High-Yield Synthesis of AIE-Type Au22(SG)18 Nanoclusters through Precursor Engineering and Its pH-Dependent Size Transformation

2021 ◽  
Vol 125 (7) ◽  
pp. 4066-4076
Author(s):  
Yuvasri Genji Srinivasulu ◽  
Nirmal Goswami ◽  
Qiaofeng Yao ◽  
Jianping Xie
Keyword(s):  
High Yield ◽  
Ph Dependent ◽  
Precursor Engineering

scholarly journals Chiral Amphiphilic Secondary Amine-Porphyrin Hybrids for Aqueous Organocatalysis

Molecules ◽  
2020 ◽  
Vol 25 (15) ◽  
pp. 3420 ◽  
Author(s):  
Aitor Arlegui ◽  
Pol Torres ◽  
Victor Cuesta ◽  
Joaquim Crusats ◽  
Albert Moyano
Keyword(s):  
Catalytic Activity ◽  
High Yield ◽  
Aldol Reactions ◽  
Free Base ◽  
Reaction Products ◽  
Chirality Transfer ◽  
Base Form ◽  
Low Degree ◽  
Acidic Conditions ◽  
Ph Dependent

Two chiral proline-derived amphiphilic 5-substituted-10,15,20-tris(4-sulfonatophenyl)porphyrins were prepared, and their pH-dependent supramolecular behavior was studied. In neutral aqueous solutions, the free-base form of the hybrids is highly soluble, allowing enamine-based organocatalysis to take place, whereas under acidic conditions, the porphyrinic protonated core of the hybrid leads to the formation of self-assembled structures, so that the hybrids flocculate and their catalytic activity is fully suppressed. The low degree of chirality transfer observed for aqueous Michael and aldol reactions strongly suggests that these reactions take place under true “in water” organocatalytic conditions. The highly insoluble catalyst aggregates can easily be separated from the reaction products by centrifugation of the acidic reaction mixtures, and after neutralization and desalting, the sodium salts of the sulfonated amine-porphyrin hybrids, retaining their full catalytic activity, can be recovered in high yield.

Quality films from carbon fiber evaporation for thorough coverage of TEM grids

1988 ◽  
Vol 46 ◽  
pp. 418-419
Author(s):  
N. Tempel ◽  
M. C. Ledbetter
Keyword(s):  
Electron Microscopy ◽  
High Resolution Electron Microscopy ◽  
Carbon Films ◽  
Low Noise ◽  
Vacuum Evaporation ◽  
High Yield ◽  
Good Adhesion ◽  
Noise Structure ◽  
Resolution Electron ◽  
Carbon Foils

Carbon films have been a support of choice for high resolution electron microscopy since the introduction of vacuum evaporation of carbon. The desirable qualities of carbon films and methods of producing them has been extensively reviewed. It is difficult to get a high yield of grids by many of these methods, especially if virtually all of the windows must be covered with a tightly bonded, quality film of predictable thickness. We report here a method for producing carbon foils designed to maximize these attributes: 1) coverage of virtually all grid windows, 2) freedom from holes, wrinkles or folds, 3) good adhesion between film and grid, 4) uniformity of film and low noise structure, 5) predictability of film thickness, and 6) reproducibility.Our method utilizes vacuum evaporation of carbon from a fiber onto celloidin film and grid bars, adhesion of the film complex to the grid by carbon-carbon contact, and removal of the celloidin by acetone dissolution. Materials must be of high purity, and cleanliness must be rigorously maintained.

Effects of high pressure on the crystallization of carbon fiber reinforced polyetheretherketone (CF/PEEK) laminate composites

1990 ◽  
Vol 48 (4) ◽  
pp. 876-877
Author(s):  
Hong-Ming Lin ◽  
C. H. Liu ◽  
R. F. Lee
Keyword(s):  
High Pressure ◽  
Carbon Fiber ◽  
Sample Surface ◽  
High Yield ◽  
Fiber Reinforced ◽  
Laminate Composites ◽  
Peek Composite ◽  
Continuous Carbon Fiber ◽  
Carbon Fiber Reinforced

Polyetheretherketone (PEEK) is a crystallizable thermoplastic used as composite matrix materials in application which requires high yield stress, high toughness, long term high temperature service, and resistance to solvent and radiation. There have been several reports on the crystallization behavior of neat PEEK and of CF/PEEK composite. Other reports discussed the effects of crystallization on the mechanical properties of PEEK and CF/PEEK composites. However, these reports were all concerned with the crystallization or melting processes at or close to atmospheric pressure. Thus, the effects of high pressure on the crystallization of CF/PEEK will be examined in this study.The continuous carbon fiber reinforced PEEK (CF/PEEK) laminate composite with 68 wt.% of fibers was obtained from Imperial Chemical Industry (ICI). For the high pressure experiments, HIP was used to keep these samples under 1000, 1500 or 2000 atm. Then the samples were slowly cooled from 420 °C to 60 °C in the cooling rate about 1 - 2 degree per minute to induce high pressure crystallization. After the high pressure treatment, the samples were scanned in regular DSC to study the crystallinity and the melting temperature. Following the regular polishing, etching, and gold coating of the sample surface, the scanning electron microscope (SEM) was used to image the microstructure of the crystals. Also the samples about 25mmx5mmx3mm were prepared for the 3-point bending tests.

Catalytic enantioselective synthesis of indolizino[8,7-b]indole alkaloid derivatives based on the tandem reaction of tertiary enamides

2021 ◽  
Author(s):  
Xin-Ming Xu ◽  
Ming Xie ◽  
Jiazhu Li ◽  
Mei-Xiang Wang
Keyword(s):  
Indole Alkaloid ◽  
Enantioselective Synthesis ◽  
High Yield ◽  
Tandem Reaction ◽  
Indole Derivatives

An exquisite Pybox/Cu(OTf)2-catalyzed asymmetric tandem reaction of tertiary enamides was developed, which enabled the expeditious synthesis of indolizino[8,7-b]indole derivatives in high yield, excellent enantioselectivity and diastereoselectivity.

The Reaction of Thiol Compounds with the Vitamin-K Dependent Clotting Factors

1969 ◽  
Vol 21 (03) ◽  
pp. 573-579 ◽  
Author(s):  
P Fantl
Keyword(s):  
Prothrombin Time ◽  
Vitamin K ◽  
Anaerobic Conditions ◽  
Clotting Factors ◽  
Thiol Compounds ◽  
Aerobic Conditions ◽  
One Stage ◽  
Factor Ii ◽  
Ph Dependent ◽  
The One

SummaryTreatment of human and dog oxalated plasma with 0.2 to 1.0 × 10−1 M 2.3-dithiopropanol (BAL) or dithiothreitol (DTT) at 2–4° C for 30 min results in the reduction of the vitamin-K dependent clotting factors II, VII, IX and X to the respective-SH derivatives. The reaction is pH dependent. Under aerobic conditions the delayed one stage prothrombin time can be partly reversed. Under anaerobic conditions a gradual prolongation of the one stage prothrombin time occurs without reversal.In very diluted plasma treated with the dithiols, prothrombin can be converted into thrombin if serum as source of active factors VII and X is added. In contrast SH factors VII, IX and X are inactive in the specific tests. Reoxidation to active factors II, VII, IX and X takes place during adsorption and elution of the SH derivatives. The experiments have indicated that not only factor II but also factors VII, IX and X have active-S-S-centres.

Purification of Urokinase from Complex Mixtures Using Immobilized Monoclonal Antibody Against Urokinase Light Chain

1983 ◽  
Vol 49 (01) ◽  
pp. 024-027 ◽  
Author(s):  
David Vetterlein ◽  
Gary J Calton
Keyword(s):  
Monoclonal Antibody ◽  
Light Chain ◽  
Culture Media ◽  
Biological Fluids ◽  
Single Step ◽  
High Yield ◽  
Step Method ◽  
Commercial Preparation ◽  
E Coli ◽  
Tissue Culture Media

SummaryThe preparation of a monoclonal antibody (MAB) against high molecular weight (HMW) urokinase light chain (20,000 Mr) is described. This MAB was immobilized and the resulting immunosorbent was used to isolate urokinase starting with an impure commercial preparation, fresh urine, spent tissue culture media, or E. coli broth without preliminary dialysis or concentration steps. Monospecific antibodies appear to provide a rapid single step method of purifying urokinase, in high yield, from a variety of biological fluids.

FloRunTM ‘331’ Peanut Variety

EDIS ◽  
2019 ◽  
Vol 2019 (1) ◽  
Author(s):  
Barry L. Tillman
Keyword(s):  
Seed Size ◽  
Growth Habit ◽  
Yield Potential ◽  
High Yield ◽  
University Of Florida ◽  
High Oleic ◽  
Central Stem ◽  
Research And Education ◽  
The University ◽  
High Yield Potential

FloRunTM ‘331’ peanut variety was developed by the University of Florida, Institute of Food and Agricultural Sciences, North Florida Research and Education Center near Marianna, Florida.  It was released in 2016 because it combines high yield potential with excellent disease tolerance. FloRunTM ‘331’ has a typical runner growth habit with a semi-prominent central stem and medium green foliage.  It has medium runner seed size with high oleic oil chemistry.

Sign in / Sign up

Export Citation Format

Share Document