Biodiesel Production by Esterification of Oleic Acid and Transesterification of Soybean Oil Using a New Solid Acid Catalyst Comprising 12-Tungstosilicic Acid and Zeolite Hβ

2013 ◽  
Vol 52 (38) ◽  
pp. 13637-13644 ◽  
Author(s):  
Nilesh Narkhede ◽  
Anjali Patel
Keyword(s):  
Oleic Acid ◽  
Soybean Oil ◽  
Solid Acid ◽  
Solid Acid Catalyst ◽  
Acid Catalyst ◽  
Biodiesel Production ◽  
Tungstosilicic Acid

scholarly journals The Effect of Co-solvent on Esterification of Oleic Acid Using Amberlyst 15 as Solid Acid Catalyst in Biodiesel Production

2018 ◽  
Vol 156 ◽  
pp. 03002
Author(s):  
Iwan Ridwan ◽  
Mukhtar Ghazali ◽  
Adi Kusmayadi ◽  
Resza Diwansyah Putra ◽  
Nina Marlina ◽  
...  
Keyword(s):  
Oleic Acid ◽  
Fatty Acid ◽  
Free Fatty Acid ◽  
Solid Acid ◽  
Solid Acid Catalyst ◽  
Acid Catalyst ◽  
Biodiesel Production ◽  
Molar Ratio ◽  
Amberlyst 15 ◽  
Acid Esterification

The oleic acid solubility in methanol is low due to two phase separation, and this causes a slow reaction time in biodiesel production. Tetrahydrofuran as co-solvent can decrease the interfacial surface tension between methanol and oleic acid. The objective of this study was to investigate the effect of co-solvent, methanol to oleic acid molar ratio, catalyst amount, and temperature of the reaction to the free fatty acid conversion. Oleic acid esterification was conducted by mixing oleic acid, methanol, tetrahydrofuran and Amberlyst 15 as a solid acid catalyst in a batch reactor. The Amberlyst 15 used had an exchange capacity of 2.57 meq/g. Significant free fatty acid conversion increments occur on biodiesel production using co-solvent compared without co-solvent. The highest free fatty acid conversion was obtained over methanol to the oleic acid molar ratio of 25:1, catalyst use of 10%, the co-solvent concentration of 8%, and a reaction temperature of 60°C. The highest FFA conversion was found at 28.6 %, and the steady state was reached after 60 minutes. In addition, the use of Amberlyst 15 oleic acid esterification shows an excellent performance as a solid acid catalyst. Catalytic activity was maintained after 4 times repeated use and reduced slightly in the fifth use.

Biodiesel production from esterification of oleic acid by a sulfonated magnetic solid acid catalyst

2019 ◽  
Vol 139 ◽  
pp. 688-695 ◽  
Author(s):  
Yi-Tong Wang ◽  
Xing-Xia Yang ◽  
Jie Xu ◽  
Hong-Li Wang ◽  
Zi-Bing Wang ◽  
...  
Keyword(s):  
Oleic Acid ◽  
Solid Acid ◽  
Solid Acid Catalyst ◽  
Acid Catalyst ◽  
Biodiesel Production ◽  
Magnetic Solid ◽  
Magnetic Solid Acid

Synthesis and Characterization of Heterogeneous Solid Acid Catalyst from Alstonia Scolaris Stalks for Biodiesel Production using Waste Cooking Oil

2020 ◽  
Vol 10 ◽  
Author(s):  
Charishma Venkata Sai Anne ◽  
Karthikeyan S. ◽  
Arun C.
Keyword(s):  
Reaction Time ◽  
Solid Acid ◽  
Solid Acid Catalyst ◽  
Acid Catalyst ◽  
Waste Cooking Oil ◽  
Biodiesel Production ◽  
Wood Biomass ◽  
Waste Wood ◽  
X Ray ◽  
Cooking Oil

Background: Waste biomass derived reusable heterogeneous acid based catalysts are more suitable to overcome the problems associated with homogeneous catalysts. The use of agricultural biomass as catalyst for transesterification process is more economical and it reduces the overall production cost of biodiesel. The identification of an appropriate suitable catalyst for effective transesterification will be a landmark in biofuel sector Objective: In the present investigation, waste wood biomass was used to prepare a low cost sulfonated solid acid catalyst for the production of biodiesel using waste cooking oil. Methods: The pretreated wood biomass was first calcined then sulfonated with H2SO4. The catalyst was characterized by various analyses such as, Fourier-transform infrared spectroscopy (FTIR), Scanning Electron Microscopy (SEM), Energy Dispersive X-Ray Spectroscopy (EDS) and X-ray diffraction (XRD). The central composite design (CCD) based response surface methodology (RSM) was applied to study the influence of individual process variables such as temperature, catalyst load, methanol to oil molar ration and reaction time on biodiesel yield. Results: The obtained optimized conditions are as follows: temperature (165 ˚C), catalyst loading (1.625 wt%), methanol to oil molar ratio (15:1) and reaction time (143 min) with a maximum biodiesel yield of 95 %. The Gas chromatographymass spectrometry (GC-MS) analysis of biodiesel produced from waste cooking oil was showed that it has a mixture of both monounsaturated and saturated methyl esters. Conclusion: Thus the waste wood biomass derived heterogeneous catalyst for the transesterification process of waste cooking oil can be applied for sustainable biodiesel production by adding an additional value for the waste materials and also eliminating the disposable problem of waste oils.

Simulation, Case Studies and Optimization of a Biodiesel Process with a Solid Acid Catalyst

2007 ◽  
Vol 5 (1) ◽  
Author(s):  
Alex H West ◽  
Dusko Posarac ◽  
Naoko Ellis
Keyword(s):  
Case Studies ◽  
Solid Acid ◽  
Solid Acid Catalyst ◽  
Fixed Bed ◽  
Acid Catalyst ◽  
Biodiesel Production ◽  
Fixed Bed Reactor ◽  
Rate Of Return ◽  
Manufacturing Cost ◽  
Tax Rate

A commercial process simulator was used to develop a detailed simulation of a biodiesel production process, and carry out case studies and optimization. The simulated process produced biodiesel from a feedstock containing 5 wt.% free fatty acids in a fixed-bed reactor with sulfated-zirconia as an acidic catalyst. Sized unit operation blocks, material and energy flows were used to conduct an economic assessment of the process. Total capital investment, total manufacturing cost, after tax rate-of-return and production cost ($/kg) were all determined for the process. The process was then optimized by maximizing the after tax rate-of-return (ATROR). Based on our previous work, the most economical process for transesterification of waste vegetable oil at the scale of 8000 metric tones/yr of biodiesel production among the four processes examined was based on a solid acid catalyst reaction. Our results showed that the process is economically feasible, even without government subsidy, while at the same time, the produced biodiesel met the required ASTM standard for purity.

scholarly journals Optimization of Biodiesel Production from Waste Cooking Oil Using S–TiO2/SBA-15 Heterogeneous Acid Catalyst

Catalysts ◽  
2019 ◽  
Vol 9 (1) ◽  
pp. 67 ◽  
Author(s):  
Muhammad Hossain ◽  
Md Siddik Bhuyan ◽  
Abul Md Ashraful Alam ◽  
Yong Seo
Keyword(s):  
Solid Acid ◽  
Solid Acid Catalyst ◽  
Acid Catalyst ◽  
Waste Cooking Oil ◽  
Biodiesel Production ◽  
Catalyst Loading ◽  
Esterification Reaction ◽  
Impregnation Method ◽  
Cooking Oil ◽  
Heterogeneous Acid Catalyst

The aim of this research was to synthesize, characterize, and apply a heterogeneous acid catalyst to optimum biodiesel production from hydrolyzed waste cooking oil via an esterification reaction, to meet society’s future demands. The solid acid catalyst S–TiO2/SBA-15 was synthesized by a direct wet impregnation method. The prepared catalyst was evaluated using analytical techniques, X-ray diffraction (XRD), Scanning electron microscopy (SEM) and the Brunauer–Emmett–Teller (BET) method. The statistical analysis of variance (ANOVA) was studied to validate the experimental results. The catalytic effect on biodiesel production was examined by varying the parameters as follows: temperatures of 160 to 220 °C, 20–35 min reaction time, methanol-to-oil mole ratio between 5:1 and 20:1, and catalyst loading of 0.5%–1.25%. The maximum biodiesel yield was 94.96 ± 0.12% obtained under the optimum reaction conditions of 200 °C, 30 min, and 1:15 oil to methanol molar ratio with 1.0% catalyst loading. The catalyst was reused successfully three times with 90% efficiency without regeneration. The fuel properties of the produced biodiesel were found to be within the limits set by the specifications of the biodiesel standard. This solid acid catalytic method can replace the conventional homogeneous catalyzed transesterification of waste cooking oil for biodiesel production.

Polystyrene-based superacidic solid acid catalyst: synthesis and its application in biodiesel production

RSC Advances ◽  
2014 ◽  
Vol 4 (88) ◽  
pp. 47448-47454 ◽  
Author(s):  
Ying Chang ◽  
Chohee Lee ◽  
Chulsung Bae
Keyword(s):  
High Efficiency ◽  
Solid Acid ◽  
Solid Acid Catalyst ◽  
Acid Catalyst ◽  
Biodiesel Production ◽  
Catalyst Loading ◽  
Catalyst Synthesis ◽  
Low Catalyst Loading

A novel polystyrene-based superacidic solid acid catalyst was developed. It showed high efficiency for biodiesel production with low catalyst loading and excellent recyclability.

scholarly journals Microporous Acidic Cesium Salt of 12-Tungstosilicic Acid Cs3HSiW12O40as a Size-selective Solid Acid Catalyst

2010 ◽  
Vol 39 (8) ◽  
pp. 881-883 ◽  
Author(s):  
Yuichi Kamiya ◽  
Shogo Sano ◽  
Yu-ki Miura ◽  
Yohei Uchida ◽  
Yuki Ogawa ◽  
...  
Keyword(s):  
Solid Acid ◽  
Solid Acid Catalyst ◽  
Acid Catalyst ◽  
Cesium Salt ◽  
Tungstosilicic Acid
Sign in / Sign up

Export Citation Format

Share Document