Theory of dynamic equilibrium focusing generated by two physical fields in bidisperse suspension of colloidal particles

2000 ◽  
Vol 2 (11) ◽  
pp. 2607-2611 ◽  
Author(s):  
Josef Janča
Keyword(s):  
Colloidal Particles ◽  
Dynamic Equilibrium ◽  
Physical Fields ◽  
Bidisperse Suspension

Analysis of bacteriophage inactivation and its attenuation by adsorption onto colloidal particles by batch agitation techniques

1999 ◽  
Vol 45 (1) ◽  
pp. 9-17 ◽  
Author(s):  
P Rossi ◽  
M Aragno
Keyword(s):  
Liquid Medium ◽  
Colloidal Particles ◽  
Dynamic Equilibrium ◽  
Virus Population ◽  
Environmental Consequence ◽  
Clay Particles ◽  
Adsorption Mechanisms ◽  
Low Concentrations ◽  
Colloidal Clay ◽  
Phage T7

A batch agitation technique was designed to specify the different parameters that influence the inactivation and adsorption mechanisms of viruses in water. The advantage of this method over the classical procedures is that the kinetic reactions of the different subfractions of the virus population can be described simultaneously. A first set of experiments with phage T7 showed that this phage is rapidly inactivated in a constantly agitated liquid medium. This inactivation rate is highly influenced by temperature, but variation of the pH (from 5 to 9) and increase in salt concentration have no effect on it. The addition of colloidal clay particles (CCPs) of montmorillonite and attapulgite into the liquid medium considerably modifies this behavior, even at very low concentrations (0.025 mg/mL). The experiments show that the viruses react quickly with the particles and that bonding is not permanent. Viruses establish a dynamic equilibrium, which is strongly dependent on physicochemical parameters such as pH, ionic concentrations, and the presence of proteins or protein hydrolysates. A major environmental consequence is that the presence of CCPs seems to effectively protect the coliphage T7 from rapid inactivation.Key words: bacteriophage T7, viruses, inactivation and adsorption kinetics, colloidal particles, protective effect.

Microtubule nucleation sequence studied by time-resolved x-ray scattering and electron microscopy

1983 ◽  
Vol 41 ◽  
pp. 766-767
Author(s):  
Eva-Maria Mandelkow ◽  
Eckhard Mandelkow ◽  
Joan Bordas
Keyword(s):  
Electron Microscopy ◽  
Dynamic Equilibrium ◽  
Time Resolved ◽  
X Ray ◽  
Additional Information ◽  
X Ray Scattering ◽  
Low Concentrations ◽  
Microtubule Growth ◽  
Ray Patterns ◽  
Ray Scattering

When a solution of microtubule protein is changed from non-polymerising to polymerising conditions (e.g. by temperature jump or mixing with GTP) there is a series of structural transitions preceding microtubule growth. These have been detected by time-resolved X-ray scattering using synchrotron radiation, and they may be classified into pre-nucleation and nucleation events. X-ray patterns are good indicators for the average behavior of the particles in solution, but they are difficult to interpret unless additional information on their structure is available. We therefore studied the assembly process by electron microscopy under conditions approaching those of the X-ray experiment. There are two difficulties in the EM approach: One is that the particles important for assembly are usually small and not very regular and therefore tend to be overlooked. Secondly EM specimens require low concentrations which favor disassembly of the particles one wants to observe since there is a dynamic equilibrium between polymers and subunits.

Ultrastructure of Lymphatic Capillaries in the Transport of Colloidal Particles

1967 ◽  
Vol 25 ◽  
pp. 186-187
Author(s):  
L. V. Leak ◽  
J. F. Burke
Keyword(s):  
Connective Tissue ◽  
Colloidal Particles ◽  
Ultrastructural Level ◽  
Vital Role ◽  
Time Intervals ◽  
Thorium Dioxide ◽  
Lymphatic Capillary ◽  
Tissue Area ◽  
Rapid Removal ◽  
Tissue Fluids

The vital role played by the lymphatic capillaries in the transfer of tissue fluids and particulate materials from the connective tissue area can be demonstrated by the rapid removal of injected vital dyes into the tissue areas. In order to ascertain the mechanisms involved in the transfer of substances from the connective tissue area at the ultrastructural level, we have injected colloidal particles of varying sizes which range from 80 A up to 900-mμ. These colloidal particles (colloidal ferritin 80-100A, thorium dioxide 100-200 A, biological carbon 200-300 and latex spheres 900-mμ) are injected directly into the interstitial spaces of the connective tissue with glass micro-needles mounted in a modified Chambers micromanipulator. The progress of the particles from the interstitial space into the lymphatic capillary lumen is followed by observing tissues from animals (skin of the guinea pig ear) that were injected at various time intervals ranging from 5 minutes up to 6 months.

Deposited emulsion particles in the pores of aluminum oxide film

1978 ◽  
Vol 36 (1) ◽  
pp. 450-451
Author(s):  
Michio Ashida ◽  
Yasukiyo Ueda
Keyword(s):  
Oxide Film ◽  
Acid Solution ◽  
Barrier Layer ◽  
Colloidal Particles ◽  
Oxalic Acid Solution ◽  
Anodic Oxide ◽  
Anodic Oxide Film ◽  
Carbon Replica ◽  
Sectioning Method ◽  
Thin Sectioning

An anodic oxide film is formed on aluminum in an acidic elecrolyte during anodizing. The structure of the oxide film was observed directly by carbon replica method(l) and ultra-thin sectioning method(2). The oxide film consists of barrier layer and porous layer constructed with fine hexagonal cellular structure. The diameter of micro pores and the thickness of barrier layer depend on the applying voltage and electrolyte. Because the dimension of the pore corresponds to that of colloidal particles, many metals deposit in the pores. When the oxide film is treated as anode in emulsion of polyelectrolyte, the emulsion particles migrate onto the film and deposit on it. We investigated the behavior of the emulsion particles during electrodeposition.Aluminum foils (99.3%) were anodized in either 0.25M oxalic acid solution at 30°C or 3M sulfuric acid solution at 20°C. After washing with distilled water, the oxide films used as anode were coated with emulsion particles by applying voltage of 200V and then they were cured at 190°C for 30 minutes.

COUPLING OF COLLOIDAL PARTICLES AND RECOILLESS FRACTION

1976 ◽  
Vol 37 (C6) ◽  
pp. C6-273-C6-276
Author(s):  
H. J. ÜBELHACK ◽  
F. H. WITTMANN
Keyword(s):  
Colloidal Particles ◽  
Recoilless Fraction

Platelet Adhesion to Subendothelium - Effect of Shear Rate, Hematocrit and Platelet Count on the Dynamic Equilibrium Between Platelets Adhering to and Detaching from the Surface

1985 ◽  
Vol 54 (04) ◽  
pp. 857-861 ◽  
Author(s):  
Andrea Remuzzi ◽  
Lucia Raffaella Languino ◽  
Vincenzo Costantini ◽  
Vincenzo Guardabasso ◽  
Giovanni de Gartano ◽  
...  
Keyword(s):  
Platelet Adhesion ◽  
Initial Rate ◽  
Dynamic Equilibrium ◽  
Dynamic Condition ◽  
Platelet Reactivity ◽  
Experimental Conditions ◽  
Platelet Suspension ◽  
Shear Rates ◽  
Platelet Concentration ◽  
Adhesion Rate

SummaryThe adherence of human 3H-adenine-labeled platelets to rat subendothelium was quantitated using a rotating probe device. Platelet adhesion increased in relation to the rotation time, reaching a plateau value in about 4-6 min without any further increase. A non-linear fitting analysis of experimental data allowed calculations of initial rate and plateau value of platelet adhesion. Increasing the shear rates (from 35 to 150 sec-1) or the hematocrit (from 10% to 40%), both the adhesion rate and the plateau value were increased. When different platelet concentrations were used the adhesion rate and the plateau calculated increased with platelet concentration. Different plateau values were obtained in the experimental conditions considered. This suggests that the plateau was not reached for the complete occupation of the subendothelial surface by the adherent platelets. Experiments using two different vessels rotated in the same platelet suspension or, viceversa, the same vessel rotated successively in two fresh platelet suspensions, showed that the plateau was not determined by reduced platelet reactivity. Rotating the same vessel first in radiolabeled platelets, until the plateau was reached, and secondly in non labeled platelets, or viceversa, showed that the plateau was indeed a dynamic condition where the number of platelets adhering and detaching reached equilibrium. These observations suggest that the platelet adhesion to subendothelium is the final equilibrium of two platelet fluxes, one adhering to the surface and another detaching from the surface.

How to use alum with cationic dispersed rosin size

TAPPI Journal ◽  
2016 ◽  
Vol 15 (5) ◽  
pp. 331-335 ◽  
Author(s):  
LEBO XU ◽  
JEREMY MYERS ◽  
PETER HART
Keyword(s):  
Zeta Potential ◽  
Colloidal Particles ◽  
Streaming Potential ◽  
Excessive Amount ◽  
Paper Machine ◽  
Optimum Amount ◽  
Potential Measurement ◽  
Streaming Current ◽  
Wide Range ◽  
Laboratory Results

Retention of cationic dispersed rosin size was studied via turbidity measurements on stock filtrate with different alum and dispersed rosin size dosages. Stock charge characteristics were analyzed using both an analysis of charge demand determined via a streaming current detector and an evaluation of zeta potential of the fibers by streaming potential measurement. The results indicated that an optimum amount of alum existed such that good sizing retention was maintained throughout a wide range of dispersed rosin size dosages. However, when an excessive amount of alum was used and fines and colloidal particles were transitioned from anionic to cationic, the cationic size retention was reduced. Laboratory results were confirmed with a paper machine trial. All data suggested that a stock charge study was necessary to identify optimal alum dosage for a cationic dispersed rosin sizing program.

Sign in / Sign up

Export Citation Format

Share Document