scholarly journals Are inter-model differences in AMIP-II near surface air temperature means and extremes explained by land surface energy balance complexity?

2004 ◽  
Vol 31 (5) ◽  
pp. n/a-n/a ◽  
Author(s):  
A. J. Pitman ◽  
B. J. McAvaney ◽  
N. Bagnoud ◽  
B. Cheminat
Keyword(s):  
Energy Balance ◽  
Surface Energy ◽  
Air Temperature ◽  
Land Surface ◽  
Surface Energy Balance ◽  
Surface Air Temperature ◽  
Near Surface

An improved representation of the land surface temperature including the effects of vegetation in the COSMO model

2020 ◽  
Author(s):  
Jan-Peter Schulz ◽  
Gerd Vogel
Keyword(s):  
Energy Balance ◽  
Surface Energy ◽  
Surface Temperature ◽  
Land Surface ◽  
Surface Energy Balance ◽  
Heat Fluxes ◽  
Surface Processes ◽  
Atmospheric Models ◽  
Land Surface Processes ◽  
Near Surface

<p>Land surface processes have a significant impact on near-surface atmospheric phenomena. They determine, among others, near-surface sensible and latent heat fluxes and the radiation budget, and thus influence atmosphere and land characteristics, such as temperature and humidity, the structure of the planetary boundary layer, and even cloud formation processes. It is therefore important to simulate the land surface processes in atmospheric models as realistically as possible.</p><p>Verifications have shown that the amplitude of the diurnal cycle of the surface temperature simulated by the land surface scheme TERRA of the COSMO atmospheric model is systematically underestimated. In contrast, the diurnal cycles of the temperatures in the soil are overestimated, instead. This means that the other components of the surface energy balance are biased as well, for instance, the surface turbulent heat fluxes or the ground heat flux.</p><p>Data from the Meteorological Observatory Lindenberg of the German Meteorological Service (DWD) were used to analyse this model behaviour. In the standard model configuration of TERRA, there is no representation of the vegetation in the surface energy balance. This means, there is no energy budget including a temperature for the vegetation layer. Furthermore, the insulating effects by the vegetation at the sub-canopy level are missing as well. In this work, a scheme providing both of these missing model characteristics was implemented in TERRA. As a result, the simulated diurnal amplitude of the surface temperature is increased and the one of the soil temperature is reduced, both leading to better agreements with the measurements. These improvements are found in TERRA in offline mode, using Lindenberg observations, as well as in coupled mode in the atmospheric models of DWD, i.e. the limited-area COSMO model and the global ICON model.</p>

scholarly journals Evaluation and Comparison of Noah and Pleim–Xiu Land Surface Models in MM5 Using GÖTE2001 Data: Spatial and Temporal Variations in Near-Surface Air Temperature

2007 ◽  
Vol 46 (10) ◽  
pp. 1587-1605 ◽  
Author(s):  
J-F. Miao ◽  
D. Chen ◽  
K. Borne
Keyword(s):  
Soil Moisture ◽  
Air Temperature ◽  
Land Surface ◽  
Model Performance ◽  
Surface Air Temperature ◽  
Near Surface ◽  
Surface Models ◽  
Urban Heat ◽  
Soil Moisture Initialization ◽  
Evident Difference

Abstract In this study, the performance of two advanced land surface models (LSMs; Noah LSM and Pleim–Xiu LSM) coupled with the fifth-generation Pennsylvania State University–National Center for Atmospheric Research Mesoscale Model (MM5), version 3.7.2, in simulating the near-surface air temperature in the greater Göteborg area in Sweden is evaluated and compared using the GÖTE2001 field campaign data. Further, the effects of different planetary boundary layer schemes [Eta and Medium-Range Forecast (MRF) PBLs] for Noah LSM and soil moisture initialization approaches for Pleim–Xiu LSM are investigated. The investigation focuses on the evaluation and comparison of diurnal cycle intensity and maximum and minimum temperatures, as well as the urban heat island during the daytime and nighttime under the clear-sky and cloudy/rainy weather conditions for different experimental schemes. The results indicate that 1) there is an evident difference between Noah LSM and Pleim–Xiu LSM in simulating the near-surface air temperature, especially in the modeled urban heat island; 2) there is no evident difference in the model performance between the Eta PBL and MRF PBL coupled with the Noah LSM; and 3) soil moisture initialization is of crucial importance for model performance in the Pleim–Xiu LSM. In addition, owing to the recent release of MM5, version 3.7.3, some experiments done with version 3.7.2 were repeated to reveal the effects of the modifications in the Noah LSM and Pleim–Xiu LSM. The modification to longwave radiation parameterizations in Noah LSM significantly improves model performance while the adjustment of emissivity, one of the vegetation properties, affects Pleim–Xiu LSM performance to a larger extent. The study suggests that improvements both in Noah LSM physics and in Pleim–Xiu LSM initialization of soil moisture and parameterization of vegetation properties are important.

Estimation of Evapotranspiration using Remote Sensing and Surface Energy Balance Algorithm for Land (SEBAL) in Canal Command

2021 ◽  
Vol 58 (03) ◽  
pp. 274-285
Author(s):  
H. V. Parmar ◽  
N. K. Gontia
Keyword(s):  
Remote Sensing ◽  
Energy Balance ◽  
Surface Energy ◽  
Land Surface ◽  
Surface Energy Balance ◽  
Crop Growth ◽  
Growth Stages ◽  
Landsat 8 ◽  
Surface Temperatures ◽  
Canal Command

Remote sensing based various land surface and bio-physical variables like Normalized Difference Vegetation Index (NDVI), Land Surface Temperature (LST), surface albedo, transmittance and surface emissivity are useful for the estimation of spatio-temporal variations in evapotranspiration (ET) using Surface Energy Balance Algorithm for Land (SEBAL) method. These variables were estimated under the present study for Ozat-II canal command in Junagadh district, Gujarat, India, using Landsat-7 and Landsat-8 images of summer season of years 2014 and 2015. The derived parameters were used in SEBAL to estimate the Actual Evapotranspiration (AET) of groundnut and sesame crops. The lower values NDVI observed during initial (March) and end (May) stages of crop growth indicated low vegetation cover during these periods. With full canopy coverage of the crops, higher value of NDVI (0.90) was observed during the mid-crop growth stage. The remote sensing-based LST was lower for agricultural areas and the area near banks of the canal and Ozat River, while higher surface temperatures were observed for rural settlements, road and areas with exposed dry soil. The maximum surface temperatures in the cropland were observed as 311.0 K during March 25, 2014 and 315.8 K during May 31, 2015. The AET of summer groundnut increased from 3.75 to 7.38 mm.day-1, and then decreased to 3.99 mm.day-1 towards the end stage of crop growth. The daily AET of summer sesame ranged from 1.06 to 7.72 mm.day-1 over different crop growth stages. The seasonal AET of groundnut and sesame worked out to 358.19 mm and 346.31 mm, respectively. The estimated AET would be helpful to schedule irrigation in the large canal command.

scholarly journals Snow specific surface area simulation using the one-layer snow model in the Canadian LAnd Surface Scheme (CLASS)

2013 ◽  
Vol 7 (3) ◽  
pp. 961-975 ◽  
Author(s):  
A. Roy ◽  
A. Royer ◽  
B. Montpetit ◽  
P. A. Bartlett ◽  
A. Langlois
Keyword(s):  
Energy Balance ◽  
Surface Energy ◽  
Liquid Water ◽  
Land Surface ◽  
Surface Energy Balance ◽  
Liquid Water Content ◽  
Canadian Land Surface Scheme ◽  
Snow Model ◽  
Surface Scheme ◽  
The One

Abstract. Snow grain size is a key parameter for modeling microwave snow emission properties and the surface energy balance because of its influence on the snow albedo, thermal conductivity and diffusivity. A model of the specific surface area (SSA) of snow was implemented in the one-layer snow model in the Canadian LAnd Surface Scheme (CLASS) version 3.4. This offline multilayer model (CLASS-SSA) simulates the decrease of SSA based on snow age, snow temperature and the temperature gradient under dry snow conditions, while it considers the liquid water content of the snowpack for wet snow metamorphism. We compare the model with ground-based measurements from several sites (alpine, arctic and subarctic) with different types of snow. The model provides simulated SSA in good agreement with measurements with an overall point-to-point comparison RMSE of 8.0 m2 kg–1, and a root mean square error (RMSE) of 5.1 m2 kg–1 for the snowpack average SSA. The model, however, is limited under wet conditions due to the single-layer nature of the CLASS model, leading to a single liquid water content value for the whole snowpack. The SSA simulations are of great interest for satellite passive microwave brightness temperature assimilations, snow mass balance retrievals and surface energy balance calculations with associated climate feedbacks.

scholarly journals Near–surface air temperature and snow skin temperature comparison from CREST-SAFE station data with MODIS land surface temperature data

2015 ◽  
Vol 12 (8) ◽  
pp. 7665-7687 ◽  
Author(s):  
C. L. Pérez Díaz ◽  
T. Lakhankar ◽  
P. Romanov ◽  
J. Muñoz ◽  
R. Khanbilvardi ◽  
...  
Keyword(s):  
Surface Temperature ◽  
Skin Temperature ◽  
Air Temperature ◽  
Land Surface Temperature ◽  
Land Surface ◽  
Hydrological Cycle ◽  
Critical Role ◽  
Surface Air Temperature ◽  
Balance Model ◽  
Near Surface

Abstract. Land Surface Temperature (LST) is a key variable (commonly studied to understand the hydrological cycle) that helps drive the energy balance and water exchange between the Earth's surface and its atmosphere. One observable constituent of much importance in the land surface water balance model is snow. Snow cover plays a critical role in the regional to global scale hydrological cycle because rain-on-snow with warm air temperatures accelerates rapid snow-melt, which is responsible for the majority of the spring floods. Accurate information on near-surface air temperature (T-air) and snow skin temperature (T-skin) helps us comprehend the energy and water balances in the Earth's hydrological cycle. T-skin is critical in estimating latent and sensible heat fluxes over snow covered areas because incoming and outgoing radiation fluxes from the snow mass and the air temperature above make it different from the average snowpack temperature. This study investigates the correlation between MODerate resolution Imaging Spectroradiometer (MODIS) LST data and observed T-air and T-skin data from NOAA-CREST-Snow Analysis and Field Experiment (CREST-SAFE) for the winters of 2013 and 2014. LST satellite validation is imperative because high-latitude regions are significantly affected by climate warming and there is a need to aid existing meteorological station networks with the spatially continuous measurements provided by satellites. Results indicate that near-surface air temperature correlates better than snow skin temperature with MODIS LST data. Additional findings show that there is a negative trend demonstrating that the air minus snow skin temperature difference is inversely proportional to cloud cover. To a lesser extent, it will be examined whether the surface properties at the site are representative for the LST properties within the instrument field of view.

Sign in / Sign up

Export Citation Format

Share Document