Semantic Gradients and Interference with Sorting According to Color, Spatial Position, and Numerosity

1973 ◽  
Author(s):  
Leslie A. Fox ◽  
Ronald E. Shor
Keyword(s):  
Spatial Position

The Smoulder Stream of Cigarettes / Zur Kenntnis des Glimmstromes von Cigaretten

1965 ◽  
Vol 3 (2) ◽  
Author(s):  
F. Seehofer ◽  
W. Schulz
Keyword(s):  
Moisture Content ◽  
Spatial Position ◽  
High Yield ◽  
Physical Conditions ◽  
Moisture Contents ◽  
Cigarette Paper ◽  
First Time

AbstractThe phenomenon of the smoulder stream flowing through the cigarette during smouldering and during the puff intervals is demonstrated for the first time and its dependence upon physical conditions is examined. The volume of the smoulder stream can amount up to 180 ml per cigarette. Increasing draw resistance of the cigarette and augmenting moisture content of the tobacco as well as perforation of the cigarette paper have a decreasing effect on volume and velocity of the smoulder stream. The porosity of the cigarette paper has no perceptible influence. The spatial position of the cigarette affects volume and velocity of the smoulder stream. The influence exercised by the smoulder stream on the yields of total condensate, nicotine, phenols, aldehydes, and acroleine when the cigarette tip is open during the puff intervals is determined. When the moisture contents of the tobacco were extremely high, yield decreases reaching 50 % could be observed.

Experimental research control methods of the spatial position of building constructions

2017 ◽  
Vol 922 (4) ◽  
pp. 7-12 ◽  
Author(s):  
G.A. Shekhovtsov ◽  
R.P. Shekhovtsova ◽  
D.P. Ivenin ◽  
O.V. Raskatkina
Keyword(s):  
Simultaneous Determination ◽  
Experimental Research ◽  
Vertical Plane ◽  
Error Theory ◽  
Spatial Position ◽  
Bridge Crane ◽  
Building Structures ◽  
Control Methods ◽  
Engineering Geodesy

The article contains the method of discrete scanning points in the vertical plane of the columns and roof trusses for the simultaneous determination of vertical columns, the distance between them in flight at their tip and deflection farms with one point standing and only one performer. The technique is based on the use of reflectorless electronic tachymeter and its SDh key. Experimental research of methods on the elements of building structures NNGASU educational housing using electronic tachymeter SET530R. Results of the experiments were monitored by a coordinate and photographic methods, as well as with the developed at the chair of Engineering Geodesy laser-mirroring device designed to measure inaccessible or hard to reach distances. Analysis methods of error theory position and the results of its comparison with other methods have shown that it provides the required accuracy, easy to perform, does not require the output of the observer on the crane path or lift to the towers, free from the multiple engagement of the bridge crane and can be successfully applied on practice.

scholarly journals Deviation Tolerance Performance Evaluation and Experiment of Picking End Effector for Famous Tea

Agriculture ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 128
Author(s):  
Yingpeng Zhu ◽  
Chuanyu Wu ◽  
Junhua Tong ◽  
Jianneng Chen ◽  
Leiying He ◽  
...  
Keyword(s):  
Success Rate ◽  
Negative Pressure ◽  
Evaluation Method ◽  
Orthogonal Experiment ◽  
Spatial Position ◽  
End Effector ◽  
Significance Level ◽  
Growth Environment ◽  
End Effectors ◽  
Average Success Rate

Accurately obtaining the posture and spatial position of tea buds through machine vision and other technologies is difficult due to the small size, different shapes, and complex growth environment of tea buds. Therefore, end effectors are prone to problems, such as picking omission and picking error. This study designs a picking end effector based on negative pressure guidance for famous tea. This end effector uses negative pressure to guide tea buds in a top-down manner, thereby correcting their posture and spatial position. Therefore, the designed end effector has deviation tolerance performance that can improve the picking success rate. The pre-experiment is designed, the tip of apical bud is referred to as the descent position, and the negative pressure range is determined to be 0.6 to 0.9 kPa. A deviation tolerance orthogonal experiment is designed. Experimental results show that various experimental factors are ranked in terms of the significance level of the effect on the average success rate, and the significance ranking is as follows: negative pressure (P) > pipe diameter (D) > descent speed (V). An evaluation method of deviation tolerance performance is presented, and the optimal experiment factor-level combination is determined as: P = 0.9 kPa, D = 34 mm, V = 20 mm/s. Within the deviation range of a 10 mm radius, the average success rate of the negative pressure guidance of the end effector is 97.36%. The designed end effector can be applied to the intelligent picking of famous tea. This study can provide a reference for the design of similar picking end effectors for famous tea.

Effect of microhabitats, mesohabitats and spatial position on macroinvertebrate communities of a braided river

2021 ◽  
pp. 1-10
Author(s):  
Gemma Burgazzi ◽  
Paolo Vezza ◽  
Giovanni Negro ◽  
Luca Astegiano ◽  
Riccardo Pellicanó ◽  
...  
Keyword(s):  
Spatial Position ◽  
Braided River ◽  
Macroinvertebrate Communities

scholarly journals The Influence of Exploration Mode, Orientation, and Configuration on the Haptic Müller-Lyer Illusion

Perception ◽  
10.1068/p5269 ◽  
2005 ◽  
Vol 34 (12) ◽  
pp. 1475-1500 ◽  
Author(s):  
Morton A Heller ◽  
Melissa McCarthy ◽  
Jennifer Schultz ◽  
Jayme Greene ◽  
Melissa Shanley ◽  
...  
Keyword(s):  
Index Finger ◽  
Spatial Position ◽  
Lyer Illusion ◽  
Free Exploration ◽  
And Control ◽  
The Impact ◽  
Practical Implications

We studied the impact of manner of exploration, orientation, spatial position, and configuration on the haptic Müller-Lyer illusion. Blindfolded sighted subjects felt raised-line Müller-Lyer and control stimuli. The stimuli were felt by tracing with the index finger, free exploration, grasping with the index finger and thumb, or by measuring with the use of any two or more fingers. For haptic judgments of extent a sliding tangible ruler was used. The illusion was present in all exploration conditions, with overestimation of the wings-out compared to wings-in stimuli. Tracing with the index finger reduced the magnitude of the illusion. However, tracing and grasping induced an overall underestimation of size. The illusion was greatly attenuated when stimuli were felt with the index fingers of both hands. Illusory misperception was not altered by the position in space of the Müller-Lyer stimuli. No effects of changes in the thickness of the line shaft were found, but there were effects of the length of the wing endings for the smaller, 5.1 cm stimuli. The theoretical and practical implications of the results are discussed.

Image region label refinement using spatial position relation graph

2019 ◽  
Vol 166 ◽  
pp. 82-91
Author(s):  
Jing Zhang ◽  
Zhenkun Wang ◽  
Yakun Mu ◽  
Zhe Wang
Keyword(s):  
Spatial Position ◽  
Image Region ◽  
Relation Graph
Sign in / Sign up

Export Citation Format

Share Document