scholarly journals Three-dimensional, prestack, plane wave migration of teleseismicP-to-Sconverted phases: 1. Theory

2003 ◽  
Vol 108 (B2) ◽  
Author(s):  
Christian Poppeliers ◽  
Gary L. Pavlis
Keyword(s):  
Plane Wave ◽  
Three Dimensional ◽  
Wave Migration

scholarly journals Effects of Central Tube on Shape of Modal Duct of a Helicoid in a Simple Expansion Chamber

2018 ◽  
Vol 2018 ◽  
pp. 1-6
Author(s):  
Daniel Omondi Onyango ◽  
Robert Kinyua ◽  
Abel Nyakundi Mayaka
Keyword(s):  
Wave Propagation ◽  
Acoustic Wave ◽  
Plane Wave ◽  
Acoustic Pressure ◽  
Three Dimensional ◽  
The Other ◽  
Expansion Chamber ◽  
Central Tube ◽  
Simple Expansion ◽  
Plane Wave Propagation

The shape of the modal duct of an acoustic wave propagating in a muffling system varies with the internal geometry. This shape can be either as a result of plane wave propagation or three-dimensional wave propagation. These shapes depict the distribution of acoustic pressure that may be used in the design or modification of mufflers to create resonance at cut-off frequencies and hence achieve noise attenuation or special effects on the output of the noise. This research compares the shapes of acoustic duct modes of two sets of four pitch configurations of a helicoid in a simple expansion chamber with and without a central tube. Models are generated using Autodesk Inventor modeling software and imported into ANSYS 18.2, where a fluid volume from the complex computer-aided-design (CAD) geometry is extracted for three-dimensional (3D) analysis. Mesh is generated to capture the details of the fluid cavity for frequency range between 0 and 2000Hz. After defining acoustic properties, acoustic boundary conditions and loads were defined at inlet and outlet ports before computation. Postprocessed acoustic results of the modal shapes and transmission loss (TL) characteristics of the two configurations were obtained and compared for geometries of the same helical pitch. It was established that whereas plane wave propagation in a simple expansion chamber (SEC) resulted in a clearly defined acoustic pressure pattern across the propagation path, the distribution in the configurations with and without the central tube depicted three-dimensional acoustic wave propagation characteristics, with patterns scattering or consolidating to regions of either very low or very high acoustic pressure differentials. A difference of about 80 decibels between the highest and lowest acoustic pressure levels was observed for the modal duct of the geometry with four turns and with a central tube. On the other hand, the shape of the TL curve shifts from a sinusoidal-shaped profile with well-defined peaks and valleys in definite multiples of π for the simple expansion chamber, while that of the other two configurations depended on the variation in wavelength that affects the location of occurrence of cut-on or cut-off frequency. The geometry with four turns and a central tube had a maximum value of TL of about 90 decibels at approximately 1900Hz.

Rigorous accounting diffraction on non-plane gratings irradiated by non-planar waves

2021 ◽  
Author(s):  
Leonid I. Goray
Keyword(s):  
Plane Wave ◽  
Wave Diffraction ◽  
Plane Waves ◽  
Three Dimensional ◽  
Integral Equation Method ◽  
Transverse Magnetic ◽  
Incident Field ◽  
Boundary Integral ◽  
Cylindrical Waves ◽  
Plane Wave Diffraction

Abstract The modified boundary integral equation method (MIM) is considered a rigorous theoretical application for the diffraction of cylindrical waves by arbitrary profiled plane gratings, as well as for the diffraction of plane/non-planar waves by concave/convex gratings. This study investigates two-dimensional (2D) diffraction problems of the filiform source electromagnetic field scattered by a plane lamellar grating and of plane waves scattered by a similar cylindrical-shaped grating. Unlike the problem of plane wave diffraction by a plane grating, the field of a localised source does not satisfy the quasi-periodicity requirement. Fourier transform is used to reduce the solution of the problem of localised source diffraction by the grating in the whole region to the solution of the problem of diffraction inside one Floquet channel. By considering the periodicity of the geometry structure, the problem of Floquet terms for the image can be formulated so that it enables the application of the MIM developed for plane wave diffraction problems. Accounting of the local structure of an incident field enables both the prediction of the corresponding efficiencies and the specification of the bounds within which the approximation of the incident field with plane waves is correct. For 2D diffraction problems of the high-conductive plane grating irradiated by cylindrical waves and the cylindrical high-conductive grating irradiated by plane waves, decompositions in sets of plane waves/sections are investigated. The application of such decomposition, including the dependence on the number of plane waves/sections and radii of the grating and wave front shape, was demonstrated for lamellar, sinusoidal and saw-tooth grating examples in the 0th & –1st orders as well as in the transverse electric and transverse magnetic polarisations. The primary effects of plane wave/section partitions of non-planar wave fronts and curved grating shapes on the exact solutions for 2D and three-dimensional (conical) diffraction problems are discussed.

scholarly journals Adaptive-multilevel BDDC algorithm for three-dimensional plane wave Helmholtz systems

2021 ◽  
Vol 381 ◽  
pp. 113011
Author(s):  
Jie Peng ◽  
Shi Shu ◽  
Junxian Wang ◽  
Liuqiang Zhong
Keyword(s):  
Plane Wave ◽  
Three Dimensional ◽  
Dimensional Plane

scholarly journals Denoising Directional Room Impulse Responses with Spatially Anisotropic Late Reverberation Tails

2020 ◽  
Vol 10 (3) ◽  
pp. 1033 ◽  
Author(s):  
Pierre Massé ◽  
Thibaut Carpentier ◽  
Olivier Warusfel ◽  
Markus Noisternig
Keyword(s):  
Plane Wave ◽  
Gaussian Noise ◽  
Three Dimensional ◽  
Microphone Arrays ◽  
Impulse Responses ◽  
Noise Floor ◽  
Surround Sound ◽  
Plane Wave Decomposition ◽  
Spherical Microphone Arrays ◽  
Wave Decomposition

Directional room impulse responses (DRIR) measured with spherical microphone arrays (SMA) enable the reproduction of room reverberation effects on three-dimensional surround-sound systems (e.g., Higher-Order Ambisonics) through multichannel convolution. However, such measurements inevitably contain a nondecaying noise floor that may produce an audible “infinite reverberation effect” upon convolution. If the late reverberation tail can be considered a diffuse field before reaching the noise floor, the latter may be removed and replaced with an extension of the exponentially-decaying tail synthesized as a zero-mean Gaussian noise. This has previously been shown to preserve the diffuse-field properties of the late reverberation tail when performed in the spherical harmonic domain (SHD). In this paper, we show that in the case of highly anisotropic yet incoherent late fields, the spatial symmetry of the spherical harmonics is not conducive to preserving the energy distribution of the reverberation tail. To remedy this, we propose denoising in an optimized spatial domain obtained by plane-wave decomposition (PWD), and demonstrate that this method equally preserves the incoherence of the late reverberation field.

3D plane-wave migration in tilted coordinates: A field data example

Geophysics ◽  
2009 ◽  
Vol 74 (6) ◽  
pp. WCA199-WCA209 ◽  
Author(s):  
Guojian Shan ◽  
Robert Clapp ◽  
Biondo Biondi
Keyword(s):  
Plane Wave ◽  
Field Data ◽  
Synthetic Data ◽  
Data Set ◽  
Wave Source ◽  
Surface Data ◽  
The One ◽  
Wave Migration ◽  
Wavefield Extrapolation ◽  
Slant Stacking

We have extended isotropic plane-wave migration in tilted coordinates to 3D anisotropic media and applied it on a Gulf of Mexico data set. Recorded surface data are transformed to plane-wave data by slant-stack processing in inline and crossline directions. The source plane wave and its corresponding slant-stacked data are extrapolated into the subsurface within a tilted coordinate system whose direction depends on the propagation direction of the plane wave. Images are generated by crosscorrelating these two wavefields. The shot sampling is sparse in the crossline direction, and the source generated by slant stacking is not really a plane-wave source but a phase-encoded source. We have discovered that phase-encoded source migration in tilted coordinates can image steep reflectors, using 2D synthetic data set examples. The field data example shows that 3D plane-wave migration in tilted coordinates can image steeply dipping salt flanks and faults, even though the one-way wave-equation operator is used for wavefield extrapolation.

The impact of reciprocity on prestack source plane wave migration

2004 ◽  
Author(s):  
Faqi Liu ◽  
Dan N. Whitmore ◽  
Douglas W. Hanson ◽  
Richard S. Day ◽  
Chuck C. Mosher
Keyword(s):  
Plane Wave ◽  
Source Plane ◽  
Wave Migration ◽  
The Impact

3D plane‐wave migration in tilted coordinates

2007 ◽  
Author(s):  
Guojian Shan ◽  
Robert Clappand ◽  
Biondo Biondi
Keyword(s):  
Plane Wave ◽  
Wave Migration

Efficient Plane Wave Excitation for 3-D Laguerre-Based FDTD Method

2014 ◽  
Vol 556-562 ◽  
pp. 4542-4546
Author(s):  
Zheng Chen ◽  
Yan Tao Duan ◽  
Ye Rong Zhang ◽  
Cheng Gao
Keyword(s):  
Plane Wave ◽  
Electric Fields ◽  
Laguerre Polynomials ◽  
Fdtd Method ◽  
Three Dimensional ◽  
Field Variable ◽  
Wave Excitation ◽  
Computationally Efficient ◽  
Scattering Problems ◽  
Scatter Field

In the three-dimensional (3-D) Laguerre-based finite-difference time-domain method, each electric field variable has the relationship with the adjacent twelve electric fields. This results in the tedious modification of field components adjacent to the total-field/scatter-field boundary in analyzing scattering problems. In addition, the plane wave excitation requires much time in evaluating the expansion coefficient of incident field which involves integral of the weighted Laguerre polynomials with respect to time. In this letter, the plane wave is introduced by defining a set of equivalent currents on a closed Huygen's surface and a computationally efficient one-dimensional auxiliary propagator is presented to speed up the plane wave excitation. Numerical results indicated that the proposed method is valid.

Sign in / Sign up

Export Citation Format

Share Document