A Polymorphic FeS2 Cathode Enabled by Copper Current Collector Induced Displacement Redox Mechanism

ACS Nano ◽  
2021 ◽  
Author(s):  
Lulu Tan ◽  
Jinming Yue ◽  
Zhao Yang ◽  
Xiaogang Niu ◽  
Yusi Yang ◽  
...  
Keyword(s):  
Current Collector ◽  
Redox Mechanism

Investigation of Polyoxometalate-(Poly)pyrrole Heterogeneous Nanostructures as Cathodes for Rechargeable Magnesium-Ion Batteries

2018 ◽  
Author(s):  
Hakeem K. Henry ◽  
Sang Bok Lee
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Photoelectron Spectroscopy ◽  
Active Material ◽  
Conductive Polymer ◽  
Current Collector ◽  
Constant Current ◽  
Anodized Aluminum ◽  
Transmission Electron ◽  
Pyrrole Monomer

The PMo<sub>12</sub>-PPy heterogeneous cathode was synthesized electrochemically. In doing so, the PMo<sub>12</sub> redox-active material was impregnated throughout the conductive polymer matrix of the poly(pyrrole) nanowires. All chemicals and reagents used were purchased from Sigma-Aldrich. Anodized aluminum oxide (AAO) purchased from Whatman served as the porous hard template for nanowire deposition. A thin layer of gold of approximately 200nm was sputtered onto the disordered side of the AAO membrane to serve as the current collector. Copper tape was connected to the sputtered gold for contact and the device was sealed in parafilm with heat with an exposed area of 0.32 cm<sup>2</sup> to serve as the electroactive area for deposition. All electrochemical synthesis and experiments were conducted using a Bio-Logic MPG2 potentiostat. The deposition was carried out using a 3-electrode beaker cell setup with a solution of acetonitrile containing 5mM and 14mM of the phosphomolybdic acid and pyrrole monomer, respectively. The synthesis was achieved using chronoamperometry to apply a constant voltage of 0.8V vs. Ag/AgCl (BASi) to oxidatively polymerize the pyrrole monomer to poly(pyrrole). To prevent the POM from chemically polymerizing the pyrrole, an injection method was used in which the pyrrole monomer was added to the POM solution only after the deposition voltage had already been applied. The deposition was well controlled by limiting the amount of charge transferred to 300mC. Following deposition, the AAO template was removed by soaking in 3M sodium hydroxide (NaOH) for 20 minutes and rinsed several times with water. After synthesis, all cathodes underwent electrochemical testing to determine their performance using cyclic voltammetry and constant current charge-discharge cycling in 0.1 M Mg(ClO<sub>4</sub>)<sub>2</sub>/PC electrolyte. The cathodes were further characterized using scanning electron microscopy (SEM), transmission electron microscopy (TEM), scanning transmission electron microscopy (STEM), and x-ray photoelectron spectroscopy (XPS).

scholarly journals Osmium–arene complexes with high potency towards Mycobacterium tuberculosis

Metallomics ◽  
2021 ◽  
Vol 13 (4) ◽  
Author(s):  
James P C Coverdale ◽  
Collette S Guy ◽  
Hannah E Bridgewater ◽  
Russell J Needham ◽  
Elizabeth Fullam ◽  
...  
Keyword(s):  
Mycobacterium Tuberculosis ◽  
Global Health ◽  
Mechanism Of Action ◽  
Health Problem ◽  
Normal Lung ◽  
Lung Cells ◽  
Redox Mechanism ◽  
Human Lung Cells ◽  
Half Sandwich ◽  
Global Health Problem

Abstract The treatment of tuberculosis (TB) poses a major challenge as frontline therapeutic agents become increasingly ineffective with the emergence and spread of drug-resistant strains of Mycobacterium tuberculosis (Mtb). To combat this global health problem, new antitubercular agents with novel modes of action are needed. We have screened a close family of 17 organometallic half-sandwich Os(II) complexes [(arene)Os(phenyl-azo/imino-pyridine)(Cl/I)]+Y– containing various arenes (p-cymene, biphenyl, or terphenyl), and NMe2, F, Cl, or Br phenyl or pyridyl substituents, for activity towards Mtb in comparison with normal human lung cells (MRC5). In general, complexes with a monodentate iodido ligand were more potent than chlorido complexes, and the five most potent iodido complexes (MIC 1.25–2.5 µM) have an electron-donating Me2N or OH substituent on the phenyl ring. As expected, the counter anion Y (PF6–, Cl–, I–) had little effect on the activity. The pattern of potency of the complexes towards Mtb is similar to that towards human cells, perhaps because in both cases intracellular thiols are likely to be involved in their activation and their redox mechanism of action. The most active complex against Mtb is the p-cymene Os(II) NMe2-phenyl-azopyridine iodido complex (2), a relatively inert complex that also exhibits potent activity towards cancer cells. The uptake of Os from complex 2 by Mtb is rapid and peaks after 6 h, with temperature-dependence studies suggesting a major role for active transport. Significance to Metallomics Antimicrobial resistance is a global health problem. New advances are urgently needed in the discovery of new antibiotics with novel mechanisms of action. Half-sandwich organometallic complexes offer a versatile platform for drug design. We show that with an appropriate choice of the arene, an N,N-chelated ligand, and monodentate ligand, half-sandwich organo–osmium(II) complexes can exhibit potent activity towards Mycobacterium tuberculosis (Mtb), the leading cause of death from a single infectious agent. The patterns of activity of the 17 azo- and imino-pyridine complexes studied here towards Mtb and normal lung cells suggest a common redox mechanism of action involving intracellular thiols.

Ag coated 3D-Cu foam as a lithiophilic current collector for enabling Li2S-based anode-free batteries

2021 ◽  
Vol 57 (30) ◽  
pp. 3708-3711
Author(s):  
Hao Cheng ◽  
Cheng Gao ◽  
Ning Cai ◽  
Miao Wang
Keyword(s):  
Three Dimensional ◽  
Current Collector ◽  
Lithium Deposition ◽  
Cu Foam

Ag coated three-dimensional Cu foam is introduced as a lithiophilic current collector to regulate the lithium deposition for Li2S-based anode-free batteries.

scholarly journals Efficient electrocatalytic nitrogen reduction to ammonia with aqueous silver nanodots

2021 ◽  
Vol 4 (1) ◽  
Author(s):  
Wenyi Li ◽  
Ke Li ◽  
Yixing Ye ◽  
Shengbo Zhang ◽  
Yanyan Liu ◽  
...  
Keyword(s):  
Active Sites ◽  
Theoretical Calculations ◽  
Current Collector ◽  
Electrochemical Reactor ◽  
Reduction Reaction ◽  
Solution Ph ◽  
Faradaic Efficiency ◽  
Yield Rate ◽  
Silver Nanodots ◽  
Ti Mesh

AbstractThe electrocatalytic nitrogen (N2) reduction reaction (NRR) relies on the development of highly efficient electrocatalysts and electrocatalysis systems. Herein, we report a non-loading electrocatalysis system, where the electrocatalysts are dispersed in aqueous solution rather than loading them on electrode substrates. The system consists of aqueous Ag nanodots (AgNDs) as the catalyst and metallic titanium (Ti) mesh as the current collector for electrocatalytic NRR. The as-synthesized AgNDs, homogeneously dispersed in 0.1 M Na2SO4 solution (pH = 10.5), can achieve an NH3 yield rate of 600.4 ± 23.0 μg h−1 mgAg−1 with a faradaic efficiency (FE) of 10.1 ± 0.7% at −0.25 V (vs. RHE). The FE can be further improved to be 20.1 ± 0.9% at the same potential by using Ti mesh modified with oxygen vacancy-rich TiO2 nanosheets as the current collector. Utilizing the aqueous AgNDs catalyst, a Ti plate based two-electrode configured flow-type electrochemical reactor was developed to achieve an NH3 yield rate of 804.5 ± 30.6 μg h−1 mgAg−1 with a FE of 8.2 ± 0.5% at a voltage of −1.8 V. The designed non-loading electrocatalysis system takes full advantage of the AgNDs’ active sites for N2 adsorption and activation, following an alternative hydrogenation mechanism revealed by theoretical calculations.

Research Progress on Copper-Based Current Collector for Lithium Metal Batteries

2021 ◽  
Author(s):  
Yongchao Liu ◽  
Dian Gao ◽  
Hongfa Xiang ◽  
Xuyong Feng ◽  
Yan Yu
Keyword(s):  
Current Collector ◽  
Research Progress ◽  
Lithium Metal ◽  
Lithium Metal Batteries
Sign in / Sign up

Export Citation Format

Share Document