Adsorption of Atmospheric Gases at the Air−Water Interface. 2. C1−C4Alcohols, Acids, and Acetone

1999 ◽  
Vol 103 (7) ◽  
pp. 871-876 ◽  
Author(s):  
D. J. Donaldson ◽  
Darren Anderson
Keyword(s):  
Water Interface ◽  
Atmospheric Gases ◽  
Air Water Interface

scholarly journals Direct numerical simulation of gas transfer across the air–water interface driven by buoyant convection

2015 ◽  
Vol 787 ◽  
pp. 508-540 ◽  
Author(s):  
J. G. Wissink ◽  
H. Herlina
Keyword(s):  
Cold Water ◽  
Scaling Law ◽  
Numerical Code ◽  
Gas Transfer ◽  
Water Interface ◽  
Atmospheric Gases ◽  
Velocity Fluctuations ◽  
Air Water Interface ◽  
Schmidt Numbers ◽  
Time Accuracy

A series of direct numerical simulations of mass transfer across the air–water interface driven by buoyancy-induced convection have been carried out to elucidate the physical mechanisms that play a role in the transfer of heat and atmospheric gases. The buoyant instability is caused by the presence of a thin layer of cold water situated on top of a body of warm water. In time, heat and atmospheric gases diffuse into the uppermost part of the thermal boundary layer and are subsequently transported down into the bulk by falling sheets and plumes of cold water. Using a specifically designed numerical code for the discretization of scalar convection and diffusion, it was possible to accurately resolve this buoyant-instability-induced transport of atmospheric gases into the bulk at a realistic Prandtl number ($\mathit{Pr}=6$) and Schmidt numbers ranging from$\mathit{Sc}=20$to$\mathit{Sc}=500$. The simulations presented here provided a detailed insight into instantaneous gas transfer processes. The falling plumes with highly gas-saturated fluid in their core were found to penetrate deep inside the bulk. With an initial temperature difference between the water surface and the bulk of slightly above$2$ K, peaks in the instantaneous heat flux in excess of$1600~\text{W}~\text{m}^{-2}$were observed, proving the potential effectiveness of buoyant-convective heat and gas transfer. Furthermore, the validity of the scaling law for the ratio of gas and heat transfer velocities$K_{L}/H_{L}\propto (\mathit{Pr}/\mathit{Sc})^{0.5}$for the entire range of Schmidt numbers considered was confirmed. A good time-accurate approximation of$K_{L}$was found using surface information such as velocity fluctuations and convection cell size or surface divergence. A reasonable time accuracy for the$K_{L}$estimation was obtained using the horizontal integral length scale and the root mean square of the horizontal velocity fluctuations in the upper part of the bulk.

Adsorption of Atmospheric Gases at the Air−Water Interface. 3:  Methylamines

2000 ◽  
Vol 104 (46) ◽  
pp. 10789-10793 ◽  
Author(s):  
Baagi T. Mmereki ◽  
Janice M. Hicks ◽  
D. J. Donaldson
Keyword(s):  
Water Interface ◽  
Atmospheric Gases ◽  
Air Water Interface

Sampling and analysis of the air-water interface with SEM and EDS of microlayers

1989 ◽  
Vol 47 ◽  
pp. 1004-1005
Author(s):  
Randall W. Smith ◽  
John Dash
Keyword(s):  
Heavy Metals ◽  
Surface Microlayer ◽  
Surface Films ◽  
Water Interface ◽  
Physical Processes ◽  
Infrared Spectroscopic Analysis ◽  
Eds Analysis ◽  
Air Water Interface ◽  
Significant Area ◽  
Bulk Chemical

The structure of the air-water interface forms a boundary layer that involves biological ,chemical geological and physical processes in its formation. Freshwater and sea surface microlayers form at the air-water interface and include a diverse assemblage of organic matter, detritus, microorganisms, plankton and heavy metals. The sampling of microlayers and the examination of components is presently a significant area of study because of the input of anthropogenic materials and their accumulation at the air-water interface. The neustonic organisms present in this environment may be sensitive to the toxic components of these inputs. Hardy reports that over 20 different methods have been developed for sampling of microlayers, primarily for bulk chemical analysis. We report here the examination of microlayer films for the documentation of structure and composition.Baier and Gucinski reported the use of Langmuir-Blogett films obtained on germanium prisms for infrared spectroscopic analysis (IR-ATR) of components. The sampling of microlayers has been done by collecting fi1ms on glass plates and teflon drums, We found that microlayers could be collected on 11 mm glass cover slips by pulling a Langmuir-Blogett film from a surface microlayer. Comparative collections were made on methylcel1ulose filter pads. The films could be air-dried or preserved in Lugol's Iodine Several slicks or surface films were sampled in September, 1987 in Chesapeake Bay, Maryland and in August, 1988 in Sequim Bay, Washington, For glass coverslips the films were air-dried, mounted on SEM pegs, ringed with colloidal silver, and sputter coated with Au-Pd, The Langmuir-Blogett film technique maintained the structure of the microlayer intact for examination, SEM observation and EDS analysis were then used to determine organisms and relative concentrations of heavy metals, using a Link AN 10000 EDS system with an ISI SS40 SEM unit. Typical heavy microlayer films are shown in Figure 3.

Temperature Dependence of the Air/Water Interface Revealed by Polarization Sensitive Sum-Frequency Generation Spectroscopy

2018 ◽  
Author(s):  
Daniel R. Moberg ◽  
Shelby C. Straight ◽  
Francesco Paesani
Keyword(s):  
Temperature Dependence ◽  
Low Frequency ◽  
Potential Energy Function ◽  
Md Simulations ◽  
Sum Frequency Generation ◽  
Water Molecules ◽  
Water Interface ◽  
Sum Frequency ◽  
Air Water Interface ◽  
Frequency Generation

<div> <div> <div> <p>The temperature dependence of the vibrational sum-frequency generation (vSFG) spectra of the the air/water interface is investigated using many-body molecular dynamics (MB-MD) simulations performed with the MB-pol potential energy function. The total vSFG spectra calculated for different polarization combinations are then analyzed in terms of molecular auto-correlation and cross-correlation contributions. To provide molecular-level insights into interfacial hydrogen-bonding topologies, which give rise to specific spectroscopic features, the vSFG spectra are further investigated by separating contributions associated with water molecules donating 0, 1, or 2 hydrogen bonds to neighboring water molecules. This analysis suggests that the low frequency shoulder of the free OH peak which appears at ∼3600 cm−1 is primarily due to intermolecular couplings between both singly and doubly hydrogen-bonded molecules. </p> </div> </div> </div>

Sign in / Sign up

Export Citation Format

Share Document