Conformational Properties of Nickel(II) Octaethylporphyrin in Solution. 1. Resonance Excitation Profiles and Temperature Dependence of Structure-Sensitive Raman Lines

1996 ◽  
Vol 100 (33) ◽  
pp. 14184-14191 ◽  
Author(s):  
Walter Jentzen ◽  
Esko Unger ◽  
Gerasimos Karvounis ◽  
John A. Shelnutt ◽  
Wolfgang Dreybrodt ◽  
...  
Keyword(s):  
Temperature Dependence ◽  
Resonance Excitation ◽  
Structure Sensitive ◽  
Conformational Properties

Temperature Dependence of the Critical Electron Dose for Fatty Acid Monolayers

1982 ◽  
Vol 40 ◽  
pp. 78-79
Author(s):  
Kenneth H. Downing ◽  
Robert M. Glaeser
Keyword(s):  
Electron Beam ◽  
Fatty Acid ◽  
Inelastic Scattering ◽  
Temperature Dependence ◽  
Structural Damage ◽  
Direct Result ◽  
Second Step ◽  
Strong Temperature Dependence ◽  
Electron Dose ◽  
Covalent Bonds

The structural damage of molecules irradiated by electrons is generally considered to occur in two steps. The direct result of inelastic scattering events is the disruption of covalent bonds. Following changes in bond structure, movement of the constituent atoms produces permanent distortions of the molecules. Since at least the second step should show a strong temperature dependence, it was to be expected that cooling a specimen should extend its lifetime in the electron beam. This result has been found in a large number of experiments, but the degree to which cooling the specimen enhances its resistance to radiation damage has been found to vary widely with specimen types.

Temperature Dependence of Magnetic Domains and Wall Structures

1972 ◽  
Vol 30 ◽  
pp. 496-497
Author(s):  
Sonoko Tsukahara ◽  
Tadami Taoka ◽  
Hisao Nishizawa
Keyword(s):  
Temperature Dependence ◽  
Domain Walls ◽  
Magnetic Domain ◽  
Iron Film ◽  
Objective Lens ◽  
Lorentz Microscopy ◽  
Domain Structures ◽  
Wall Structures ◽  
Crystal Films ◽  
Metallurgical Structure

The high voltage Lorentz microscopy was successfully used to observe changes with temperature; of domain structures and metallurgical structures in an iron film set on the hot stage combined with a goniometer. The microscope used was the JEM-1000 EM which was operated with the objective lens current cut off to eliminate the magnetic field in the specimen position. Single crystal films with an (001) plane were prepared by the epitaxial growth of evaporated iron on a cleaved (001) plane of a rocksalt substrate. They had a uniform thickness from 1000 to 7000 Å.The figure shows the temperature dependence of magnetic domain structure with its corresponding deflection pattern and metallurgical structure observed in a 4500 Å iron film. In general, with increase of temperature, the straight domain walls decrease in their width (at 400°C), curve in an iregular shape (600°C) and then vanish (790°C). The ripple structures with cross-tie walls are observed below the Curie temperature.

Tailoring microstructures of materials through biomimetics

1993 ◽  
Vol 51 ◽  
pp. 500-501
Author(s):  
Mehmet Sarikaya ◽  
Ilhan A. Aksay
Keyword(s):  
Chemical Properties ◽  
Design And Synthesis ◽  
Structure Sensitive ◽  
Macro Scale ◽  
Methods Of Synthesis ◽  
Successive Level ◽  
Engineering Materials ◽  
Physical And Chemical ◽  
And Chemical Properties ◽  
Synthesis Of Materials

Biomimetics involves investigation of structure, function, and methods of synthesis of biological composite materials. The goal is to apply this information to the design and synthesis of materials for engineering applications.Properties of engineering materials are structure sensitive through the whole spectrum of dimensions from nanometer to macro scale. The goal in designing and processing of technological materials, therefore, is to control microstructural evolution at each of these dimensions so as to achieve predictable physical and chemical properties. Control at each successive level of dimension, however, is a major challenge as is the retention of integrity between successive levels. Engineering materials are rarely fabricated to achieve more than a few of the desired properties and the synthesis techniques usually involve high temperature or low pressure conditions that are energy inefficient and environmentally damaging.In contrast to human-made materials, organisms synthesize composites whose intricate structures are more controlled at each scale and hierarchical order.

The conformational properties of calix[4]arenes 1h NMR and molecular mechanics calculations

1989 ◽  
Vol 86 ◽  
pp. 945-954 ◽  
Author(s):  
F. Bayard ◽  
D. Decoret ◽  
D. Pattou ◽  
J. Royer ◽  
A. Satrallah ◽  
...  
Keyword(s):  
Molecular Mechanics ◽  
1H Nmr ◽  
Molecular Mechanics Calculations ◽  
Conformational Properties

Temperature dependence of generation-recombination noise in p-n junctions

2002 ◽  
Vol 12 (3) ◽  
pp. 71-74
Author(s):  
J. A. Jiménez Tejada ◽  
A. Godoy ◽  
A. Palma ◽  
P. Cartujo
Keyword(s):  
Temperature Dependence
Sign in / Sign up

Export Citation Format

Share Document