Differential, Alkalimetric Determination of Sulfuric Acid-Hydrochloric Acid and Sulfuric Acid-Nitric Acid Mixtures

1954 ◽  
Vol 26 (11) ◽  
pp. 1803-1806 ◽  
Author(s):  
F. E. Critchfield ◽  
J. B. Johnson
1940 ◽  
Vol 13 (2) ◽  
pp. 430-436
Author(s):  
P. Dekker

Abstract A scheme for the determination of manganese in mineral fillers, compounding ingredients, crude rubber, rubber mixtures and rubberized materials is described. It is shown that with this method the use of potassium persulfate and two drops of orthophosphoric acid, as proposed by Kehren for the oxidation of colorless manganese ions to red permanganate ions, is advisable. When potassium periodate is used, small quantities of manganese escape detection. It is further shown that there is no appreciable difference between concentration with nitric acid and evaporation with hydrochloric acid and a little sulfuric acid. If, however, the ash is decomposed by soda-potash mixture, the manganese contents are considerably higher. Doubtless these higher values can be accounted for by manganese compounds which are occluded in silicates, and which can be regarded as harmless. A reliable method for the decomposition of the manganese compounds is therefore desirable. The results of analyses of the manganese contents of a large number of various materials are tabulated, and the maximum manganese contents of various materials allowed by the Netherlands Government Rubber Institute are given.


1960 ◽  
Vol 38 (9) ◽  
pp. 1488-1494 ◽  
Author(s):  
E. J. Bounsall ◽  
W. A. E. McBryde

An analytical method is described for the determination of microgram amounts of silver in galena ores, based on the "reversion" of silver dithizonate. Silver is separated from relatively large amounts of lead by extraction as dithizonate into chloroform from an aqueous 1:99 nitric acid solution. Separation from mercury, which is also extracted under these conditions and would, if present, interfere in the analysis, is achieved by reverting the dithizonate solution with a 5% aqueous sodium chloride solution which is also 0.015 molar in hydrochloric acid. Following dilution of this aqueous solution and adjustment of pH, silver is again extracted into chloroform as the dithizonate, and determined absorptiometrically. Analyses of a number of galena ore samples showed a precision of within 3% for a silver content ranging from 0.03 to 0.4%.Some other methods for isolating silver from these samples, which were tried but found unsatisfactory, are discussed.


2019 ◽  
Vol 3 (2) ◽  
pp. 45 ◽  
Author(s):  
Jahromi ◽  
Ghahreman

Carbon-based catalysts can assist the oxidative leaching of sulfide minerals. Recently, we presented that AF 5 Lewatit® is among the catalysts with superior enargite oxidation capacity and capability to collect elemental sulfur on its surface. Herein, the effect of acid pre-treatment of the AF 5 catalyst was studied on the AF 5 surface, to further enhance the catalytic properties of AF 5. The AF 5 catalyst was pretreated by hydrochloric acid, nitric acid and sulfuric acid. The results showed that the acid treatment drastically changes the surface properties of AF 5. For instance, the concentration of quinone-like functional groups, which are ascribed to the catalytic properties of AF 5, is 45.4% in the sulfuric acid pre-treatment AF 5 and only 29.8% in the hydrochloric acid-treated AF 5. Based on the C 1s X-ray photoelectron spectroscopy (XPS) results the oxygenated carbon is 30.6% in the sulfuric acid-treated AF 5, 29.2% in the nitric acid-treated AF 5 and 28.3% in the hydrochloric acid-treated AF 5. The nitric acid pre-treated AF 5 resulted in the highest copper recovery during the oxidative enargite leaching process, recovering 98.8% of the copper. The sulfuric acid-treated AF 5 recovered 97.1% of the enargite copper into the leach solution. Among different leaching media and pre-treatment the lowest copper recovery was achieved with the HCl pre-treated AF 5 which was 88.6%. The pre-treatment of AF 5 with acids also had modified its elemental sulfur adsorption capacity, where the sulfur adsorption on AF 5 was increased from 30.9% for the HCl treated AF 5 to 51.1% for the sulfuric acid-treated AF 5.


2020 ◽  
Vol 1001 ◽  
pp. 139-144
Author(s):  
Ying Li ◽  
Ben Tao Li ◽  
Guang Yu Sun ◽  
Hui Huang ◽  
Chen Gong ◽  
...  

The influence of different acidic medium, including hydrochloric acid, nitric acid and perchloric acid on the absorbance of sodium by flame atomic absorption spectrometry was studied. The results showed that the effects of acidic medium and water on the determination of sodium were as follows: hydrochloric acid > perchloric acid > nitric acid > water. Acid effect changed with the increase of acid concentration, however, the absorbance value of sodium element decreased when the concentration of acid was higher than 1%~2%. This effect was more obvious for high content of sodium. The detection limits, repeatability and recovery of the samples under the three acidic medium were compared. The optimum acid conditions were determined and the sensitivity of the method was improved.


1955 ◽  
Vol 38 (5) ◽  
pp. 581-598 ◽  
Author(s):  
Margaret R. McDonald

The proteolytic activity of dilute solutions of clystalline trypsin is destroyed by x-rays, the amount of inactivation being an exponential function of the radiation dose. The reaction yield increases steadily with increasing concentration of trypsin, varying, as the concentration of enzyme is increased from 1 to 300 µM, from 0.068 to 0.958 micromole of trypsin per liter inactivated per 1000 r with 0.005 N hydrochloric acid as the solvent, from 0.273 to 0.866 with 0.005 N sulfuric acid as the solvent, and from 0.343 to 0.844 with 0.005 N nitric acid as the solvent. When the reaction yields are plotted as a function of the initial concentration of trypsin, they fall on a curve given by the expression Y α XK, in which Y is the reaction yield, X is the concentration of trypsin, and K is a constant equal to 0.46, 0.20, and 0.16, respectively, with 0.005 N hydrochloric, sulfuric, and nitric acids as solvents. The differences between the reaction yields found with chloride and sulfate ions in I to 10 µM trypsin solutions are significant only in the pH range from 2 to 4. The amount of inactivation obtained with a given dose of x-rays depends on the pH of the solution being irradiated and the nature of the solvent. The reaction yield-pH curve is a symmetrical one, with minimum yields at about pH 7. Buffers such as acetate, citrate, borate and barbiturate, and other organic molecules such as ethanol and glucose, in concentrations as low as 20 µM, inhibit the inactivation of trypsin by x-radiation. Sigmoid inactivation-dose curves instead of exponential ones are obtained in the presence of ethanol. The reaction yields for the inactivation of trypsin solutions by x-rays are approximately 1.5 times greater when the irradiation is done at 26°C. than when it is done at 5°C., when 0.005 N hydrochloric acid is the solvent. The dependence on temperature is less when 0.005 N sulfuric acid is used, and is negligible with 0.005 N nitric acid. The difficulties involved in interpreting radiation effects in aqueous systems, and in comparing the results obtained under different experimental conditions, are discussed.


1986 ◽  
Vol 40 (4) ◽  
pp. 445-460 ◽  
Author(s):  
S. H. Tan ◽  
G. Horlick

Basic background mass spectra of the inductively coupled plasma are presented in this report. The background spectral features were measured for the nebulization of water and for 5% solutions of nitric acid, hydrochloric acid, and sulfuric acid. Background spectra are presented for all these solutions for the mass range 1 to 84 amu, and extensive tables are presented for observed species and their isotopic combinations.


2014 ◽  
Vol 722 ◽  
pp. 22-24
Author(s):  
Bo Wen Yang ◽  
Ping Zhou ◽  
Wan Chao Jin

The phosphate is low silicon carbonate collophane, gangue mainly dolomite. determine one-stage roughing and one-stage scavenging reverse flotation test process,the grinding fineness of 92.86% -200 mesh.Collector with paraffin soap oxidated,Three acid of sulfuric acid, hydrochloric acid, nitric acid as an inhibitor for contrast test,With concentration of 10% sulfuric acid 10000 g/t can research qualified phosphate product with content of 33.95% in concentration and recovery of 62.06%.


CORROSION ◽  
1959 ◽  
Vol 15 (12) ◽  
pp. 29-35 ◽  
Author(s):  
ROBERT E. BARNETT ◽  
THOMAS F. ANDERSON

Abstract Polyesters used in situations where their chemical resistance is important are grouped into five types for convenience in considering their value under attack by industrial corrosives at varying temperatures. Data were compiled from information supplied by four of the major producers on polyester ducts, hoods and tanks as were 17 illustrations of equipment. Pictured equipment is described, environment indicated and durability reported. Corrodents involved include sulfonated fish oil, acidified oils, HCl containing benzene, nitric acid, hydrochloric acid and fumes, plating solutions, sulfuric acid and others at varying temperatures. Some of the characteristics of and reasons for using lined equipment are given. The appendix consists of four tables in which polyesters are rated for service as open hoods and connecting ductwork and for tanks against a wide variety of industrial corrosives, plating solutions pickling and dipping solutions and stripping solutions. Over 5000 ratings are given as excellent, good, fair, poor and not recommended at temperatures of 80 F or less, 212 F or boiling point of solution, if lower: 160 F. 180 F. 6.6.8


Sign in / Sign up

Export Citation Format

Share Document