Internal Fines Removal Using Population Balance Model Based Control of Crystal Size Distribution under Dissolution, Growth and Nucleation Mechanisms

2011 ◽  
Vol 11 (6) ◽  
pp. 2205-2219 ◽  
Author(s):  
Z. K. Nagy ◽  
E. Aamir ◽  
C. D. Rielly
Keyword(s):  
Size Distribution ◽  
Crystal Size ◽  
Population Balance ◽  
Crystal Size Distribution ◽  
Balance Model ◽  
Population Balance Model ◽  
Model Based Control ◽  
Model Based ◽  
Nucleation Mechanisms

POPULATION BALANCE MODEL OF ICE CRYSTALS SIZE DISTRIBUTION DURING ICE SLURRY STORAGE

2014 ◽  
Vol 22 (02) ◽  
pp. 1440001 ◽  
Author(s):  
AIXIANG XU ◽  
ZHIQIANG LIU ◽  
TENGLEI ZHAO ◽  
XIAOXIAO WANG
Keyword(s):  
Particle Size ◽  
Particle Size Distribution ◽  
Size Distribution ◽  
Crystal Size ◽  
Population Balance ◽  
Ice Crystals ◽  
Balance Model ◽  
Ice Slurry ◽  
Slurry Storage

Particle size distribution and number of ice crystals have a great influence on the flow and heat transfer performance of ice slurry. A population balance model (PBM) containing population and mass balances has been built to simulate numerically the development of ice particle size distribution during adiabatic ice slurry storage. The model assumes a homogeneously mixed and long-term storage tank in which the effect of breakage and aggregation between ice crystals was considered. For solving the population balance equations (PBEs) in the PBM, a semi-discrete finite volume scheme was applied. Finally, the effect of breakage and aggregation on development of ice particle size distribution was analyzed respectively. The results show that both breakage and aggregation are the two important effects on the particle size distribution and evolution of ice particle during storage, but they have opposite effect on the development of ice crystal size. In storage, breakage and aggregation have almost equivalent effect in the initial phase, but aggregation has dominant effect at last. The PBM results are in good agreement with experimental results by Pronk et al. [Effect of long-term ice slurry storage on crystal size distribution, 5th Workshop on Ice Slurries of the IIR (2002), pp. 151–160]. Therefore, the PBM presented in this paper is able to predict the development of particle size distribution during ice slurry storage.

Modeling of the formation kinetics and size distribution evolution of II–VI quantum dots

2017 ◽  
Vol 2 (4) ◽  
pp. 567-576 ◽  
Author(s):  
Stefano Lazzari ◽  
Milad Abolhasani ◽  
Klavs F. Jensen
Keyword(s):  
Quantum Dots ◽  
Size Distribution ◽  
Semiconductor Nanocrystals ◽  
Population Balance ◽  
Nanocrystal Size ◽  
Balance Model ◽  
Population Balance Model ◽  
Formation Kinetics

A population balance model describes the formation of II–VI semiconductor nanocrystals and predicts experimentally observed properties of the nanocrystal size distribution.

scholarly journals A numerical study on the estimation of the stable size distribution for a cell population balance model

2018 ◽  
Vol 41 (8) ◽  
pp. 2894-2905 ◽  
Author(s):  
Luis M. Abia ◽  
Óscar Angulo ◽  
Juan Carlos López-Marcos ◽  
Miguel Ángel López-Marcos
Keyword(s):  
Size Distribution ◽  
Cell Population ◽  
Numerical Study ◽  
Population Balance ◽  
Balance Model ◽  
Population Balance Model ◽  
A Cell ◽  
Stable Size Distribution

scholarly journals Simulation of Floc Size Distribution in Flocculation of Activated Sludge Using Population Balance Model with Modified Expressions for the Aggregation and Breakage

2019 ◽  
Vol 2019 ◽  
pp. 1-10
Author(s):  
Zhenliang Li ◽  
Peili Lu ◽  
Daijun Zhang ◽  
Fuzhong Song
Keyword(s):  
Activated Sludge ◽  
Size Distribution ◽  
Velocity Gradient ◽  
Population Balance ◽  
Balance Model ◽  
Population Balance Model ◽  
Collision Efficiency ◽  
Volume Percentage ◽  
Floc Size ◽  
Breakage Rate

The floc size distribution of activated sludge was simulated successfully by population balance model in the previous study (Population Balance Model and Calibration Method for Simulating the Time Evolution of Floc Size Distribution of Activated Sludge Flocculation. Desalination and Water Treatment, 67, 41-50). However, nonignorable errors exist in the simulation for the volume percentage of large flocs. This paper describes the application of a modified population balance model in the simulation of the time evolution of floc size distribution in activated sludge flocculation process under shear-induced conditions. It was found that the application of modified size dependent collision efficiency, modified breakage rate expression by assuming a maximum value, and binominal daughter-particles distribution function could improve the population balance model for activated sludge flocculation and successfully predict the dynamic changes in volume percentage distribution and mean floc size of activated sludge under different shear conditions. The results demonstrate that the maximum breakage rate was independent on the velocity gradient, and both the collision efficiency and breakage rate coefficient show a power-law relationship with the average velocity gradient; the former decreases while the latter increases with the rise of the average velocity gradient. These findings would help to understand the dynamics of activated sludge flocculation.

Sign in / Sign up

Export Citation Format

Share Document