Soft Sensors: Chemoinformatic Model for Efficient Control and Operation in Chemical Plants

2016 ◽  
pp. 159-174
Author(s):  
Hiromasa Kaneko ◽  
Kimito Funatsu
Keyword(s):  
Chemical Plants ◽  
Soft Sensors ◽  
Efficient Control

ALLEGHENY LUDLUM AL276

Alloy Digest ◽  
1996 ◽  
Vol 45 (1) ◽  
Keyword(s):  
Corrosion Resistance ◽  
High Temperature ◽  
Power Plant ◽  
Physical Properties ◽  
Surface Treatment ◽  
Tensile Properties ◽  
Crevice Corrosion ◽  
Heat Treating ◽  
Chemical Plants ◽  
Temperature Performance

Abstract Allegheny Ludlum AL276 is widely used in the most severe environments found in chemical plants and in power plant desulfurization systems. The high molybdenum level with tungsten gives excellent pitting and crevice corrosion resistance. This datasheet provides information on composition, physical properties, hardness, elasticity, and tensile properties. It also includes information on low and high temperature performance, and corrosion resistance as well as forming, heat treating, joining, and surface treatment. Filing Code: Ni-497. Producer or source: Allegheny Ludlum Corporation.

Performance Stability of Small Biological Chemical Treatment Plants

1990 ◽  
Vol 22 (3-4) ◽  
pp. 275-282
Author(s):  
R. Storhaug
Keyword(s):  
Activated Sludge ◽  
Chemical Treatment ◽  
Chemical Precipitation ◽  
Poor Quality ◽  
Precipitation Process ◽  
Chemical Plants ◽  
Effluent Standards ◽  
Main Portion ◽  
Rotating Biological Contactors ◽  
Number Of Treatment

Biological and chemical treatment plants constitute a main portion of the overall number of treatment plants in Norway. The biological and chemical plants are divided into three process groups, simultaneous precipitation and activated sludge, combined precipitation and rotating biological contactors (RBC) and post precipitation and activated sludge. Aluminium sulphate or ferric chloride are the commonly used flocculants in the chemical precipitation process. Effluent data from 174 Norwegian biological chemical treatment plants are evaluated. Compared to the effluent standards for each process group, post precipitation shows the best performance. On an average these plants have the lowest actual utilization of the design capacity. The most important factors that cause the treatment plants not to meet the effluent standards are, poor quality of the sewer system, improper design of the plant and organizational problems. Satisfactory separation of particles, flow equalization and proper operational management, are the basic demands to achieve low effluent concentrations for tot-P and BOD7.

Sign in / Sign up

Export Citation Format

Share Document