Acetonitrile Dehydration via Extractive Distillation Using Low Transition Temperature Mixtures as Entrainers

2018 ◽  
Vol 63 (8) ◽  
pp. 2921-2930 ◽  
Author(s):  
Bandhana Sharma ◽  
Neetu Singh ◽  
Tarun Jain ◽  
Jai Prakash Kushwaha ◽  
Parminder Singh
Keyword(s):  
Transition Temperature ◽  
Extractive Distillation

Low transition temperature mixtures (LTTMs) as novel entrainers in extractive distillation

2015 ◽  
Vol 385 ◽  
pp. 72-78 ◽  
Author(s):  
Nerea R. Rodríguez ◽  
Agustin S.B. González ◽  
Patricia M.A. Tijssen ◽  
Maaike C. Kroon
Keyword(s):  
Transition Temperature ◽  
Extractive Distillation

In situ Tensile Experiments at Low Temperatures on Niobium Single Crystals by H.V.E.M.

1975 ◽  
Vol 33 ◽  
pp. 58-59
Author(s):  
F. H. Louchet ◽  
L. P. Kubin
Keyword(s):  
Electron Microscope ◽  
Transition Temperature ◽  
Low Temperature ◽  
Slip System ◽  
Low Temperatures ◽  
Tensile Axis ◽  
Image Intensifier ◽  
Screw Dislocations ◽  
Source Operation

Experiments have been carried out on the 3 MeV electron microscope in Toulouse. The low temperature straining holder has been previously described Images given by an image intensifier are recorded on magnetic tape.The microtensile niobium samples are cut in a plane with the two operative slip directions [111] and lying in the foil plane. The tensile axis is near [011].Our results concern:- The transition temperature of niobium near 220 K: at this temperature and below an increasing difference appears between the mobilities of the screw and edge portions of dislocations loops. Source operation and interactions between screw dislocations of different slip system have been recorded.

The structure of membranes and membrane proteins embedded in amorphous ice

1992 ◽  
Vol 50 (1) ◽  
pp. 432-433
Author(s):  
Uwe Lücken ◽  
Joachim Jäger
Keyword(s):  
Phase Transition ◽  
Transition Temperature ◽  
Membrane Proteins ◽  
Phase Transition Temperature ◽  
Lipid Vesicles ◽  
Freezing Stress ◽  
Amorphous Ice ◽  
Different Temperatures ◽  
Band Pass ◽  
Lipid Polymorphism

TEM imaging of frozen-hydrated lipid vesicles has been done by several groups Thermotrophic and lyotrophic polymorphism has been reported. By using image processing, computer simulation and tilt experiments, we tried to learn about the influence of freezing-stress and defocus artifacts on the lipid polymorphism and fine structure of the bilayer profile. We show integrated membrane proteins do modulate the bilayer structure and the morphology of the vesicles.Phase transitions of DMPC vesicles were visualized after freezing under equilibrium conditions at different temperatures in a controlled-environment vitrification system. Below the main phase transition temperature of 24°C (Fig. 1), vesicles show a facetted appearance due to the quasicrystalline areas. A gradual increase in temperature leads to melting processes with different morphology in the bilayer profile. Far above the phase transition temperature the bilayer profile is still present. In the band-pass-filtered images (Fig. 2) no significant change in the width of the bilayer profile is visible.

A SIMPLE QUALITATIVE DETERMINATION OF JOSEPHSON TUNNEL JUNCTION PARAMETERS NEAR THE TRANSITION TEMPERATURE

1978 ◽  
Vol 39 (C6) ◽  
pp. C6-1232-C6-1233 ◽  
Author(s):  
N. F. Pedersen ◽  
J. Mygind ◽  
O. H. Soerensen ◽  
B. Dueholm
Keyword(s):  
Transition Temperature ◽  
Tunnel Junction ◽  
Josephson Tunnel ◽  
Qualitative Determination

COMPUTER MODELING OF CHEMICAL EQUILIBRIUMS IN WO3–H2O SYSTEM

2017 ◽  
pp. 35-48 ◽  
Author(s):  
V.P. Bondarenko ◽  
O.O. Matviichuk
Keyword(s):  
Transition Temperature ◽  
Gas Phase ◽  
Single Phase ◽  
Reference Data ◽  
Maximum Amount ◽  
Reaction Products ◽  
Influence Of Temperature ◽  
Equilibrium Chemical ◽  
Program Data ◽  
Good Agreement

Detail investigation of equilibrium chemical reactions in WO3–H2O system using computer program FacktSage with the aim to establish influence of temperature and quantity of water on formation of compounds of H2WO4 and WO2(OH)2 as well as concomitant them compounds, evaporation products, decomposition and dissociation, that are contained in the program data base were carried out. Calculations in the temperature range from 100 to 3000 °С were carried out. The amount moles of water added to 1 mole of WO3 was varied from 0 to 27. It is found that the obtained data by the melting and evaporation temperatures of single-phase WO3 are in good agreement with the reference data and provide additionally detailed information on the composition of the gas phase. It was shown that under heating of 1 mole single-phase WO3 up to 3000 °С the predominant oxide that exist in gaseous phase is (WO3)2. Reactions of it formation from other oxides ((WO3)3 and (WO3)4) were proposed. It was established that compound H2WO4 is stable and it is decomposed on WO3 and H2O under 121 °C. Tungsten Oxide Hydrate WO2(OH)2 first appears under 400 °С and exists up to 3000 °С. Increasing quantity of Н2О in system leads to decreasing transition temperature of WO3 into both liquid and gaseous phases. It was established that adding to 1 mole WO3 26 mole H2O maximum amount (0,9044–0,9171 mole) WO2(OH)2 under temperatures 1400–1600 °С can be obtained, wherein the melting stage of WO3 is omitted. Obtained data also allowed to state that that from 121 till 400 °С WO3–Н2O the section in the О–W–H ternary system is partially quasi-binary because under these temperatures in the system only WO3 and Н2O are present. Under higher temperatures WO3–Н2O section becomes not quasi-binary since in the reaction products WO3 with Н2O except WO3 and Н2O, there are significant amounts of WO2(OH)2, (WO3)2, (WO3)3, (WO3)4 and a small amount of atoms and other compounds. Bibl. 12, Fig. 6, Tab. 5.

Sign in / Sign up

Export Citation Format

Share Document