Comment on "Effective groundwater model parameter values: Influence of spatial variability of hydraulic conductivity, Leakance, and recharge" by J. Gomez-Hernandez and S. Gorelick

1990 ◽  
Vol 26 (8) ◽  
pp. 1843-1846 ◽  
Author(s):  
R. Ababou
Keyword(s):  
Hydraulic Conductivity ◽  
Spatial Variability ◽  
Groundwater Model ◽  
Model Parameter ◽  
Parameter Values

Spatial Variability of Contaminant Transport in a Fractured Till, Avedøre Denmark

1999 ◽  
Vol 30 (4-5) ◽  
pp. 333-360 ◽  
Author(s):  
Larry McKay ◽  
Johnny Fredericia ◽  
Melissa Lenczewski ◽  
Jørn Morthorst ◽  
Knud Erik S. Klint
Keyword(s):  
Hydraulic Conductivity ◽  
Spatial Variability ◽  
Field Experiment ◽  
Contaminant Transport ◽  
Tracer Test ◽  
Conductivity Measurements ◽  
Fine Grained ◽  
Downward Migration ◽  
Rapid Transport ◽  
High Degree

A field experiment shows that rapid downward migration of solutes and microorganisms can occur in a fractured till. A solute tracer, chloride, and a bacteriophage tracer, PRD-1, were added to groundwater and allowed to infiltrate downwards over a 4 × 4 m area. Chloride was detected in horizontal filters at 2.0 m depth within 3-40 days of the start of the tracer test, and PRD-1 was detected in the same filters within 0.27 - 27 days. At 2.8 m depth chloride appeared in all the filters, but PRD-1 appeared in only about one-third of the filters. At 4.0 m depth chloride appeared in about one-third of the filters and trace amounts of PRD-1 were detected in only 2 of the 36 filters. Transport rates and peak tracer concentrations decreased with depth, but at each depth there was a high degree of variability. The transport data is generally consistent with expectations based on hydraulic conductivity measurements and on the observed density of fractures and biopores, both of which decrease with depth. Transport of chloride was apparently retarded by diffusion into the fine-grained matrix between fractures, but the rapid transport of PRD-1, with little dispersion, indicates that it was transported mainly through the fractures.

EFFECT OF SPATIAL VARIABILITY IN HYDRAULIC CONDUCTIVITY ON WATER TABLE DRAWDOWN

1997 ◽  
Vol 40 (2) ◽  
pp. 371-375
Author(s):  
S. O. Prasher ◽  
M. Singh ◽  
A. K. Maheshwari ◽  
R. S. Clemente
Keyword(s):  
Hydraulic Conductivity ◽  
Spatial Variability ◽  
Water Table

scholarly journals Experimental investigation to characterize simple versus multi scaling analysis of hydraulic conductivity at a mesoscale

2021 ◽  
Author(s):  
Guglielmo Federico Antonio Brunetti ◽  
Samuele De Bartolo ◽  
Carmine Fallico ◽  
Ferdinando Frega ◽  
Maria Fernanda Rivera Velásquez ◽  
...  
Keyword(s):  
Hydraulic Conductivity ◽  
Spatial Variability ◽  
Hydraulic Properties ◽  
Scaling Laws ◽  
Scaling Analysis ◽  
Field Scale ◽  
Porous Formation ◽  
Proper Design ◽  
First Time

AbstractThe spatial variability of the aquifers' hydraulic properties can be satisfactorily described by means of scaling laws. The latter enable one to relate the small (typically laboratory) scale to the larger (typically formation/regional) ones, therefore leading de facto to an upscaling procedure. In the present study, we are concerned with the spatial variability of the hydraulic conductivity K into a strongly heterogeneous porous formation. A strategy, allowing one to identify correctly the single/multiple scaling of K, is applied for the first time to a large caisson, where the medium was packed. In particular, we show how to identify the various scaling ranges with special emphasis on the determination of the related cut-off limits. Finally, we illustrate how the heterogeneity enhances with the increasing scale of observation, by identifying the proper law accounting for the transition from the laboratory to the field scale. Results of the present study are of paramount utility for the proper design of pumping tests in formations where the degree of spatial variability of the hydraulic conductivity does not allow regarding them as “weakly heterogeneous”, as well as for the study of dispersion mechanisms.

Open-loop stable running

Robotica ◽  
2005 ◽  
Vol 23 (1) ◽  
pp. 21-33 ◽  
Author(s):  
Katja D. Mombaur ◽  
Richard W. Longman ◽  
Hans Georg Bock ◽  
Johannes P. Schlöder
Keyword(s):  
Optimization Methods ◽  
Open Loop ◽  
Bipedal Robots ◽  
Model Parameter ◽  
Stable Periodic ◽  
Parameter Values ◽  
Difficult Issue ◽  
Loop Stability

We present simulated monopedal and bipedal robots that are capable of open-loop stable periodic running motions without any feedback even though they have no statically stable standing positions. Running as opposed to walking involves flight phases which makes stability a particularly difficult issue. The concept of open-loop stability implies that the actuators receive purely periodic torque or force inputs that are never altered by any feedback in order to prevent the robot from falling. The design of these robots and the choice of model parameter values leading to stable motions is a difficult task that has been accomplished using newly developed stability optimization methods.

Sign in / Sign up

Export Citation Format

Share Document