scholarly journals Turbulent mixing and transport of collisionless plasmas across a stratified velocity shear layer

2006 ◽  
Vol 111 (A5) ◽  
Author(s):  
Yosuke Matsumoto ◽  
Masahiro Hoshino
Keyword(s):  
Shear Layer ◽  
Turbulent Mixing ◽  
Velocity Shear ◽  
Collisionless Plasmas ◽  
Mixing And Transport

Flow Geometry Effects on the Turbulent Mixing Efficiency

2006 ◽  
Vol 128 (4) ◽  
pp. 874-879 ◽  
Author(s):  
Roberto C. Aguirre ◽  
Jennifer C. Nathman ◽  
Haris C. Catrakis
Keyword(s):  
Shear Layer ◽  
Turbulent Mixing ◽  
Large Scale ◽  
Mixture Fraction ◽  
Mixing Efficiency ◽  
Developed Turbulence ◽  
Planar Shear ◽  
Flow Geometry ◽  
Schmidt Numbers ◽  
Geometry Effects

Flow geometry effects are examined on the turbulent mixing efficiency quantified as the mixture fraction. Two different flow geometries are compared at similar Reynolds numbers, Schmidt numbers, and growth rates, with fully developed turbulence conditions. The two geometries are the round jet and the single-stream planar shear layer. At the flow conditions examined, the jet exhibits an ensemble-averaged mixing efficiency which is approximately double the value for the shear layer. This substantial difference is explained fluid mechanically in terms of the distinct large-scale entrainment and mixing-initiation environments and is therefore directly due to flow geometry effects.

scholarly journals Effects of velocity shear layer on detonation propagation in a supersonic expanding combustor

2021 ◽  
Vol 33 (10) ◽  
pp. 105110
Author(s):  
Jian Dai ◽  
Fei Xu ◽  
Xiaodong Cai ◽  
Yasser Mahmoudi
Keyword(s):  
Shear Layer ◽  
Velocity Shear ◽  
Detonation Propagation

Electrostatic and magnetic fluctuations in the proximity of the velocity shear layer in the TJ‐I tokamak

1992 ◽  
Vol 4 (12) ◽  
pp. 4007-4011 ◽  
Author(s):  
I. García‐Cortés ◽  
M. A. Pedrosa ◽  
C. Hidalgo ◽  
B. Brañas ◽  
T. Estrada ◽  
...  
Keyword(s):  
Shear Layer ◽  
Velocity Shear ◽  
Magnetic Fluctuations

The potential flow bounded by a mixing layer and a solid surface

1984 ◽  
Vol 395 (1809) ◽  
pp. 265-290 ◽  
Keyword(s):  
Shear Layer ◽  
Solid Surface ◽  
Turbulent Mixing ◽  
Potential Flow ◽  
Near Field ◽  
Mixing Layer ◽  
Detailed Comparison ◽  
Mixing Layers ◽  
Turbulent Shear ◽  
Spatial Correlations

Phillips's ( Proc. Camb. Phil. Soc . 51, 220 (1955)) analysis of the potential 'near field' forced by a turbulent shear layer is extended to include calculation of velocity spectra, spatial correlations and the effect of a solid surface at a finite distance from the shear layer. In the region away from the influence of the wall the theory predicts that correlation scales depend principally on the effective distance from the turbulence. This result suggests that the large correlation scales measured outside turbulent mixing layers do not necessarily demonstrate the essential tow-dimensionality of the large turbulent eddies and shows why mixing layers are more influenced by potential flow effects than are other shear layers. The detailed comparison of the theory to measurements made outside a high Reynolds number single-stream turbulent mixing layer results in an unphysical negative regions are caused by an error in a basic assumption of the theory. However, all the measured correlation scales appear to increase linearly with distance from the turbulence and therefore are consistent with the main result of the analysis. As the potential flow becomes affected by the wind tunnel floor, u 2 — and w 2 — are amplified significantly more than the theory predicts, while v 2 — is not attenuated. These discrepancies are attributed partly to the streamwise inhomogeneity of the flow, which was not incorporated into the analysis.

Velocity shear layer measurements by reflectometry in TJ-II plasmas

2006 ◽  
Vol 46 (9) ◽  
pp. S792-S798 ◽  
Author(s):  
T Estrada ◽  
E Blanco ◽  
L Cupido ◽  
M.E Manso ◽  
J Sánchez
Keyword(s):  
Shear Layer ◽  
Velocity Shear

Turbulent mixing and atomization in a confined shear layer

1991 ◽  
Vol 7 (4) ◽  
pp. 488-496 ◽  
Author(s):  
R. C. Prior ◽  
K. V. Tallio ◽  
A. M. Mellor
Keyword(s):  
Shear Layer ◽  
Turbulent Mixing

Surface Roughness Impact on Boundary Layer Transition and Loss Mechanisms over a Flat-Plate under a Low-Pressure Turbine Pressure Gradient

2021 ◽  
pp. 1-40
Author(s):  
Heechan Jeong ◽  
Seung Jin Song
Keyword(s):  
Surface Roughness ◽  
Pressure Gradient ◽  
Shear Layer ◽  
Flat Plate ◽  
Turbulence Intensity ◽  
Turbulent Mixing ◽  
Separation Bubble ◽  
Low Pressure Turbine ◽  
Separated Shear Layer ◽  
Profile Loss

Abstract An experimental study has been conducted to investigate the effects of surface roughness on the profile loss of a flat-plate with a contoured wall. All of the measurements have been conducted for the suction side pressure gradient of a high-lift low pressure turbine airfoil at the fixed Reynolds number (Rec) and freestream turbulence intensity (Tu) of 1.2 · 105 and 3.2%, respectively, representing a cruise condition. The time-resolved streamwise and wall-normal velocity fields for three different surface roughness values of Ra/C · 105 = 0.065, 4.417 and 7.428 have been measured with a 2D hot-wire probe. For the smooth surface, a laminar separation bubble forms from about 60% of the chord; and laminar-to-turbulent transition occurs during reattachment. Since the portion of turbulent flow over the flat-plate is relatively small, the overall profile loss is mainly determined by the momentum deficit generated during transition. Increased roughness decreases the maximum height and length of the separation bubble but does not affect the separation bubble onset location. The beneficial effects of increased surface roughness on the profile loss appear in the separated shear layer and reattachment. Increased surface roughness increases turbulent mixing in the separated shear layer. Thus, the shear layer thickness and momentum deficit are reduced. In addition, increased surface roughness reduces the length scale and turbulence intensity of the shed vortices. Consequently, turbulent mixing and momentum deficit during reattachment of boundary layers are decreased, resulting in a lower profile loss.

On the turbulent mixing of compressible free shear layers

1990 ◽  
Vol 431 (1882) ◽  
pp. 219-243 ◽  
Keyword(s):  
Stability Analysis ◽  
Shear Layer ◽  
Turbulent Mixing ◽  
Large Scale ◽  
Shear Flows ◽  
Time Dependent ◽  
Turbulent Shear ◽  
Large Scale Structures ◽  
Turbulent Shear Flows ◽  
Scale Structures

For over a quarter of a century it has been recognized that turbulent shear flows are dominated by large-scale structures. Yet the majority of models for turbulent mixing fail to include the properties of the structures either explicitly or implicitly. The results obtained using these models may appear to be satisfactory, when compared with experimental observations, but in general these models require the inclusion of empirical constants, which render the predictions only as good as the empirical database used in the determination of such constants. Existing models of turbulence also fail to provide, apart from its stochastic properties, a description of the time-dependent properties of a turbulent shear flow and its development. In this paper we introduce a model for the large-scale structures in a turbulent shear layer. Although, with certain reservations, the model is applicable to most turbulent shear flows, we restrict ourselves here to the consideration of turbulent mixing in a two-stream compressible shear layer. Two models are developed for this case that describe the influence of the large-scale motions on the turbulent mixing process. The first model simulates the average behaviour by calculating the development of the part of the turbulence spectrum related to the large-scale structures in the flow. The second model simulates the passage of a single train of large-scale structures, thereby modelling a significant part of the time-dependent features of the turbulent flow. In both these treatments the large-scale structures are described by a superposition of instability waves. The local properties of these waves are determined from linear, inviscid, stability analysis. The streamwise development of the mean flow, which includes the amplitude distribution of these instability waves, is determined from an energy integral analysis. The models contain no empirical constants. Predictions are made for the effects of freestream velocity and density ratio as well as freestream Mach number on the growth of the mixing layer. The predictions agree very well with experimental observations. Calculations are also made for the time-dependent motion of the turbulent shear layer in the form of streaklines that agree qualitatively with observation. For some other turbulent shear flows the dominant structure of the large eddies can be obtained similarly using linear stability analysis and a partial justification for this procedure is given in the Appendix. In wall-bounded flows a preliminary analysis indicates that a linear, viscous, stability analysis must be extended to second order to derive the most unstable waves and their subsequent development. The extension of the present model to such cases and the inclusion of the effects of chemical reactions in the models are also discussed.

Sign in / Sign up

Export Citation Format

Share Document