High-Adhesion Stretchable Electrode via Cross-Linking Intensified Electroless Deposition on a Biomimetic Elastomeric Micropore Film

2019 ◽  
Vol 11 (22) ◽  
pp. 20535-20544 ◽  
Author(s):  
Congyi Wu ◽  
Xing Tang ◽  
Lin Gan ◽  
Wenfei Li ◽  
Jian Zhang ◽  
...  
Keyword(s):  
Electroless Deposition ◽  
Cross Linking ◽  
High Adhesion ◽  
Stretchable Electrode

High-adhesion vertically aligned gold nanowire stretchable electrodes via a thin-layer soft nailing strategy

2019 ◽  
Vol 4 (6) ◽  
pp. 1380-1387 ◽  
Author(s):  
Yunzhi Ling ◽  
Keying Guo ◽  
Bowen Zhu ◽  
Beatriz Prieto-Simon ◽  
Nicolas H. Voelcker ◽  
...  
Keyword(s):  
Thin Layer ◽  
Stretchable Electronics ◽  
Gold Nanowire ◽  
High Adhesion ◽  
Crucial Component ◽  
Stretchable Electrode ◽  
Healthcare Monitoring ◽  
Vertically Aligned ◽  
Soft Actuators ◽  
And Robotics

A stretchable electrode is a crucial component in future elastronics (i.e. stretchable electronics) with implications in soft actuators, healthcare monitoring, and robotics to name a few.

scholarly journals A stretchable and adhesive ionic conductor based on polyacrylic acid and deep eutectic solvents

2021 ◽  
Vol 5 (1) ◽  
Author(s):  
Gang Li ◽  
Zhihao Deng ◽  
Minkun Cai ◽  
Kaixi Huang ◽  
Mengxue Guo ◽  
...  
Keyword(s):  
Polyacrylic Acid ◽  
Low Temperatures ◽  
Deep Eutectic Solvents ◽  
Ionic Conductor ◽  
High Signal ◽  
Signal Quality ◽  
High Adhesion ◽  
Stretchable Electrode ◽  
Electromyographic Signal ◽  
Surface Electromyographic Signal

AbstractHydrogels are a widely used ionic conductor in on-skin electronic and iontronic devices. However, hydrogels dehydrate in the open air and freeze at low temperatures, limiting their real applications when they are attached on skin or exposed to low temperatures. Polymer-ionic liquid gels can overcome these two obstacles, but synthetic ionic liquids are expensive and toxic. In this work, we present an ionic conductor based on polyacrylic acid (PAAc) and deep eutectic solvents (DESs) that well addresses the aforementioned challenges. We polymerize acrylic acid in DESs to get the PAAc–DES gel, which exhibits excellent stretchability (> 1000%), high electrical conductivity (1.26 mS cm−1), high adhesion to the skin (~ 100 N m−1), as well as good anti-drying and anti-freezing properties. We also demonstrate that the PAAc-DES gel can be used as an on-skin electrode to record the surface electromyographic signal with high signal quality, or as a transparent stretchable electrode in iontronic devices that can work at –20 °C. We believe that the PAAc–DES gels are an ideal candidate as epidermal electrodes or transparent stretchable electrodes.

Aligned wave-like elastomer fibers with robust conductive layers via electroless deposition for stretchable electrode applications

2021 ◽  
Author(s):  
Yan Li ◽  
Yi Chen ◽  
Yi Yang ◽  
Jun-Di Gu ◽  
Kai Ke ◽  
...  
Keyword(s):  
Electroless Deposition ◽  
Conductive Layer ◽  
Low Resistance ◽  
Stretchable Electrode

The robust conductive layer formed on wave-like fibers by electroless deposition endows electrodes with high stretchability and low resistance.

Influence of Calcium Ions on the Plant Cell Surface: Membrane Fusions and Conformational Changes

1974 ◽  
Vol 32 ◽  
pp. 154-155
Author(s):  
D. James Morré ◽  
Charles E. Bracker ◽  
William J. VanDerWoude
Keyword(s):  
Cell Wall ◽  
Cell Surface ◽  
Conformational Changes ◽  
Calcium Ions ◽  
Surface Membrane ◽  
Carboxyl Groups ◽  
Cross Linking ◽  
Ultrastructural Evidence ◽  
Glycine Max L ◽  
Wall Extensibility

Calcium ions in the concentration range 5-100 mM inhibit auxin-induced cell elongation and wall extensibility of plant stems. Inhibition of wall extensibility requires that the tissue be living; growth inhibition cannot be explained on the basis of cross-linking of carboxyl groups of cell wall uronides by calcium ions. In this study, ultrastructural evidence was sought for an interaction of calcium ions with some component other than the wall at the cell surface of soybean (Glycine max (L.) Merr.) hypocotyls.

Embedding Procedure for Water Swollen Samples

1970 ◽  
Vol 28 ◽  
pp. 504-505
Author(s):  
Ann M. Thomas ◽  
Virginia Shemeley
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Ion Exchange ◽  
Structural Changes ◽  
Cross Linking ◽  
Ion Exchange Resins ◽  
Transmission Electron ◽  
First Pass ◽  
Exchange Resins

Those samples which swell rapidly when exposed to water are, at best, difficult to section for transmission electron microscopy. Some materials literally burst out of the embedding block with the first pass by the knife, and even the most rapid cutting cycle produces sections of limited value. Many ion exchange resins swell in water; some undergo irreversible structural changes when dried. We developed our embedding procedure to handle this type of sample, but it should be applicable to many materials that present similar sectioning difficulties.The purpose of our embedding procedure is to build up a cross-linking network throughout the sample, while it is in a water swollen state. Our procedure was suggested to us by the work of Rosenberg, where he mentioned the formation of a tridimensional structure by the polymerization of the GMA biproduct, triglycol dimethacrylate.

The Current Situation in Chemical Stabilization of Biological Materials

1972 ◽  
Vol 30 ◽  
pp. 132-133
Author(s):  
John H. Luft
Keyword(s):  
Electron Microscopy ◽  
Electron Microscope ◽  
Osmium Tetroxide ◽  
Molecular Level ◽  
Cross Linking ◽  
Chemical Stabilization ◽  
Specimen Preparation ◽  
Sufficient Condition ◽  
Radio Telescopes

With information processing devices such as radio telescopes, microscopes or hi-fi systems, the quality of the output often is limited by distortion or noise introduced at the input stage of the device. This analogy can be extended usefully to specimen preparation for the electron microscope; fixation, which initiates the processing sequence, is the single most important step and, unfortunately, is the least well understood. Although there is an abundance of fixation mixtures recommended in the light microscopy literature, osmium tetroxide and glutaraldehyde are favored for electron microscopy. These fixatives react vigorously with proteins at the molecular level. There is clear evidence for the cross-linking of proteins both by osmium tetroxide and glutaraldehyde and cross-linking may be a necessary if not sufficient condition to define fixatives as a class.

Parathyroid gland before and after cisplatin treatment

1987 ◽  
Vol 45 ◽  
pp. 860-861
Author(s):  
S.K. Aggarwal ◽  
J.M. Fadool
Keyword(s):  
Parathyroid Gland ◽  
Wistar Rats ◽  
Antitumor Agent ◽  
The Body ◽  
Cross Linking ◽  
Limiting Factor ◽  
Hormonal Changes ◽  
Primary Mechanism ◽  
Before And After ◽  
Dna Strands

Cisplatin (CDDP) a potent antitumor agent suffers from severe toxic side effects with nephrotoxicity being the major dose-limiting factor, The primary mechanism of its action has been proposed to be through its cross-linking DNA strands. It has also been shown to inactivate various transport enzymes and induce hypocalcemia and hypomagnesemia that may be the underlying cause for some of its toxicities. The present is an effort to study its influence on the parathyroid gland for any hormonal changes that control calcium levels in the body.Male Swiss Wistar rats (Crl: (WI) BR) weighing 200-300 g and of 60 days in age were injected (ip) with cisplatin (7mg/kg in normal saline). The controls received saline injections only. The animals were injected (iv) with calcium (0.5 ml of 10% calcium gluconate/day) and were killed by decapitation on day 1 through 5. Trunk blood was collected in heparinized tubes.

Large-cluster and combined fluorescent and gold immunoprobes

1996 ◽  
Vol 54 ◽  
pp. 892-893
Author(s):  
Richard D. Powell ◽  
James F. Hainfeld ◽  
Carol M. R. Halsey ◽  
David L. Spector ◽  
Shelley Kaurin ◽  
...  
Keyword(s):  
Metal Cluster ◽  
Sulfonyl Chloride ◽  
Gel Filtration ◽  
Cross Linking ◽  
Site Specific ◽  
Fab Fragments ◽  
Cluster Label ◽  
Covalently Linked ◽  
Texas Red ◽  
Fold Excess

Two new types of covalently linked, site-specific immunoprobes have been prepared using metal cluster labels, and used to stain components of cells. Combined fluorescein and 1.4 nm “Nanogold” labels were prepared by using the fluorescein-conjugated tris (aryl) phosphine ligand and the amino-substituted ligand in the synthesis of the Nanogold cluster. This cluster label was activated by reaction with a 60-fold excess of (sulfo-Succinimidyl-4-N-maleiniido-cyclohexane-l-carboxylate (sulfo-SMCC) at pH 7.5, separated from excess cross-linking reagent by gel filtration, and mixed in ten-fold excess with Goat Fab’ fragments against mouse IgG (obtained by reduction of F(ab’)2 fragments with 50 mM mercaptoethylamine hydrochloride). Labeled Fab’ fragments were isolated by gel filtration HPLC (Superose-12, Pharmacia). A combined Nanogold and Texas Red label was also prepared, using a Nanogold cluster derivatized with both and its protected analog: the cluster was reacted with an eight-fold excess of Texas Red sulfonyl chloride at pH 9.0, separated from excess Texas Red by gel filtration, then deprotected with HC1 in methanol to yield the amino-substituted label.

Microstructural changes of Aluminum Nitride after laser irradiation and electroless copper deposition

1994 ◽  
Vol 52 ◽  
pp. 636-637
Author(s):  
S. Cao ◽  
A. J. Pedraza ◽  
L. F. Allard
Keyword(s):  
Aluminum Nitride ◽  
Laser Irradiation ◽  
Electroless Deposition ◽  
Thermal Evaporation ◽  
Surface Region ◽  
Near Surface ◽  
Laser Patterning ◽  
Electroless Copper ◽  
Excimer Laser Irradiation ◽  
Laser Effect

Excimer-laser irradiation strongly modifies the near-surface region of aluminum nitride (AIN) substrates. The surface acquires a distinctive metallic appearance and the electrical resistivity of the near-surface region drastically decreases after laser irradiation. These results indicate that Al forms at the surface as a result of the decomposition of the Al (which has been confirmed by XPS). A computer model that incorporates two opposing phenomena, decomposition of the AIN that leaves a metallic Al film on the surface, and thermal evaporation of the Al, demonstrated that saturation of film thickness and, hence, of electrical resistance is reached when the rate of Al evaporation equals the rate of AIN decomposition. In an electroless copper bath, Cu is only deposited in laser-irradiated areas. This laser effect has been designated laser activation for electroless deposition. Laser activation eliminates the need of seeding for nucleating the initial layer of electroless Cu. Thus, AIN metallization can be achieved by laser patterning followed by electroless deposition.

CRYO-Electron Microscopy of the Acto-Myosin-ATP Complex

1990 ◽  
Vol 48 (1) ◽  
pp. 248-249
Author(s):  
John Trinickt ◽  
Howard White
Keyword(s):  
Electron Microscopy ◽  
Atp Hydrolysis ◽  
Myosin Head ◽  
Bound State ◽  
Cross Linking ◽  
Weakly Bound ◽  
Cryo Electron Microscopy ◽  
Myosin Subfragment 1 ◽  
Attached State ◽  
High Fraction

The primary force of muscle contraction is thought to involve a change in the myosin head whilst attached to actin, the energy coming from ATP hydrolysis. This change in attached state could either be a conformational change in the head or an alteration in the binding angle made with actin. A considerable amount is known about one bound state, the so-called strongly attached state, which occurs in the presence of ADP or in the absence of nucleotide. In this state, which probably corresponds to the last attached state of the force-producing cycle, the angle between the long axis myosin head and the actin filament is roughly 45°. Details of other attached states before and during power production have been difficult to obtain because, even at very high protein concentration, the complex is almost completely dissociated by ATP. Electron micrographs of the complex in the presence of ATP have therefore been obtained only after chemically cross-linking myosin subfragment-1 (S1) to actin filaments to prevent dissociation. But it is unclear then whether the variability in attachment angle observed is due merely to the cross-link acting as a hinge.We have recently found low ionic-strength conditions under which, without resorting to cross-linking, a high fraction of S1 is bound to actin during steady state ATP hydrolysis. The structure of this complex is being studied by cryo-electron microscopy of hydrated specimens. Most advantages of frozen specimens over ambient temperature methods such as negative staining have already been documented. These include improved preservation and fixation rates and the ability to observe protein directly rather than a surrounding stain envelope. In the present experiments, hydrated specimens have the additional benefit that it is feasible to use protein concentrations roughly two orders of magnitude higher than in conventional specimens, thereby reducing dissociation of weakly bound complexes.

Sign in / Sign up

Export Citation Format

Share Document