Solubility, Density, Viscosity, Electrical Conductivity, and Refractive Index of Saturated Solutions of Lithium Hydroxide in Water + Ethanol

2005 ◽  
Vol 50 (1) ◽  
pp. 187-190 ◽  
Author(s):  
Maria Elisa Taboada ◽  
Daniza M. Véliz ◽  
Héctor R. Galleguillos ◽  
Teófilo A. Graber
Agriculture ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 247
Author(s):  
Aida Albu ◽  
Cristina-Gabriela Radu-Rusu ◽  
Ioan Mircea Pop ◽  
Gabriela Frunza ◽  
Gherasim Nacu

Romania is known among the main European honey producers, due to the variety of landforms as well as the diversity of the flora. Thirty-four honey samples of the acacia, linden and multifloral types, produced in eastern Romania and collected during 2013–2018, were physico-chemically analyzed using methods provided by the national and EU standards. The results of water-insoluble solids, color and refractive index were found to be 0.023–0.131%, 0.3–76.4 mm Pfund and 1.485–1.499, respectively. The moisture content ranged between 15.20% and 20.77%, solid substances content ranged between 79.23% and 84.80% and total soluble substances content ranged between 77.83 °Brix and 83.26 °Brix. The obtained values of specific gravity were from 1.414 to 1.450 g/cm3, pH ranged from 3.673 to 5.503 and free acidity ranged between 2.4 meq and 50 meq kg−1. The ash content and the electrical conductivity varied between 0.030 and 0.543% and 130 and 679 µS cm−1, respectively. Pearsonʹs correlation analysis showed an intense association of the ash content with electrical conductivity (r = 0.81). Our findings reveal the qualitative level of Romanian honey and the variation in quality parameters due to factors such as geographical region, climatic conditions, botanical origin and handling or storage conditions.


2019 ◽  
Vol 16 (3) ◽  
pp. 0588 ◽  
Author(s):  
Al-Taa'y Et al.

       Optical properties and surface morphology of pure and doped Polystyrene films with different divalent metals of Zn, Cu and Sn and one concentration percentage have been studied. Measurements of UV-Vis spectrophotometer and AFM spectroscopy were determined. The absorbance, transmittance and reflectance spectrums were used to study different optical parameters such as absorption coefficient, refractive index, extinction coefficient and energy gap in the wavelengths rang 200-800nm. These parameters have increased in the presence of the metals. The change in the calculated values of energy gaps with doping metals content has been investigated in terms of PS matrix structural modification. The value of optical energy gap was found decreasing from 4.5eV of pure PS to reach 4.45, 4.38 and 4.32eV for Zn, Cu and Sn respectively. Measurement by AFM spectroscopy was done for two and three dimensional topographic images. From figures, the data of roughness average were 7.29, 7.31, 3.37 and 6.73nm for samples (Blank, Zn, Cu and Sn) respectively.


1991 ◽  
Vol 46 (6) ◽  
pp. 540-544
Author(s):  
Yasuhiko Iwadata ◽  
Junichi Mochinaga ◽  
Kazuo Igarashi ◽  
Koji Tajiri ◽  
Tadashi Asahina ◽  
...  

AbstractFor molten (Na, K)SCN mixtures with more than 50 mol% KSCN the molar volume Vm,electrical conductivity, χ, refractive index n, surface tension γ and heat capacity CP were measured in dependence of composition and temperature, γ exhibited the minimum at ca. 70 mol% KSCN and Cp was 148 JK-1 mol-1 in the range of 413 to 471 K. The electronic polarizabilities of the ions in the molten state were estimated by the semiclassical Clausius-Mossotti equation


2014 ◽  
Vol 59 (2) ◽  
pp. 339-345 ◽  
Author(s):  
Bernardo de Sá Costa ◽  
Edwin Elard Garcia-Rojas ◽  
Jane Sélia dos Reis Coimbra ◽  
José Antônio Teixeira ◽  
Javier Telis-Romero

2020 ◽  
Vol 85 (10) ◽  
pp. 1303-1315
Author(s):  
Biljana Djordjevic ◽  
Dragan Troter ◽  
Vlada Veljkovic ◽  
Mirjana Kijevcanin ◽  
Ivona Radovic ◽  
...  

Different deep eutectic solvents (DESs) of triethanolamine (TEOA) and oxalic acid (OA), glacial acetic acid (AA), L-(+)-lactic acid (LA), oleic acid (OLA), glycerol (G), ethylene glycol (EG), propylene glycol (PEG), choline chloride (ChCl) or 1,3-dimethylurea (DMU) were prepared and characterized regarding their physicochemical (density, viscosity, electrical conductivity, refractive index, coefficient of volume expansion, molecular volume, lattice energy and heat capacity) properties over the temperature range of 293.15?363.15 K at 101.325 kPa. For all tested DESs, the density, viscosity and refractive index decreased with rising temperature, while the electrical conductivity increased. The temperature dependence of viscosity and electrical conductivity are described by the Vogel?Tamman?Fulcher equations. The viscosity and molar conductivity, which exhibited a linear behaviour, were correlated by the fractional Walden rule. Besides, the Fourier transform infrared spectroscopy (FTIR) was used to study the functional groups of these DESs while thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC) provided the information about their stability. The tested DESs of TEOA possess desirable properties for use in various industrial processes, such as extractions, separations, chemical technology and biotechnology.


Sign in / Sign up

Export Citation Format

Share Document