Seismic constraints on the nature of lower crustal reflectors beneath the extending Southern Transition Zone of the Colorado Plateau, Arizona

1992 ◽  
Vol 97 (B9) ◽  
pp. 12391 ◽  
Author(s):  
Tom Parsons ◽  
John M. Howie ◽  
George A. Thompson
Keyword(s):  
Transition Zone ◽  
Colorado Plateau ◽  
Lower Crustal

Signal penetration In the COCORP Basin and Range‐Colorado Plateau survey

Geophysics ◽  
1986 ◽  
Vol 51 (5) ◽  
pp. 1050-1055 ◽  
Author(s):  
James R. Mayer ◽  
Larry D. Brown
Keyword(s):  
Transition Zone ◽  
Colorado Plateau ◽  
Sedimentary Cover ◽  
Basin And Range ◽  
Eastern Basin ◽  
Arrival Times ◽  
Reflection Data ◽  
Temporal Decay ◽  
On Line ◽  
Seismic Sections

Seismic sections from COCORP’s 1982 survey from the eastern Basin and Range to the Colorado Plateau of central Utah exhibit distinct cutoff times after which reflections are rare to nonexistent. In the eastern Basin and Range, this cutoff time is approximately 11 s (33 km), but beneath the central Colorado Plateau it exceeds 15 s (45 km). These depths appear to correspond to the base of the crust (Moho), with the lack of reflections from greater depths indicating mantle homogeneity. In general, absence of deeper reflections may be due either to geologic homogeneity or to lack of signal penetration. COCORP line 3 in the Colorado Plateau‐Basin and Range transition zone shows that variations in penetration are significant. On line 3 few reflections are evident below the structurally complex sedimentary cover, which extends to only 4 s (8 km), and virtually none are identifiable later than 7 s (21 km). Lateral variations in the temporal decay of source‐generated energy, together with estimates of corresponding ambient noise levels, infer that limited signal penetration, rather than geologic homogeneity, causes the lack of subsedimentary reflections within the transition zone. Deep reflections, if any, from beneath the westernmost Colorado Plateau appear to be masked by unusually high local environmental noise. In contrast, continued decay of source‐generated energy at traveltimes significantly greater than Moho arrival times within the Basin and Range and Colorado Plateau suggests (though it cannot confirm) that the underlying mantle is seismically transparent. Variations in signal penetration, such as those documented here, severely constrain interpretations of nonreflective zones in deep reflection data and should be a standard estimation in any interpretational procedure.

scholarly journals In search for the missing arc root of the Southern California Batholith: P-T-t evolution of upper mantle xenoliths of the Colorado Plateau Transition Zone

2020 ◽  
Vol 547 ◽  
pp. 116447 ◽  
Author(s):  
Ojashvi Rautela ◽  
Alan D. Chapman ◽  
Jessie E. Shields ◽  
Mihai N. Ducea ◽  
Cin-Ty Lee ◽  
...  
Keyword(s):  
Transition Zone ◽  
Upper Mantle ◽  
Southern California ◽  
Colorado Plateau ◽  
Mantle Xenoliths ◽  
Arc Root

Lower crustal low-resistivity zones caused by compaction-induced fluid localization and stagnation – recent results from electromagnetic data in an intracontinental setting

2021 ◽  
Author(s):  
Matthew Joseph Comeau ◽  
Michael Becken ◽  
James A. D. Connolly ◽  
Alexander Grayver ◽  
Alexey V. Kuvshinov ◽  
...  
Keyword(s):  
Electrical Resistivity ◽  
Transition Zone ◽  
Hydrodynamic Model ◽  
Lower Crust ◽  
Dislocation Creep ◽  
Magnetotelluric Data ◽  
Low Resistivity ◽  
Vertical Extent ◽  
Brittle Ductile Transition ◽  
Lower Crustal

<p>We investigate how a conceptual hydrodynamic model consisting of fluid localization and stagnation by thermally activated compaction can explain low-resistivity anomalies observed in the lower crust (>20 km depth). Electrical resistivity models, derived from magnetotelluric data collected across the intracontinental Bulnay region, a subset of a larger regional array across central Mongolia, are generated. They reveal low-resistivity (3 - 30 Ωm) domains with a width of ~25 km and a vertical extent of <10 km in the lower crust, with their tops ~5 km below the brittle-ductile transition zone. In 3-D these features appear as laterally extended (tube-like) structures, 300 km long, rather than disconnected ellipsoids. The features are oriented parallel to the adjacent Bulnay fault zone segments and perpendicular to the far-field compressive tectonic stress (i.e., northward motion from China and Tibet). These low-resistivity domains are consistent with the presence of saline metamorphic fluids. Deeper features imaged with the data include a large upper mantle conductor that we attribute to an asthenospheric upwelling, and thin lithosphere, related to intraplate surface uplift and volcanism, in agreement with recent geodynamic modelling of lithospheric removal in this region.</p><p>Based on the observed thermal structure of the crust, and assuming the mean stress at the brittle-ductile transition is twice the vertical load, the hydrodynamic model predicts that fluids would collect in zones <9 km below the brittle-ductile transition zone, and the zones would have a vertical extent of ~9 km, both in agreement with the resistivity models across the Bulnay region. The hydrodynamic model also gives plausible values for the activation energy for viscous creep (270 - 360 kJ/mol), suggesting that the mechanism is dislocation creep.</p><p>From the electrical resistivity models, the lower crustal viscous compaction-length is constrained to be ~25 km - in this region. Within the conceptual model, this length-scale is entirely consistent with independent estimates for the specific hydraulic and rheological properties of this region. In fact, this can be used to independently constrain acceptable ranges for the lower crustal effective viscosity, which is found to be low (on the order of 10^18 Pas). Accordingly, the results indicate that low-salinity fluids (likely 1 - 0.01 wt% NaCl), and correspondingly low porosities (likely 5 - 0.1 vol%), are the most plausible. These key findings suggest partial melts are not favoured to explain the anomalies. Overall, the results of this contribution imply that it is tectonic and compaction processes that control lower crustal fluid flow, rather than lithological or structural heterogeneity.</p>

Reflection seismic surveys to site the Drilling the Ivrea Verbano zonE (DIVE) proposed drill-holes, Val Sesia and Val d’Ossola, Italy.

2020 ◽  
Author(s):  
Andrew Greenwood ◽  
Ludovic Baron ◽  
Yu Liu ◽  
György Hetényi ◽  
Klaus Holliger ◽  
...  
Keyword(s):  
Continental Crust ◽  
Transition Zone ◽  
Lower Crust ◽  
Seismic Reflection ◽  
Spatial Scales ◽  
Seismic Reflection Data ◽  
Seismic Surveys ◽  
Crustal Rocks ◽  
Drill Holes ◽  
Lower Crustal

<p>The Ivrea-Verbano Zone in the Italian Alps represents one of the most complete and best-studied cross-sections of the continental crust. Here, geological and geophysical observations indicate the presence of the Moho transition zone at shallow depth, possibly as shallow as 3 km in the location of Balmuccia in Val Sesia. Correspondingly, the Ivrea-Verbano Zone is a primary target for assembling data on the deep continental crust as well as for testing several hypotheses regarding its formation and evolution.</p><p>            Within the context of a project submitted to the International Continental Scientific Drilling Program (ICDP), the Drilling the Ivrea-Verbano zonE (DIVE) team proposes to establish three drill holes across pertinent structures within the Ivrea-Verbano Zone. Two of the planned drill holes, each with a length of ~1000 m, are within Val d’Ossola and target the Pre-Permian lower and upper section of the lower crust. The third proposed drill hole, with a length of ~4000 m, is targeting the lower most crust of the Permian magmatic system of the Ivrea-Verbano Zone in the Val Sesia, close to the Insubric Line. Combined, the three drill holes will compose a complete section of the lower crust and the Moho transition zone, and will reveal the associated structural and composition characteristics at different scales.</p><p>To bridge across the range of spatial scales and to support the drilling proposal, we have carried out active seismic surveys using an EnviroVibe source in the Val d’Ossola. These surveys combined 2D transects (in-line) with the simultaneous collection of short cross-lines, and spatially varied source points, to collect sparse 3D data with a preferential CMP coverage across strike. This survey geometry was largely controlled by environmental considerations and access for the vibrator. Accordingly, 2D profiles, both in-line and cross-line, have been processed using crooked-line geometries, which include CMPs from the 3D infill.</p><p>The very high acoustic impedance contrast of the Quaternary valley infill sediments with respect to the predominant metapelitic and gabbroic lower crustal rocks, as well as the highly attenuative nature of the sediments, were both beneficial and problematic. The former enables mapping of the valley structure, while the latter largely prevents the detection of low-amplitude reflections from within the underlying lower crustal rocks.</p><p>Here, we present the latest results of these seismic reflection surveys and discuss the observations with respect to the prevailing structure and the planning of the drilling operations. Beyond the specific objectives pursued in this study, our results have important implications with regard to the acquisition and processing of high-resolution seismic reflection data in crystalline terranes and their capacity for resolving complex, steeply dipping structures.</p>

Sign in / Sign up

Export Citation Format

Share Document