scholarly journals In-Situ Growing CdS Single-Crystal Nanorods via P3HT Polymer as a Soft Template for Enhancing Photovoltaic Performance

2009 ◽  
Vol 42 (17) ◽  
pp. 6558-6563 ◽  
Author(s):  
Hung-Chou Liao ◽  
San-Yuan Chen ◽  
Dean-Mo Liu
Keyword(s):  
Single Crystal ◽  
Photovoltaic Performance ◽  
Soft Template

Structure of Palladium Single-Crystal Films Prepared by Flash Evaporation onto (001) NaCl Substrates

1970 ◽  
Vol 28 ◽  
pp. 456-457
Author(s):  
L. E. Murr ◽  
G. Wong
Keyword(s):  
Single Crystal ◽  
High Vacuum ◽  
Ultra High Vacuum ◽  
High Rate ◽  
Flash Evaporation ◽  
Optimum Load ◽  
Single Crystal Films ◽  
Crystal Films ◽  
A Current

Palladium single-crystal films have been prepared by Matthews in ultra-high vacuum by evaporation onto (001) NaCl substrates cleaved in-situ, and maintained at ∼ 350° C. Murr has also produced large-grained and single-crystal Pd films by high-rate evaporation onto (001) NaCl air-cleaved substrates at 350°C. In the present work, very large (∼ 3cm2), continuous single-crystal films of Pd have been prepared by flash evaporation onto air-cleaved (001) NaCl substrates at temperatures at or below 250°C. Evaporation rates estimated to be ≧ 2000 Å/sec, were obtained by effectively short-circuiting 1 mil tungsten evaporation boats in a self-regulating system which maintained an optimum load current of approximately 90 amperes; corresponding to a current density through the boat of ∼ 4 × 104 amperes/cm2.

Single Crystal Growth of High-Pressure Phases of Ice and Salt Hydrate Far Below the Original Melting Point by Mixing Alcohol: Crystal Structure Determination of Magnesium Chloride Heptahydrate

2020 ◽  
Author(s):  
Keishiro Yamashita ◽  
Kazuki Komatsu ◽  
Hiroyuki Kagi
Keyword(s):  
Crystal Structure ◽  
High Pressure ◽  
Crystal Growth ◽  
Single Crystal ◽  
Room Temperature ◽  
Growth Technique ◽  
Salt Hydrate ◽  
X Ray

An crystal-growth technique for single crystal x-ray structure analysis of high-pressure forms of hydrogen-bonded crystals is proposed. We used alcohol mixture (methanol: ethanol = 4:1 in volumetric ratio), which is a widely used pressure transmitting medium, inhibiting the nucleation and growth of unwanted crystals. In this paper, two kinds of single crystals which have not been obtained using a conventional experimental technique were obtained using this technique: ice VI at 1.99 GPa and MgCl<sub>2</sub>·7H<sub>2</sub>O at 2.50 GPa at room temperature. Here we first report the crystal structure of MgCl2·7H2O. This technique simultaneously meets the requirement of hydrostaticity for high-pressure experiments and has feasibility for further in-situ measurements.

Laser damage mechanism and in-situ observation of stacking fault relaxation in β-Ga2O3 single crystal by EFG method

CrystEngComm ◽  
2021 ◽  
Author(s):  
Bo Fu ◽  
Gaohang He ◽  
Wenxiang Mu ◽  
Yang Li ◽  
Boyuan Feng ◽  
...  
Keyword(s):  
Single Crystal ◽  
Light Field ◽  
Damage Mechanism ◽  
Stacking Fault ◽  
High Light ◽  
Laser Damage ◽  
In Situ Observation ◽  
Structure Destruction

We designed an original and effective method to study the laser damage mechanism of β-Ga2O3 single crystal grown by edge-defined film-fed growth (EFG). The structure destruction under high light field...

In-situ X-ray tomography investigation of pore damage effects during a tensile test of a Ni-based single crystal superalloy

2021 ◽  
pp. 111180
Author(s):  
Keli Liu ◽  
Junsheng Wang ◽  
Bing Wang ◽  
Pengcheng Mao ◽  
Yanhong Yang ◽  
...  
Keyword(s):  
Tensile Test ◽  
Single Crystal ◽  
Single Crystal Superalloy ◽  
X Ray

scholarly journals Crack Propagation Behavior of a Ni-Based Single-Crystal Superalloy during In Situ SEM Tensile Test at 1000 °C

Crystals ◽  
2020 ◽  
Vol 10 (11) ◽  
pp. 1047
Author(s):  
Wenxiang Jiang ◽  
Xiaoyi Ren ◽  
Jinghao Zhao ◽  
Jianli Zhou ◽  
Jinyao Ma ◽  
...  
Keyword(s):  
Crack Propagation ◽  
Tensile Test ◽  
Single Crystal ◽  
Crack Propagation Rate ◽  
Propagation Rate ◽  
Single Crystal Superalloy ◽  
Propagation Path ◽  
Propagation Behavior ◽  
Crack Propagation Behavior

An in situ scanning electron microscope (SEM) tensile test for Ni-based single-crystal superalloy was carried out at 1000 °C. The stress displacement was obtained, and the yield strength and tensile strength of the superalloy were 699 MPa and 826 MPa, respectively. The crack propagation process, consisting of Model I crack and crystallographic shearing crack, was determined. More interestingly, the crack propagation path and rate affected by eutectics was directly observed and counted. Results show that the coalescence of the primary crack and second microcrack at the interface of a γ/γ′ matrix and eutectics would make the crack propagation rate increase from 0.3 μm/s to 0.4 μm/s. On the other hand, crack deflection decreased the rate to 0.05 μm/s. Moreover, movement of dislocations in front of the crack was also analyzed to explain the different crack propagation behavior in the superalloy.

On The Optimized Nucleation of Near-Single-Crystal Cvd Diamond Film

1995 ◽  
Vol 416 ◽  
Author(s):  
L. C. Chen ◽  
C. C. Juan ◽  
J. Y. Wu ◽  
K. H. Chen ◽  
J. W. Teng
Keyword(s):  
Single Crystal ◽  
Photoelectron Spectroscopy ◽  
Morphological Evolution ◽  
Present Report ◽  
Ex Situ ◽  
Nucleation Density ◽  
Induced Current ◽  
Current Time ◽  
Single Crystal Diamond

ABSTRACTNear-single-crystal diamond films have been obtained in a number of laboratories recently. The optimization of nucleation density by using a bias-enhanced nucleation (BEN) method is believed to be a critical step. However, the condition of optimized nucleation has never been clearly delineated. In the present report, a novel quantitative technique was established to monitor the nucleation of diamond in-situ. Specifically, the induced current was measured as a function of nucleation time during BEN. The timedependence of induced current was studied under various methane concentrations as well as substrate temperatures. The optimized nucleation condition can be unambiguously determined from the current-time plot. Besides the in-situ current probe, ex-situ x-ray photoelectron spectroscopy (XPS) and atomic force microscopy (AFM) were also used to investigate the chemical and morphological evolution. Characteristic XPS and AFM features of optimized nucleation is discussed.

In situ synthesis of mesoporous C-doped TiO 2 single crystal with oxygen vacancy and its enhanced sunlight photocatalytic properties

2017 ◽  
Vol 144 ◽  
pp. 203-211 ◽  
Author(s):  
Jing Lu ◽  
Yong Wang ◽  
Jianfeng Huang ◽  
Jie Fei ◽  
Liyun Cao ◽  
...  
Keyword(s):  
Oxygen Vacancy ◽  
Single Crystal ◽  
In Situ Synthesis ◽  
Photocatalytic Properties

scholarly journals Voltammetry and molecular assembly of G-quadruplex DNAzyme on single-crystal Au(111)-electrode surfaces – hemin as an electrochemical intercalator

2016 ◽  
Vol 193 ◽  
pp. 99-112 ◽  
Author(s):  
Ling Zhang ◽  
Jens Ulstrup ◽  
Jingdong Zhang
Keyword(s):  
Single Crystal ◽  
Single Molecule ◽  
Electrode Surface ◽  
Molecular Assembly ◽  
Electrode Surfaces ◽  
Potential Control ◽  
G Quadruplex ◽  
Tunnelling Microscopy ◽  
Dna Quadruplexes

DNA quadruplexes (qs) are a class of “non-canonical” oligonucleotides (OGNs) composed of stacked guanine (G) quartets stabilized by specific cations. Metal porphyrins selectively bind to G-qs complexes to form what is known as DNAzyme, which can exhibit peroxidase and other catalytic activity similar to heme group metalloenzymes. In the present study we investigate the electrochemical properties and the structure of DNAzyme monolayers on single-crystal Au(111)-electrode surfaces using cyclic voltammetry and scanning tunnelling microscopy under electrochemical potential control (in situ STM). The target DNAzyme is formed from a single-strand OGN with 12 guanines and iron(iii) porphyrin IX (hemin), and assembles on Au(111) through a mercapto alkyl linker. The DNAzyme monolayers exhibit a strong pair of redox peaks at 0.0 V (NHE) at pH 7 in acetate buffer, shifted positively by about 50 mV compared to free hemin weakly physisorbed on the Au(111)-electrode surface. The voltammetric hemin signal of DNAzyme is enhanced 15 times compared with that of hemin adsorbed directly on the Au(111)-electrode surface. This is indicative of both the formation of a close to dense DNAzyme monolayer and that hemin is strongly bound to the immobilized 12G-qs in well-defined orientation favorable for interfacial ET with a rate constant of 6.0 ± 0.4 s−1. This is supported by in situ STM which discloses single-molecule G-quartet structures with a size of 1.6 ± 0.2 nm.

Sign in / Sign up

Export Citation Format

Share Document