scholarly journals Charge Carriers Modulate the Bonding of Semiconductor Nanoparticle Dopants As Revealed by Time-Resolved X-ray Spectroscopy

ACS Nano ◽  
2017 ◽  
Vol 11 (10) ◽  
pp. 10070-10076 ◽  
Author(s):  
Asra Hassan ◽  
Xiaoyi Zhang ◽  
Xiaohan Liu ◽  
Clare E. Rowland ◽  
Ali M. Jawaid ◽  
...  
Keyword(s):  
Charge Carriers ◽  
Time Resolved ◽  
X Ray ◽  
Semiconductor Nanoparticle

scholarly journals Probing Electronic Strain Generation by Separated Electron-Hole Pairs Using Time-Resolved X-ray Scattering

2019 ◽  
Vol 9 (22) ◽  
pp. 4788
Author(s):  
Sooheyong Lee ◽  
Wonhyuk Jo ◽  
Anthony D. DiChiara ◽  
Timothy P. Holmes ◽  
Stephen Santowski ◽  
...  
Keyword(s):  
Charge Carriers ◽  
Excess Charge ◽  
X Ray Diffraction ◽  
Electron Hole ◽  
Time Resolved ◽  
Transient Conditions ◽  
Strain Measurements ◽  
X Ray ◽  
X Ray Scattering ◽  
Photoinduced Charge

Photogeneration of excess charge carriers in semiconductors produces electronic strain. Under transient conditions, electron-hole pairs may be separated across a potential barrier. Using time-resolved X-ray diffraction measurements across an intrinsic AlGaAs/n-doped GaAs interface, we find that the electronic strain is only produced by holes, and that electrons are not directly observable by strain measurements. The presence of photoinduced charge carriers in the n-doped GaAs is indirectly confirmed by delayed heat generation via recombination.

Microtubule nucleation sequence studied by time-resolved x-ray scattering and electron microscopy

1983 ◽  
Vol 41 ◽  
pp. 766-767
Author(s):  
Eva-Maria Mandelkow ◽  
Eckhard Mandelkow ◽  
Joan Bordas
Keyword(s):  
Electron Microscopy ◽  
Dynamic Equilibrium ◽  
Time Resolved ◽  
X Ray ◽  
Additional Information ◽  
X Ray Scattering ◽  
Low Concentrations ◽  
Microtubule Growth ◽  
Ray Patterns ◽  
Ray Scattering

When a solution of microtubule protein is changed from non-polymerising to polymerising conditions (e.g. by temperature jump or mixing with GTP) there is a series of structural transitions preceding microtubule growth. These have been detected by time-resolved X-ray scattering using synchrotron radiation, and they may be classified into pre-nucleation and nucleation events. X-ray patterns are good indicators for the average behavior of the particles in solution, but they are difficult to interpret unless additional information on their structure is available. We therefore studied the assembly process by electron microscopy under conditions approaching those of the X-ray experiment. There are two difficulties in the EM approach: One is that the particles important for assembly are usually small and not very regular and therefore tend to be overlooked. Secondly EM specimens require low concentrations which favor disassembly of the particles one wants to observe since there is a dynamic equilibrium between polymers and subunits.

Detector strategies for environmental scanning electron microscopy

1992 ◽  
Vol 50 (2) ◽  
pp. 1296-1297
Author(s):  
Klaus-Ruediger Peters
Keyword(s):  
High Vacuum ◽  
Environmental Scanning Electron Microscopy ◽  
Charge Carriers ◽  
Environmental Scanning ◽  
Surface Information ◽  
X Ray ◽  
Detector Electrode ◽  
Electrons And Ions ◽  
Low Energy Electrons ◽  
Environmental Sem

Environmental SEM operate at specimen chamber pressures of ∼20 torr (2.7 kPa) allowing stabilization of liquid water at room temperature, working on rugged insulators, and generation of an environmental secondary electron (ESE) signal. All signals available in conventional high vacuum instruments are also utilized in the environmental SEM, including BSE, SE, absorbed current, CL, and X-ray. In addition, the ESEM allows utilization of the flux of charge carriers as information, providing exciting new signal modes not available to BSE imaging or to conventional high vacuum SEM.In the ESEM, at low vacuum, SE electrons are collected with a “gaseous detector”. This detector collects low energy electrons (and ions) with biased wires or plates similar to those used in early high vacuum SEM for SE detection. The detector electrode can be integrated into the first PLA or positioned at any other place resulting in a versatile system that provides a variety of surface information.

Time-Resolved Cryo-Electron Microscopy of Oscillating Microtubules

1990 ◽  
Vol 48 (1) ◽  
pp. 502-503
Author(s):  
Eva-Maria Mandelkow ◽  
Ron Milligan
Keyword(s):  
Electron Microscopy ◽  
Dynamic Instability ◽  
Entire Solution ◽  
Reaction Scheme ◽  
Time Resolved ◽  
X Ray ◽  
X Ray Scattering ◽  
A Chain ◽  
Ray Scattering

Microtubules form part of the cytoskeleton of eukaryotic cells. They are hollow libers of about 25 nm diameter made up of 13 protofilaments, each of which consists of a chain of heterodimers of α-and β-tubulin. Microtubules can be assembled in vitro at 37°C in the presence of GTP which is hydrolyzed during the reaction, and they are disassembled at 4°C. In contrast to most other polymers microtubules show the behavior of “dynamic instability”, i.e. they can switch between phases of growth and phases of shrinkage, even at an overall steady state [1]. In certain conditions an entire solution can be synchronized, leading to autonomous oscillations in the degree of assembly which can be observed by X-ray scattering (Fig. 1), light scattering, or electron microscopy [2-5]. In addition such solutions are capable of generating spontaneous spatial patterns [6].In an earlier study we have analyzed the structure of microtubules and their cold-induced disassembly by cryo-EM [7]. One result was that disassembly takes place by loss of protofilament fragments (tubulin oligomers) which fray apart at the microtubule ends. We also looked at microtubule oscillations by time-resolved X-ray scattering and proposed a reaction scheme [4] which involves a cyclic interconversion of tubulin, microtubules, and oligomers (Fig. 2). The present study was undertaken to answer two questions: (a) What is the nature of the oscillations as seen by time-resolved cryo-EM? (b) Do microtubules disassemble by fraying protofilament fragments during oscillations at 37°C?

Time-resolved X-ray reciprocal space mapping of the crystal under external electric field

2018 ◽  
Vol 189 (02) ◽  
pp. 187-194 ◽  
Author(s):  
Nikita V. Marchenkov ◽  
Anton G. Kulikov ◽  
Ivan I. Atknin ◽  
Arsen A. Petrenko ◽  
Alexander E. Blagov ◽  
...  
Keyword(s):  
Electric Field ◽  
External Electric Field ◽  
Space Mapping ◽  
Reciprocal Space ◽  
Reciprocal Space Mapping ◽  
Time Resolved ◽  
X Ray

Monitoring Polymer-Assisted Mechanochemical Cocrystallisation Through in Situ X-Ray Powder Diffraction

2020 ◽  
Author(s):  
Luzia S. Germann ◽  
Sebastian T. Emmerling ◽  
Manuel Wilke ◽  
Robert E. Dinnebier ◽  
Mariarosa Moneghini ◽  
...  
Keyword(s):  
Molecular Weight ◽  
Powder Diffraction ◽  
Reaction Rate ◽  
Polymer Additives ◽  
Time Resolved ◽  
X Ray

Time-resolved mechanochemical cocrystallisation studies have so-far focused solely on neat and liquid-assisted grinding. Here, we report the monitoring of polymer-assisted grinding reactions using <i>in situ</i> X-ray powder diffraction, revealing that reaction rate is almost double compared to neat grinding and independent of the molecular weight and amount of used polymer additives.<br>

In situ Time-Resolved Small-Angle X-ray Scattering Reveals the Formation Kinetics of Polyelectrolyte Complex Micelles

2019 ◽  
Author(s):  
Hao Wu ◽  
Jeffrey Ting ◽  
Siqi Meng ◽  
Matthew Tirrell
Keyword(s):  
Small Angle ◽  
Self Assembly ◽  
Electrostatic Interactions ◽  
Polyelectrolyte Complex ◽  
Time Resolved ◽  
X Ray ◽  
X Ray Scattering ◽  
Kinetics Of ◽  
Ray Scattering

We have directly observed the <i>in situ</i> self-assembly kinetics of polyelectrolyte complex (PEC) micelles by synchrotron time-resolved small-angle X-ray scattering, equipped with a stopped-flow device that provides millisecond temporal resolution. This work has elucidated one general kinetic pathway for the process of PEC micelle formation, which provides useful physical insights for increasing our fundamental understanding of complexation and self-assembly dynamics driven by electrostatic interactions that occur on ultrafast timescales.

Role of the Structure and Electronic Properties of Fe2O3-MoO3 Catalyst on the Dehydration of Isopropyl Alcohol

1993 ◽  
Vol 58 (7) ◽  
pp. 1591-1599 ◽  
Author(s):  
Abd El-Aziz A. Said
Keyword(s):  
Active Sites ◽  
Isopropyl Alcohol ◽  
Oxide Catalyst ◽  
Flow System ◽  
Charge Carriers ◽  
X Ray Diffraction ◽  
X Ray ◽  
Catalyst Composition ◽  
Surface Active

Molybdenum oxide catalyst doped or mixed with (1 - 50) mole % Fe3+ ions were prepared. The structure of the original samples and the samples calcined at 400 °C were characterized using DTA, X-ray diffraction and IR spectra. Measurements of the electrical conductivity of calcined samples with and without isopropyl alcohol revealed that the conductance increases on increasing the content of Fe3+ ions up to 50 mole %. The activation energies of charge carriers were determined in presence and absence of the alcohol. The catalytic dehydration of isopropyl alcohol was carried out at 250 °C using a flow system. The results obtained showed that the doped or mixed catalysts are active and selective towards propene formation. However, the catalyst containing 40 mole % Fe3+ ions exhibited the highest activity and selectivity. Correlations were attempted to the catalyst composition with their electronic and catalytic properties. Probable mechanism for the dehydration process is proposed in terms of surface active sites.

Sign in / Sign up

Export Citation Format

Share Document