Steering the Selectivity in Gold–Titanium-Catalyzed Propene Oxidation by Controlling the Surface Acidity

2021 ◽  
Author(s):  
Ewoud J.J. de Boed ◽  
Jan Willem de Rijk ◽  
Petra E. de Jongh ◽  
Baira Donoeva
Keyword(s):  
Surface Acidity ◽  
Propene Oxidation

The effect of composition of cobalt-molybdenum catalysts on their surface acidity and isomerisation activity

1980 ◽  
Vol 45 (3) ◽  
pp. 697-702 ◽  
Author(s):  
Vlastimil Vyskočil ◽  
Miroslav Zdražil
Keyword(s):  
Chromatographic Method ◽  
Surface Acidity ◽  
Parallel Reaction ◽  
Molybdenum Catalysts ◽  
The Difference ◽  
Kinetics Of ◽  
Alumina Catalysts

Kinetics of isomerisation of cyclohexene to methylcyclopentene proceeding as parallel reaction to hydrogenation of cyclohexene to cyclohexane on cobalt-molybdenum catalysts of different composition has been measured. The surface acidity of these catalysts was estimated from the difference in the adsorption of toluene and heptane which was measured by chromatographic method. In a series of catalysts containing molybdenum the acidity parallels isomerisation activity. Cobalt on alumina catalysts and alumina itself have greater acidity but exhibit lower isomerisation activity compared to the catalysts containing molybdenum.

scholarly journals Post-Plasma Catalysis for Trichloroethylene Abatement with Ce-Doped Birnessite Downstream DC Corona Discharge Reactor

Catalysts ◽  
2021 ◽  
Vol 11 (8) ◽  
pp. 946
Author(s):  
Grêce Abdallah ◽  
Jean-Marc Giraudon ◽  
Rim Bitar ◽  
Nathalie De Geyter ◽  
Rino Morent ◽  
...  
Keyword(s):  
Corona Discharge ◽  
Active Oxygen Species ◽  
Surface Acidity ◽  
Good Stability ◽  
Ozone Decomposition ◽  
Moist Air ◽  
Plasma Catalysis ◽  
Dry Air ◽  
Water Tolerance ◽  
By Products

Trichloroethylene (TCE) removal was investigated in a post-plasma catalysis (PPC) configuration in nearly dry air (RH = 0.7%) and moist air (RH = 15%), using, for non-thermal plasma (NTP), a 10-pin-to-plate negative DC corona discharge and, for PPC, Ce0.01Mn as a catalyst, calcined at 400 °C (Ce0.01Mn-400) or treated with nitric acid (Ce0.01Mn-AT). One of the key points was to take advantage of the ozone emitted from NTP as a potential source of active oxygen species for further oxidation, at a very low temperature (100 °C), of untreated TCE and of potential gaseous hazardous by-products from the NTP. The plasma-assisted Ce0.01Mn-AT catalyst presented the best CO2 yield in dry air, with minimization of the formation of gaseous chlorinated by-products. This result was attributed to the high level of oxygen vacancies with a higher amount of Mn3+, improved specific surface area and strong surface acidity. These features also allow the promotion of ozone decomposition efficiency. Both catalysts exhibited good stability towards chlorine. Ce0.01Mn-AT tested in moist air (RH = 15%) showed good stability as a function of time, indicating good water tolerance also.

New method for the study of surface acidity of zeolites by NH3-TPD, using a pH-meter equipped with an ion selective electrode

2006 ◽  
Vol 112 (1-2) ◽  
pp. 13-18 ◽  
Author(s):  
R. Le Van Mao ◽  
N. Al-Yassir ◽  
L. Lu ◽  
N. T. Vu ◽  
A. Fortier
Keyword(s):  
Surface Acidity ◽  
New Method ◽  
Ion Selective Electrode ◽  
Selective Electrode

scholarly journals Ferrierite and Its Delaminated Forms Modified with Copper as Effective Catalysts for NH3-SCO Process

Materials ◽  
2020 ◽  
Vol 13 (21) ◽  
pp. 4885
Author(s):  
Aneta Święs ◽  
Małgorzata Rutkowska ◽  
Andrzej Kowalczyk ◽  
Urbano Díaz ◽  
Antonio E. Palomares ◽  
...  
Keyword(s):  
Copper Oxide ◽  
Ammonia Oxidation ◽  
Catalytic Reduction ◽  
Surface Acidity ◽  
Selective Reduction ◽  
Exchange Method ◽  
Copper Species ◽  
Selective Catalytic Oxidation ◽  
Catalytically Active ◽  
Copper Cations

Ferrierites and their delaminated forms (ITQ-6), containing aluminum or titanium in the zeolite framework, were synthetized and modified with copper by an ion-exchange method. The obtained samples were characterized with respect to their chemical composition (ICP-OES), structure (XRD, UV-Vis DRS), textural parameters (N2-sorption), surface acidity (NH3-TPD), form and reducibility of deposited copper species (UV-Vis DRS and H2-TPR). Ferrierites and delaminated ITQ-6 zeolites modified with copper were studied as catalysts for the selective catalytic oxidation of ammonia to dinitrogen (NH3-SCO). It was shown that aggregated copper oxide species, which were preferentially formed on Ti-zeolites, were catalytically active in direct low-temperature ammonia oxidation to NO, while copper introduced into Al-zeolites was present mainly in the form of monomeric copper cations catalytically active in selective reduction of NO by ammonia to dinitrogen. It was postulated that ammonia oxidation in the presence of the studied catalysts proceeds according to the internal-selective catalytic reduction mechanism (i-SCR) and therefore the suitable ratio between aggregated copper oxide species and monomeric copper cations is necessary to obtain active and selective catalysts for the NH3-SCO process. Cu/Al-ITQ-6 presented the best catalytic properties possibly due to the most optimal ratio of these copper species.

Effect of surface acidity on the catalytic activity and deactivation of supported sulfonic acids during dehydration of methanol to DME

2020 ◽  
Vol 44 (39) ◽  
pp. 16810-16820
Author(s):  
Rosanna Viscardi ◽  
Vincenzo Barbarossa ◽  
Daniele Mirabile Gattia ◽  
Raimondo Maggi ◽  
Giovanni Maestri ◽  
...  
Keyword(s):  
Catalytic Activity ◽  
Sulfonic Acid ◽  
Water Resistance ◽  
Surface Acidity ◽  
Acid Catalyst ◽  
Acid Sites ◽  
Sulfonic Acids ◽  
Effect Of Surface

Superiorty of the supported sulfonic acid catalyst in terms of the water resistance and efficiency of the acid sites compared to the commercial reference.

scholarly journals Characterization and Catalytic Behaviour of Co3(PO4)2–AlPO4 Catalysts

1998 ◽  
Vol 16 (4) ◽  
pp. 285-293 ◽  
Author(s):  
M.R. Mostafa ◽  
F.Sh. Ahmed
Keyword(s):  
Pore Radius ◽  
Surface Acidity ◽  
Total Pore Volume ◽  
Textural Properties ◽  
Acid Sites ◽  
Adsorption Of Nitrogen ◽  
Amorphous Structures ◽  
Ft Ir ◽  
Catalytic Behaviour ◽  
The Mean

Co3(PO4)2, AlPO4 and the binary system Co3(PO4)2-AlPO4 with different compositions were prepared by the coprecipitation method. The structural properties of these samples were determined using XRD, DTA and FT-IR techniques. The textural properties were determined from the adsorption of nitrogen at 77 K. The surface acidity was measured by a calorimetric titration method. The samples were tested as catalysts in the dehydration of ethanol and isopropanol using a pulse microcatalytic technique. The data obtained from XRD and FT-IR indicate the amorphous structures of the prepared catalysts. An increase in Co3(PO4)2 content led to a decrease in the surface area and in the total pore volume and an increase in the mean pore radius. The surface acidity of the catalyst depends on the chemical composition; the surface acidity increased with an increase in the AlPO4 content. The dehydration temperature and the distribution of acid sites are important parameters in determining the selectivity and activity of the catalyst.

The Synthesis of Iron Oxides with Different Phases or Exposure Crystal Planes and their Catalytic Property for Propene Oxidation

2012 ◽  
Vol 463-464 ◽  
pp. 189-193
Author(s):  
Kong Zhai Li ◽  
Masaaki Haneda ◽  
Masakuni Ozawa
Keyword(s):  
Catalytic Activity ◽  
Iron Oxides ◽  
Catalytic Property ◽  
Significant Influence ◽  
Catalytic Performance ◽  
Selective Growth ◽  
Crystal Plane ◽  
Low Density ◽  
Fe2o3 Nanoparticles ◽  
Propene Oxidation

Maghemite (γ-FeSubscript text2OSubscript text3) and hematite (α-Fe2O3) nanoparticles with various dominant exposure crystal planes were prepared by several different methods. The structure and the reducibility of these materials were investigated by XRD, Raman and H2-TPR technologies, and their catalytic performance for propene oxidation was also discussed. The maghemite (γ-FeSubscript text2OSubscript text3) showed a better reducibility than hematite (α-FeSubscript text2OSubscript text3), but its activity for propene oxidation is relatively lower. The exposure crystal plane of hematite has a significant influence on its catalytic activity for propene oxidation. Among the prepared four samples, the hematite-1 sample showed the best activity. The selective growth of any planes with a relative low density of Fe atoms for the α-FeSubscript text2OSubscript text3 catalyst would lead to an obvious decrease in the catalytic activity.

Effect of TiO2 crystal form on the denitration performance of Ce–W–Ti catalyst

2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Xue Bian ◽  
Yuntao Yu ◽  
Nana Hao ◽  
Wenyuan Wu
Keyword(s):  
Titanium Dioxide ◽  
Mixed Crystal ◽  
Surface Acidity ◽  
High Surface ◽  
Crystal Form ◽  
Large Specific Surface Area ◽  
Metatitanic Acid ◽  
Pure Phase ◽  
Crystal Phases ◽  
Better Than

Abstract Titanium dioxide supports, which were prepared by roasting metatitanic acid under different conditions, were used to prepare a series of Ce–W–Ti catalysts. The structure and denitration properties of the catalyst were studied. The results showed that TiO2 had different crystal types (mixed crystal phases with different proportions of anatase and rutile) under different roasting conditions, and the denitration efficiency of mixed crystal was better than that of pure phase TiO2. Ce–W/200 °C-1 hTiO2 catalyst exhibited a prominent NO conversion rate, and it can reach higher than 90% at a temperature range from 250 to 500°C. The large specific surface area, low content of rutile TiO2 in the support, high content of chemical adsorbed oxygen and high surface acidity were favorable to denitration performance of Ce–W–Ti catalyst.

Sign in / Sign up

Export Citation Format

Share Document