Erosion of upland hillslope soil organic carbon: Coupling field measurements with a sediment transport model

2005 ◽  
Vol 19 (3) ◽  
Author(s):  
Kyungsoo Yoo ◽  
Ronald Amundson ◽  
Arjun M. Heimsath ◽  
William E. Dietrich
Keyword(s):  
Sediment Transport ◽  
Organic Carbon ◽  
Soil Organic Carbon ◽  
Transport Model ◽  
Field Measurements ◽  
Coupling Field ◽  
Sediment Transport Model

scholarly journals SEDIMENT TRANSPORT FIELD DATA AND NUMERICAL MODELING STUDY TO SUPPORT DREDGE PIT INFILL RATE ESTIMATES

2020 ◽  
pp. 57
Author(s):  
Atilla Bayram ◽  
Sean O'Neil ◽  
Yang Zhang
Keyword(s):  
Sediment Transport ◽  
Suspended Sediment ◽  
Field Data ◽  
Transport Model ◽  
Phase 1 ◽  
Field Measurements ◽  
Suspended Load ◽  
Suspended Sediment Transport ◽  
Sediment Transport Model ◽  
Project Site

Site specific bedload and suspended sediment transport data collected at two test pit locations over a four-day period during April 2015 were analyzed to calibrate a numerical sediment transport model of Cook Inlet, AK. The field data campaign was designed to collect suspended load and bedload field measurements and was carried out in two phases. During Phase 1, both suspended load and bedload measurements were taken at approximately 55 ft water depth. The suspended sediment concentration was observed to be nearly uniform over the water column. Laboratory analysis showed the suspended sediment had an effective grain size of approximately 0.03 mm with 0.005 mm within a 95percent confidence interval. During Phase 2, hydrodynamic, suspended load and bedload measurements were collected over four tidal cycles in the surfzone. A two-dimensional sediment transport model was developed to simulate sediment transport infill rates at the dredged areas of the Project site. The model was calibrated by comparing measured suspended load measurements made at two offshore locations. Calibration results showed that the suspended load transport rate, which is the dominant sediment transport regime in the area, can be predicted accurately at the project site. Based on the calibrated sediment transport model, preliminary annual sediment infill rates were estimated to lie between 1.1 to 1.6 ft/yr at offshore and nearshore locations, respectively, for the presently observed and measured conditions.

scholarly journals Sediment Transport and Water Flow Resistance in Alluvial River Channels: Modified Model of Transport of Non-Uniform Grain-Size Sediments

Water ◽  
2021 ◽  
Vol 13 (15) ◽  
pp. 2038
Author(s):  
Gennady Gladkov ◽  
Michał Habel ◽  
Zygmunt Babiński ◽  
Pakhom Belyakov
Keyword(s):  
Sediment Transport ◽  
Water Flow ◽  
Transport Model ◽  
Flow Characteristics ◽  
Field Measurements ◽  
Field Investigation ◽  
Empirical Modeling ◽  
River Channels ◽  
Channel Deformations ◽  
East European

The paper presents recommendations for using the results obtained in sediment transport simulation and modeling of channel deformations in rivers. This work relates to the issues of empirical modeling of the water flow characteristics in natural riverbeds with a movable bottom (alluvial channels) which are extremely complex. The study shows that in the simulation of sediment transport and calculation of channel deformations in the rivers, it is expedient to use the calculation dependences of Chézy’s coefficient for assessing the roughness of the bottom sediment mixture, or the dependences of the form based on the field investigation data. Three models are most commonly used and based on the original formulas of Meyer-Peter and Müller (1948), Einstein (1950) and van Rijn (1984). This work deals with assessing the hydraulic resistance of the channel and improving the river sediment transport model in a simulation of riverbed transformation on the basis of previous research to verify it based on 296 field measurements on the Central-East European lowland rivers. The performed test calculations show that the modified van Rijn formula gives the best results from all the considered variants.

Sign in / Sign up

Export Citation Format

Share Document