Inner and Outer Secondary-Air Distance-Effect Study within a Cold Small-Scale Model of a New Down-Fired 600 MWe Supercritical Utility Boiler

2011 ◽  
Vol 26 (1) ◽  
pp. 417-424 ◽  
Author(s):  
Min Kuang ◽  
Zhengqi Li ◽  
Qunyi Zhu ◽  
Hongyu Zhang ◽  
Xingying Zhu ◽  
...  
Keyword(s):  
Distance Effect ◽  
Effect Study ◽  
Scale Model ◽  
Small Scale ◽  
Utility Boiler ◽  
Secondary Air ◽  
Small Scale Model

Aerodynamic characteristics within a cold small-scale model for a down-fired 350 MWe supercritical utility boiler at various primary air to vent air ratios

Energy ◽  
2012 ◽  
Vol 47 (1) ◽  
pp. 294-301 ◽  
Author(s):  
Chunlong Liu ◽  
Zhengqi Li ◽  
Xiang Zhang ◽  
Xinjing Jing ◽  
Wenzhen Zhang ◽  
...  
Keyword(s):  
Aerodynamic Characteristics ◽  
Scale Model ◽  
Small Scale ◽  
Utility Boiler ◽  
Small Scale Model

Staged-Air Ratio Optimization within a Cold Small-Scale Model for a MBEL Down-Fired Pulverized-Coal 300 MW (electrical) Utility Boiler

2010 ◽  
Vol 24 (9) ◽  
pp. 4883-4892 ◽  
Author(s):  
Zhengqi Li ◽  
Min Kuang ◽  
Qunyi Zhu ◽  
Pengfei Yang ◽  
Yuangang Wu ◽  
...  
Keyword(s):  
Pulverized Coal ◽  
Scale Model ◽  
Small Scale ◽  
Utility Boiler ◽  
Ratio Optimization ◽  
Small Scale Model

Wave Energy Hyperbaric Device for Electricity Production

2007 ◽  
Author(s):  
Segen F. Estefen ◽  
Paulo Roberto da Costa ◽  
Eliab Ricarte ◽  
Marcelo M. Pinheiro
Keyword(s):  
Power Generation ◽  
Wave Energy ◽  
Experimental Results ◽  
Electricity Production ◽  
Scale Model ◽  
Small Scale ◽  
Regular Waves ◽  
Hyperbaric Chamber ◽  
Small Scale Model

Wave energy is a renewable and non-polluting source and its use is being studied in different countries. The paper presents an overview on the harnessing of energy from waves and the activities associated with setting up a plant for extracting energy from waves in Port of Pecem, on the coast of Ceara State, Brazil. The technology employed is based on storing water under pressure in a hyperbaric chamber, from which a controlled jet of water drives a standard turbine. The wave resource at the proposed location is presented in terms of statistics data obtained from previous monitoring. The device components are described and small scale model tested under regular waves representatives of the installation region. Based on the experimental results values of prescribed pressures are identified in order to optimize the power generation.

Staged-Air Ratio Optimization for a New Down-Fired Technology within a Cold Small-Scale Model of a 350 MWeUtility Boiler

2011 ◽  
Vol 25 (4) ◽  
pp. 1485-1496 ◽  
Author(s):  
Min Kuang ◽  
Zhengqi Li ◽  
Pengfei Yang ◽  
Jinzhao Jia ◽  
Qunyi Zhu
Keyword(s):  
Scale Model ◽  
Small Scale ◽  
Ratio Optimization ◽  
Small Scale Model

Drilling Riser VIV Tests With Prototype Reynolds Numbers

2013 ◽  
Author(s):  
Halvor Lie ◽  
Henning Braaten ◽  
Jamison Szwalek ◽  
Massimiliano Russo ◽  
Rolf Baarholm
Keyword(s):  
Cross Flow ◽  
Effect Study ◽  
Full Scale ◽  
Scale Model ◽  
Small Scale ◽  
Scaling Effects ◽  
Research Activity ◽  
Forced Motion ◽  
Auxiliary Lines ◽  
Viv Suppression

For deep-water riser systems, Vortex Induced Vibrations (VIV) may cause significant fatigue damage. It appears that the knowledge gap of this phenomenon is considerable and this has caused a high level of research activity over the last decades. Small scale model tests are often used to investigate VIV behaviour. However, one substantial uncertainty in applying such results is scaling effects, i.e. differences in VIV response in full scale flow and small scale flow. To (partly) overcome this obstacle, a new innovative VIV test rig was designed and built at MARINTEK to test a rigid full scale riser model. The rigid riser model is mounted vertically and can either be elastically mounted or be given a forced motion. In the present version, the cylinder can only move in the cross-flow (CF) direction and is restricted in the in-line (IL) direction. The paper reports results from a drilling riser VIV experiment where the new rest rig has been used. The overall objective of the work is to study possible VIV suppression to improve operability of retrievable riser systems with auxiliary lines by adding riser fins. These fins are normally used as devices for protection of the auxiliary lines. The test program has recently been completed and analysis is an on-going activity. However, some results can be reported at this stage and more results are planned to be published. A bare riser model was used in a Reynolds number (Rn) scaling effect study. The riser model was elastically mounted and towed over a reduced velocity range around 4 – 10 in two different Rn ranges, 75 000 – 192 000 (subcritical regime) and 347 000 – 553 000 (critical regime). The difference in the displacement amplitude to diameter ratio, A/D, is found to be significant. The elastically mounted riser was also towed with various drilling riser configurations in order to study VIV/galloping responses. One configuration included a slick joint riser model with 6 kill & choke lines; another has added riser fins too. The riser model is based on a specific drilling riser and the kill and choke lines have various diameters and have a non-symmetrical layout. The various riser configurations have also been used in forced motion tests where the towed model has been given a sinusoidal CF motion. Forces have been measured. Determination of the force coefficients is still in progress and is planned to be reported later. Scaling effects appear to be a significant uncertainty and further research on the subject is recommended. The slick joint drilling riser configuration generally increased the displacements compared to displacements of the bare riser model. The drilling riser configuration with protection fins, kill and choke lines generally reduced the displacements compared to displacements of the bare riser model. For both riser systems, tests showed that the response is sensitive to the heading of the current.

scholarly journals Monitoring deformation of small scale model tunnels under load testing

Survey Review ◽  
2014 ◽  
Vol 46 (339) ◽  
pp. 417-425 ◽  
Author(s):  
H-M. Chen ◽  
M. Smith ◽  
H-S. Yu ◽  
N. Kokkas
Keyword(s):  
Scale Model ◽  
Small Scale ◽  
Load Testing ◽  
Small Scale Model
Sign in / Sign up

Export Citation Format

Share Document