Evaluation of Electrical Energy Per Order (EEO) with Kinetic Modeling on Photooxidative Degradation of C. I. Acid Orange 7 in a Tubular Continuous-Flow Photoreactor

2006 ◽  
Vol 45 (2) ◽  
pp. 553-557 ◽  
Author(s):  
Mohammad A. Behnajady ◽  
Nasser Modirshahla
Keyword(s):  
Kinetic Modeling ◽  
Continuous Flow ◽  
Electrical Energy ◽  
Acid Orange 7 ◽  
Acid Orange ◽  
Electrical Energy Per Order

Evaluation of electrical energy per order (EEO) with kinetic modeling on the removal of Malachite Green by US/UV/H2O2 process

Desalination ◽  
2009 ◽  
Vol 249 (1) ◽  
pp. 99-103 ◽  
Author(s):  
Mohammad A. Behnajady ◽  
Behrouz Vahid ◽  
Nasser Modirshahla ◽  
Mohammad Shokri
Keyword(s):  
Malachite Green ◽  
Kinetic Modeling ◽  
Electrical Energy ◽  
Electrical Energy Per Order

Preparation of cationic waste paper and its application in poisonous dye removal

2013 ◽  
Vol 67 (11) ◽  
pp. 2560-2567 ◽  
Author(s):  
Fan Yang ◽  
Xiaojie Song ◽  
Lifeng Yan
Keyword(s):  
Low Cost ◽  
Aqueous Suspension ◽  
Order Kinetic ◽  
Acid Orange 7 ◽  
Anionic Dyes ◽  
Experimental Conditions ◽  
Adsorption Models ◽  
Acid Orange ◽  
Initial Ph ◽  
Pseudo Second Order

Cationic paper was prepared by reaction of paper with 2,3-epoxypropyltrimethylammonium chloride in aqueous suspension, and tested as low-cost adsorbent for wastewater treatment. The experimental results revealed that anionic dyes (Acid Orange 7, Acid Red 18, and Acid Blue 92) were adsorbed on the cationic paper nicely. The maximum amount of dye Acid Orange 7 adsorbed on cationic paper was 337.2 mg/g in experimental conditions. The effects of initial dye concentration, temperature, and initial pH of dye solution on adsorption capacity of cationic paper were studied. The pseudo-first-order and pseudo-second-order kinetic models were applied to describe the kinetic data. The Freundlich and Langmuir adsorption models were used to describe adsorption equilibrium. The thermodynamic data indicated that the adsorption process of dye on cationic paper occurred spontaneously.

Fabrication of monoclinic BiVO4 photocatalyst film and its photocatalytic activity for organic pollutant removal

2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Saranyoo Chaiwichian ◽  
Buagun Samran
Keyword(s):  
Visible Light ◽  
Visible Light Irradiation ◽  
Average Particle Size ◽  
Pollutant Removal ◽  
Light Irradiation ◽  
Average Particle ◽  
Film Sample ◽  
Acid Orange 7 ◽  
Acid Orange ◽  
X Ray

Abstract Monoclinic BiVO4 photocatalyst films decorated on glass substrates were successfully fabricated via a dip-coating technique with different annealing temperatures of 400 °C, 450 °C, 500°C, and 550 °C. All of the physical and chemical properties of as-prepared BiVO4 photocatalyst film samples were investigated using X-ray diffraction, scanning electron microscopy, X-ray photoelectron spectroscopy and UV–vis diffuse reflectance spectra techniques. The results revealed that the as-prepared BiVO4 photocatalyst film samples retained a monoclinic phase with an average particle size of about 50 – 100 nm. Moreover, the BiVO4 photocatalyst film samples showed a strong photoabsorption edge in the range of visible light with the band gap energy of 2.46 eV. The photocatalytic activities of all the film samples were tested by the degradation of model acid orange 7 under visible light irradiation. The BiVO4 photocatalyst film sample annealed at a temperature of 500 °C showed the highest photoactivity efficiency compared with other film samples, reaching up to 51%within 180 min. In addition, the stability and reusability of BiVO4 photocatalyst film sample made with an annealing temperature of 500 °C did not show loss of photodegradation efficiency of acid orange 7 after ten recycles. A likely mechanism of the photocatalytic process was established by trapping experiments, indicating that the hydroxyl radical scavenger species can be considered to play a key role for acid orange 7 degradation under visible light irradiation.

Sign in / Sign up

Export Citation Format

Share Document