Determination of the Coverage of Phosphatidylcholine Monolayers Formed at Silicone Oil–Water Interfaces by Vesicle Fusion

2020 ◽  
Vol 124 (39) ◽  
pp. 8719-8727
Author(s):  
Chiho Kataoka-Hamai ◽  
Kohsaku Kawakami
1991 ◽  
Vol 56 (1) ◽  
pp. 112-129 ◽  
Author(s):  
Takashi Kakiuchi ◽  
Mitsugi Senda

We have estimated the degree of polarizability of a polarized oil-water interface used as a working interface and that of the nonpolarizability of a nonpolarized interface used as a reference oil-water interface from the numerical calculation of dc and ac current vs potential behavior at both interfaces. Theoretical equations of dc and ac currents for simultaneous cation and anion transfer of supporting electrolytes have been derived for the planar stationary interface for reversible and quasi-reversible cases. In the derivation, the migration effect and the coupling of the cation and anion transfer have been incorporated. The transfer of ions constituting a supporting electrolyte contributes to the total admittance of the interface even in the region where the interface may be considered as polarized in dc sense, as pointed out first by Samec et al. (J. Electroanal. Chem. 126, 121 (1981)). Moreover, the reference oil-water interface is not ideally reversible, so that the contribution from this interface to the measured admittance cannot be negligible, unless the area of the reference oil-water interface is much larger than that of the working oil-water interface. The effect of non-ideality of the reference oil-water interface on the determination of double layer capacitances and kinetic parameters of charge transfer at the working oil-water interface has been estimated.


2021 ◽  
Vol 8 (1) ◽  
Author(s):  
Yuanli Chen ◽  
Hui Fan ◽  
Xinlin Zha ◽  
Wenwen Wang ◽  
Yi Wu ◽  
...  

AbstractHigh efficiency and anti-pollution oil/water separation membrane has been widely explored and researched. There are a large number of hydroxyl groups on the surface of silica, which has good wettability and can be used for oil-water separation membranes. Hydrophilic silica nanostructures with different morphologies were synthesized by changing templates and contents of trimethylbenzene (TMB). Here, silica nanospheres with radical pores, hollow silica nanospheres and worm-like silica nanotubes were separately sprayed on the PVA-co-PE nanofiber membrane (PM). The abundance of hydroxyl groups and porous structures on PM surfaces enabled the absorption of silica nanospheres through hydrogen bonds. Compared with different silica nanostructures, it was found that the silica/PM exhibited excellent super-hydrophilicity in air and underwater “oil-hating” properties. The PM was mass-produced in our lab through melt-extrusion-phase-separation technique. Therefore, the obtained membranes not only have excellent underwater superoleophobicity but also have a low-cost production. The prepared silica/PM composites were used to separate n-hexane/water, silicone oil/water and peanut oil water mixtures via filtration. As a result, they all exhibited efficient separation of oil/water mixture through gravity-driven filtration.


1975 ◽  
Vol 145 (3) ◽  
pp. 417-429 ◽  
Author(s):  
J E Barnett ◽  
G D Holman ◽  
R A Chalkley ◽  
K A Munday

6-O-methyl-, 6-O-propyl-, 6-O-pentyl- and 6-O-benzyl-D-galactose, and 6-O-methyl-, 6-O-propyl- and 6-O-pentyl-D-glucose inhibit the glucose-transport system of the human erythrocyte when added to the external medium. Penetration of 6-O-methyl-D-galactose is inhibited by D-glucose, suggesting that it is transported by the glucose-transport system, but the longer-chain 6-O-alkyl-D-galactoses penetrate by a slower D-glucose-insensitive route at rates proportional to their olive oil/water partition coefficients. 6-O-n-Propyl-D-glucose and 6-O-n-propyl-D-galactose do not significantly inhibit L-sorbose entry or D-glucose exit when present only on the inside of the cells whereas propyl-beta-D-glucopyranoside, which also penetrates the membrane slowly by a glucose-insensitive route, only inhibits L-sorbose entry or D-glucose exit when present inside the cells, and not when on the outside. The 6-O-alkyl-D-galactoses, like the other nontransported C-4 and C-6 derivatives, maltose and 4,6-O-ethylidene-D-glucose, protect against fluorodinitrobenzene inactivation, whereas propyl beta-D-glucopyranoside stimulates the inactivation. Of the transported sugars tested, those modified at C-1, C-2 and C-3 enhance fluorodinitrobenzene inactivation, where those modified at C-4 and C-6 do not, but are inert or protect against inactivation. An asymmetric mechanism is proposed with two conformational states in which the sugar binds to the transport system so that C-4 and C-6 are in contact with the solvent on the outside and C-1 is in contact with the solvent on the inside of the cell. It is suggested that fluorodinitrobenzene reacts with the form of the transport system that binds sugars at the inner side of the membrane. An Appendix describes the theoretical basis of the experimental methods used for the determination of kinetic constants for non-permeating inhibitors.


2018 ◽  
pp. 28-37
Author(s):  
Piotr Pacholski ◽  
Jerzy Sęk

The wastewater produced by the metal industry is often present in the form of oil-in-water (O/W) or water-in- oil (W/O) emulsions. These fluids contain a certain amount of valuable oil that can be recovered in the recycling process. Therefore, the development of novel, efficient, and low cost processes for the treatment of metalworking fluid is necessary. Demulsification to separate oil/water mixtures is a very interesting option because it allows the recovery and reuse of the lubricant oil and effects in cleaner, easily treatablemwastewater.Chemical destabilization is the most common way of demulsification of metalworking fluids. As an example, inorganic salts can be used as demulsifiers. In the presented work the efficiency of treatment of cutting emulsions with chemical demulsification with usage of aluminum sulfate (IV) is described. The emulsion was prepared with Emulgol-ES12 self-emulsyfing oil delivered by Orlen S.A. In the research the feasibility of the demulsifier was checked.The novel in this paper is determination of the optimal dosage of emulsifier using the TurbiscanLab® apparatus. It is relatively quick and precise method that can be applied in the industry.


Author(s):  
Hooman Foroughi ◽  
Masahiro Kawaji

The flow characteristics of a highly viscous oil and water mixture in a circular microchannel have been investigated. Water and silicone oil with a viscosity of 863 mPa.s were injected into a fused silica microchannel with a diameter of 250 μm. Before each experiment, the microchannel was initially saturated with either oil or water. In the initially oil-saturated case, different liquid-liquid flow patterns were observed and classified over a wide range of oil and water flow rates. As a special case, the flow of water at zero oil flow rate in a microchannel initially filled with silicone oil was also studied. When the microchannel was initially saturated with water, the oil formed a jet in water at the injection point but developed an instability at the oil-water interface downstream and eventually broke up into droplets.


Sign in / Sign up

Export Citation Format

Share Document