environments, and high levels of NOx, also indicative of diesel emissions, were observed. Although the measurement site was located next to a large source of primary emissions, which are typically found to have low oxygen incorporation, OOA was found to comprise the majority of the measured organic aerosol, and isotopic analysis showed that the measured OOA contained mainly modern carbon, not fossil-derived carbon. Thus, even in this heavily vehicular-emission-impacted environment, photochemical processes, biogenic emissions, and aerosol oxidation dominated the overall organic aerosol mass measured during most of the campaign.


1982 ◽  
Vol 37 (1) ◽  
pp. 744-747
Author(s):  
V. M. Aleksandruk ◽  
A. S. Babaev ◽  
A. V. Lovtsyus

2009 ◽  
Vol 56 (4) ◽  
pp. 2284-2289 ◽  
Author(s):  
Pete J. Karpius ◽  
Duc Vo ◽  
Minesh Bacrania ◽  
James Beall ◽  
Douglas Bennett ◽  
...  

2007 ◽  
Vol 64 ◽  
pp. 83-87
Author(s):  
Hiromi Yamamoto ◽  
Yoshitaka Hamada ◽  
Yue Li ◽  
Yusuke Setsuda ◽  
Ryo Matsumoto

2015 ◽  
Vol 30 (7) ◽  
pp. 1655-1662 ◽  
Author(s):  
Michael Krachler ◽  
Rafael Alvarez-Sarandes

High resolution ICP-OES allows for the reliable determination of plutonium in radioactive samples.


Sign in / Sign up

Export Citation Format

Share Document