Structural variety and tectonic evolution of strike-slip basins related to the Philippine Fault System, northern Luzon, Philippines

Tectonics ◽  
1993 ◽  
Vol 12 (1) ◽  
pp. 187-203 ◽  
Author(s):  
Jean Claude Ringenbach ◽  
Nicolas Pinet ◽  
Jean François Stéphan ◽  
Jean Delteil
Keyword(s):  
Tectonic Evolution ◽  
Strike Slip ◽  
Fault System ◽  
Structural Variety

Is the North Altyn fault part of a strike-slip duplex along the Altyn Tagh fault system?

Geology ◽  
2000 ◽  
Vol 28 (3) ◽  
pp. 255 ◽  
Author(s):  
Eric Cowgill ◽  
An Yin ◽  
Wang Xiao Feng ◽  
Zhang Qing
Keyword(s):  
Strike Slip ◽  
Fault System ◽  
Altyn Tagh Fault ◽  
The North ◽  
Altyn Tagh

Tectonic evolution of a low-angle extensional fault system from restored cross-sections in the Northern Apennines (Italy)

Tectonics ◽  
2011 ◽  
Vol 30 (6) ◽  
pp. n/a-n/a ◽  
Author(s):  
F. Mirabella ◽  
F. Brozzetti ◽  
A. Lupattelli ◽  
M. R. Barchi
Keyword(s):  
Cross Sections ◽  
Tectonic Evolution ◽  
Northern Apennines ◽  
Fault System

Microearthquake seismicity and tectonics of Coastal Northern California

1970 ◽  
Vol 60 (5) ◽  
pp. 1669-1699 ◽  
Author(s):  
Leonardo Seeber ◽  
Muawia Barazangi ◽  
Ali Nowroozi
Keyword(s):  
High Frequency ◽  
Fault Plane ◽  
San Andreas Fault ◽  
High Gain ◽  
Strike Slip ◽  
Fault System ◽  
Northern California ◽  
Fault Plane Solutions ◽  
Sharp Bend ◽  
San Andreas

Abstract This paper demonstrates that high-gain, high-frequency portable seismographs operated for short intervals can provide unique data on the details of the current tectonic activity in a very small area. Five high-frequency, high-gain seismographs were operated at 25 sites along the coast of northern California during the summer of 1968. Eighty per cent of 160 microearthquakes located in the Cape Mendocino area occurred at depths between 15 and 35 km in a well-defined, horizontal seismic layer. These depths are significantly greater than those reported for other areas along the San Andreas fault system in California. Many of the earthquakes of the Cape Mendocino area occurred in sequences that have approximately the same magnitude versus length of faulting characteristics as other California earthquakes. Consistent first-motion directions are recorded from microearthquakes located within suitably chosen subdivisions of the active area. Composite fault plane solutions indicate that right-lateral movement prevails on strike-slip faults that radiate from Cape Mendocino northwest toward the Gorda basin. This is evidence that the Gorda basin is undergoing internal deformation. Inland, east of Cape Mendocino, a significant component of thrust faulting prevails for all the composite fault plane solutions. Thrusting is predominant in the fault plane solution of the June 26 1968 earthquake located along the Gorda escarpement. In general, the pattern of slip is consistent with a north-south crustal shortening. The Gorda escarpment, the Mattole River Valley, and the 1906 fault break northwest of Shelter Cove define a sharp bend that forms a possible connection between the Mendocino escarpment and the San Andreas fault. The distribution of hypocenters, relative travel times of P waves, and focal mechanisms strongly indicate that the above three features are surface expressions of an important structural boundary. The sharp bend in this boundary, which is concave toward the southwest, would tend to lock the dextral slip along the San Andreas fault and thus cause the regional north-south compression observed at Cape Mendocino. The above conclusions support the hypothesis that dextral strike-slip motion along the San Andreas fault is currently being taken up by slip along the Mendocino escarpment as well as by slip along northwest trending faults in the Gorda basin.

Erosion rates of the New Zealand Southern Alps reflect long-term tectonics and transient climate

2021 ◽  
Author(s):  
Duna Roda-Boluda ◽  
Taylor Schildgen ◽  
Hella Wittmann-Oelze ◽  
Stefanie Tofelde ◽  
Aaron Bufe ◽  
...  
Keyword(s):  
New Zealand ◽  
Strike Slip ◽  
Southern Alps ◽  
Fault System ◽  
Tectonic Deformation ◽  
Seismic Cycle ◽  
Erosion Rates ◽  
Alpine Fault ◽  
Oblique Convergence

<p>The Southern Alps of New Zealand are the expression of the oblique convergence between the Pacific and Australian plates, which move at a relative velocity of nearly 40 mm/yr. This convergence is accommodated by the range-bounding Alpine Fault, with a strike-slip component of ~30-40 mm/yr, and a shortening component normal to the fault of ~8-10 mm/yr. While strike-slip rates seem to be fairly constant along the Alpine Fault, throw rates appear to vary considerably, and whether the locus of maximum exhumation is located near the fault, at the main drainage divide, or part-way between, is still debated. These uncertainties stem from very limited data characterizing vertical deformation rates along and across the Southern Alps. Thermochronology has constrained the Southern Alps exhumation history since the Miocene, but Quaternary exhumation is hard to resolve precisely due to the very high exhumation rates. Likewise, GPS surveys estimate a vertical uplift of ~5 mm/yr, but integrate only over ~10 yr timescales and are restricted to one transect across the range.</p><p>To obtain insights into the Quaternary distribution and rates of exhumation of the western Southern Alps, we use new <sup>10</sup>Be catchment-averaged erosion rates from 20 catchments along the western side of the range. Catchment-averaged erosion rates span an order of magnitude, between ~0.8 and >10 mm/yr, but we find that erosion rates of >10 mm/yr, a value often quoted in the literature as representative for the entire range, are very localized. Moreover, erosion rates decrease sharply north of the intersection with the Marlborough Fault System, suggesting substantial slip partitioning. These <sup>10</sup>Be catchment-averaged erosion rates integrate, on average, over the last ~300 yrs. Considering that the last earthquake on the Alpine Fault was in 1717, these rates are representative of inter-seismic erosion. Lake sedimentation rates and coseismic landslide modelling suggest that long-term (~10<sup>3</sup> yrs) erosion rates over a full seismic cycle could be ~40% greater than our inter-seismic erosion rates. If we assume steady state topography, such a scaling of our <sup>10</sup>Be erosion rate estimates can be used to estimate rock uplift rates in the Southern Alps. Finally, we find that erosion, and hence potentially exhumation, does not seem to be localized at a particular distance from the fault, as some tectonic and provenance studies have suggested. Instead, we find that superimposed on the primary tectonic control, there is an elevation/temperature control on erosion rates, which is probably transient and related to frost-cracking and glacial retreat.</p><p>Our results highlight the potential for <sup>10</sup>Be catchment-averaged erosion rates to provide insights into the magnitude and distribution of tectonic deformation rates, and the limitations that arise from transient erosion controls related to the seismic cycle and climate-modulated surface processes.</p><p> </p><p> </p>

Bathymetry and uplift rate of the Gulf of Aqaba, Dead Sea Fault.

2021 ◽  
Author(s):  
Matthieu Ribot ◽  
Yann Klinger ◽  
Edwige Pons-Branchu ◽  
Marthe Lefevre ◽  
Sigurjón Jónsson
Keyword(s):  
High Resolution ◽  
Tectonic Evolution ◽  
Active Faults ◽  
Major Change ◽  
Dead Sea ◽  
Fault System ◽  
Arabian Plate ◽  
Gulf Of Aqaba ◽  
Uplift Rate ◽  
The Dead

<p>Initially described in the late 50’s, the Dead Sea Fault system connects at its southern end to the Red Sea extensive system, through a succession of left-stepping faults. In this region, the left-lateral differential displacement of the Arabian plate with respect to the Sinai micro-plate along the Dead Sea fault results in the formation of a depression corresponding to the Gulf Aqaba. We acquired new bathymetric data in the areas of the Gulf of Aqaba and Strait of Tiran during two marine campaigns (June 2018, September 2019) in order to investigate the location of the active faults, which structure and control the morphology of the area. The high-resolution datasets (10-m posting) allow us to present a new fault map of the gulf and to discuss the seismic potential of the main active faults.</p><p>We also investigated the eastern margin of the Gulf of Aqaba and Tiran island to assess the vertical uplift rate. To do so, we computed high-resolution topographic data and we processed new series of U-Th analyses on corals from the uplifted marine terraces.</p><p>Combining our results with previous studies, we determined the local and the regional uplift in the area of the Gulf of Aqaba and Strait of Tiran.</p><p>Eventually, we discussed the tectonic evolution of the gulf since the last major change of the tectonic regime and we propose a revised tectonic evolution model of the area.</p><p> </p>

Inversion of regional surface-wave spectra for source parameters of aftershocks from the 1992 Petrolia earthquake sequence

1995 ◽  
Vol 85 (3) ◽  
pp. 705-715
Author(s):  
Mark Andrew Tinker ◽  
Susan L. Beck
Keyword(s):  
Surface Wave ◽  
Focal Mechanism ◽  
Source Parameters ◽  
Strike Slip ◽  
Earthquake Sequence ◽  
Fault System ◽  
Accretionary Wedge ◽  
Wave Spectra ◽  
The North ◽  
Gorda Plate

Abstract Regional distance surface waves are used to study the source parameters for moderate-size aftershocks of the 25 April 1992 Petrolia earthquake sequence. The Cascadia subduction zone had been relatively seismically inactive until the onset of the mainshock (Ms = 7.1). This underthrusting event establishes that the southern end of the North America-Gorda plate boundary is seismogenic. It was followed by two separate and distinct large aftershocks (Ms = 6.6 for both) occurring at 07:41 and 11:41 on 26 April, as well as thousands of other small aftershocks. Many of the aftershocks following the second large aftershock had magnitudes in the range of 4.0 to 5.5. Using intermediate-period surface-wave spectra, we estimate focal mechanisms and depths for one foreshock and six of the larger aftershocks (Md = 4.0 to 5.5). These seven events can be separated into two groups based on temporal, spatial, and principal stress orientation characteristics. Within two days of the mainshock, four aftershocks (Md = 4 to 5) occurred within 4 hr of each other that were located offshore and along the Mendocino fault. These four aftershocks comprise one group. They are shallow, thrust events with northeast-trending P axes. We interpret these aftershocks to represent internal compression within the North American accretionary prism as a result of Gorda plate subduction. The other three events compose the second group. The shallow, strike-slip mechanism determined for the 8 March foreshock (Md = 5.3) may reflect the right-lateral strike-slip motion associated with the interaction between the northern terminus of the San Andreas fault system and the eastern terminus of the Mendocino fault. The 10 May aftershock (Md = 4.1), located on the coast and north of the Mendocino triple junction, has a thrust fault focal mechanism. This event is shallow and probably occurred within the accretionary wedge on an imbricate thrust. A normal fault focal mechanism is obtained for the 5 June aftershock (Md = 4.8), located offshore and just north of the Mendocino fault. This event exhibits a large component of normal motion, representing internal failure within a rebounding accretionary wedge. These two aftershocks and the foreshock have dissimilar locations in space and time, but they do share a north-northwest oriented P axis.

Seismic attribute for characterization and prediction of carbonate faulted karst reservoirs in Tarim Basin, China

2021 ◽  
pp. 1-36
Author(s):  
Zhiwei Xiao ◽  
Li Wang ◽  
Ruizhao Yang ◽  
Dewei Li ◽  
Lingbin Meng
Keyword(s):  
Tarim Basin ◽  
Oil And Gas ◽  
Prediction Method ◽  
Strike Slip ◽  
Fault System ◽  
Bright Spot ◽  
Upper Ordovician ◽  
Reservoir Prediction ◽  
Seismic Attribute ◽  
Gas Field

An ultradeep, faulted karst reservoir of Ordovician carbonate was discovered in the Shunbei area of the Tarim Basin. Fractured-cavity reservoirs buried beneath the large thickness of upper Ordovician mudstone were formed along the fault-karst belts. The hydrocarbon accumulation in these reservoirs is controlled by the fault system, and the oil-gas accumulation was affected by karstification and hydrothermal reformation. Previous studies and 2D modeling revealed that the reservoirs had “bright spot” amplitude responses like “string beads,” and they have developed along the strike-slip faults. However, describing such a complex fault-controlled karst system is still a difficult problem that has not been well addressed. We have sought to instruct the attribute expression of faulted karst reservoirs in the northern part of the Tarim Basin. We applied coherence and fault likelihood (FL) seismic attributes to image faults and fractures zones. We then used a trend analysis method to calculate the residual impedance from the impedance of the acoustic inversion, using the fact that residual impedance has higher lateral resolution in reservoir predictions. Finally, we integrated the coherence, FL, and residual impedance attributes into a new seismic attribute, the “fault-vuggy body,” with a certain fusion coefficient. The fault-vuggy body attribute establishes a connection between faults and karst cavities. This method could help in the characterization and prediction of carbonate faulted karst reservoirs. Available drilling data were used to validate that the fused fault-vuggy body attribute was an effective reservoir prediction method. As the seismic sections and slices along the layer help delineate, the distribution of bright spots and strike-slip faults indicates that the main strike-slip fault zones are the most favorable reservoirs in the Shunbei Oil and Gas Field.

Sign in / Sign up

Export Citation Format

Share Document