Single-Crystal Lattice Filling in Connected Spaces inside 3D Networks

Author(s):  
Wei Zhang ◽  
Yucen Li ◽  
Chunjing Shi ◽  
Ruijuan Qi ◽  
Ming Hu
2014 ◽  
Vol 70 (a1) ◽  
pp. C1560-C1560
Author(s):  
Fumiko Kimura ◽  
Wataru Oshima ◽  
Hiroko Matsumoto ◽  
Hidehiro Uekusa ◽  
Kazuaki Aburaya ◽  
...  

In pharmaceutical sciences, the crystal structure is of primary importance because it influences drug efficacy. Due to difficulties of growing a large single crystal suitable for the single crystal X-ray diffraction analysis, powder diffraction method is widely used. In powder method, two-dimensional diffraction information is projected onto one dimension, which impairs the accuracy of the resulting crystal structure. To overcome this problem, we recently proposed a novel method of fabricating a magnetically oriented microcrystal array (MOMA), a composite in which microcrystals are aligned three-dimensionally in a polymer matrix. The X-ray diffraction of the MOMA is equivalent to that of the corresponding large single crystal, enabling the determination of the crystal lattice parameters and crystal structure of the embedded microcrytals.[1-3] Because we make use of the diamagnetic anisotropy of crystal, those crystals that exhibit small magnetic anisotropy do not take sufficient three-dimensional alignment. However, even for these crystals that only align uniaxially, the determination of the crystal lattice parameters can be easily made compared with the determination by powder diffraction pattern. Once these parameters are determined, crystal structure can be determined by X-ray powder diffraction method. In this paper, we demonstrate possibility of the MOMA method to assist the structure analysis through X-ray powder and single crystal diffraction methods. We applied the MOMA method to various microcrystalline powders including L-alanine, 1,3,5-triphenyl benzene, and cellobiose. The obtained MOMAs exhibited well-resolved diffraction spots, and we succeeded in determination of the crystal lattice parameters and crystal structure analysis.


2014 ◽  
Vol 70 (a1) ◽  
pp. C646-C646
Author(s):  
Oksana Danylyuk ◽  
Karolina Kedra-Krolik ◽  
Marta Worzakowska ◽  
Joanna Osypiuk-Tomasik ◽  
Vladimir Fedin

The retention of crystallinity upon desolvation of molecular crystals is not common, as the molecules are rigidly and densely packed in the crystals and the original framework usually collapses once solvent is removed from the structure. However, in rare cases the host framework remains substantially unaffected by solvent (guest) removal yielding structure with open channels or discrete lattice voids that can show permanent porosity. [1] Furthermore, sometimes happens, the desolvation process proceeds as single-crystal to single-crystal transformation resulting in distortion and sliding of the structure, changes in conformation, coordination modes and/or space group. Here we would like to present crystallographic study and thermal analysis on the dehydration process of the crystalline supramolecular complex between macrocyclic host cucurbit[6]uril and dopamine. In the solid state the 1:1 host-guest complex assembles into hexameric tubes with water-filled interior channels. Another set of water channels is created between three neighboring tubes in the crystal lattice. The crystals of such supramolecular assembly are not stable when out from mother solution and immediately start to loose water upon exposure to air. However, despite severe cracking the crystals dried in air maintained their integrity and still gave satisfactory diffraction pattern. The X-ray analysis showed significant decrease in the unit cell volume of the partially dehydrated crystals that corresponds to the liberation of some of the water molecules from the channels. Moreover, the reorganization of dopamine guest molecules has occurred in the crystal lattice as a response to the escape of water molecules from the structure. The partial dehydration and reorganization of the supramolecular framework proceeds via a single-crystal to single-crystal mechanism.


2004 ◽  
Vol 71 (5) ◽  
pp. 713-723 ◽  
Author(s):  
Hongqiang Chen ◽  
Jeffrey W. Kysar ◽  
Y. Lawrence Yao

Electron backscatter diffraction (EBSD) is used to investigate crystal lattice rotation caused by plastic deformation during high-strain rate laser shock peening in single crystal aluminum and copper sample on 110¯ and (001) surfaces. New experimental methodologies are employed which enable measurement of the in-plane lattice rotation under approximate plane-strain conditions. Crystal lattice rotation on and below the microscale laser shock peened sample surface was measured and compared with the simulation result obtained from FEM analysis, which account for single crystal plasticity. The lattice rotation measurements directly complement measurements of residual strain/stress with X-ray micro-diffraction using synchrotron light source and it also gives an indication of the extent of the plastic deformation induced by the microscale laser shock peening.


1993 ◽  
Vol 48 (7) ◽  
pp. 961-964 ◽  
Author(s):  
Otto Kumberger ◽  
Jürgen Riede ◽  
Hubert Schmidbaur

A discrete zinc bis[orotate(1—)] complex of the composition Zn(OrH)2·8 H2O has been isolated and characterized by a single-crystal X-ray structure analysis. The crystals are monoclinic, space group P21/c (No. 14), Z = 2, a = 10.884(2), b = 12.896(1), c = 6.954(1) Å, β = 98.27(1)°. The crystal lattice features hexaquo complexes of zinc, the Zn(H2O)62+ cations being associated with two hydrated OrH- ions only through hydrogen bonds. The results are relevant for applications of zinc orotates in medical treatment.


Author(s):  
Keith Veenhuizen ◽  
Courtney Au-Yeung ◽  
Dmytro Savytskyy ◽  
Sean McAnany ◽  
Daniel Nolan ◽  
...  

1997 ◽  
Vol 04 (05) ◽  
pp. 1063-1069 ◽  
Author(s):  
K. HERMANN

Many theoretical methods dealing with electronic and structural properties of single crystal surfaces rely on a convenient description of the surface and bulk periodicity at the same time. This can be achieved by using surface adapted lattice vectors [Formula: see text], where vectors [Formula: see text] define (h k l) net planes parallel to the surface while [Formula: see text] connects adjacent (h k l) net planes. For selected low index (h k l) surfaces of common crystals the construction of appropriate lattice vectors may be trivial. However, the general problem of determining a lattice basis adapted to a surface orientation which is described by Miller indices (h k l) in a general crystal lattice is more involved. In this paper we show that such bases, [Formula: see text], can be uniquely determined by linear transformations from the bulk lattice basis [Formula: see text]. The transformations depend on Miller indices (h k l) but not on the lattice type and can be quantified by number-theoretical methods. Thus, they are numerically stable and can be easily implemented in computational algorithms dealing with surfaces of most general crystals.


Sign in / Sign up

Export Citation Format

Share Document