An Expert System for Chemical Speciation of Individual Particles Using Low-ZParticle Electron Probe X-ray Microanalysis Data

2004 ◽  
Vol 76 (5) ◽  
pp. 1322-1327 ◽  
Author(s):  
Chul-Un Ro ◽  
HyeKyeong Kim ◽  
René Van Grieken
2020 ◽  
Vol 26 (3) ◽  
pp. 469-483
Author(s):  
Nicholas W. M. Ritchie

AbstractThis is the first in a series of articles which present a new framework for computing the standard uncertainty in electron excited X-ray microanalysis measurements. This article will discuss the framework and apply it to a handful of simple, but useful, subcomponents of the larger problem. Subsequent articles will handle more complex aspects of the measurement model. The result will be a framework in which sophisticated and practical models of the uncertainty for real-world measurements. It will include many long overlooked contributions like surface roughness and coating thickness. The result provides more than just error bars for our measurements. It also provides a framework for measurement optimization and, ultimately, the development of an expert system to guide both the novice and expert to design more effective measurement protocols.


2001 ◽  
Vol 35 (29) ◽  
pp. 4995-5005 ◽  
Author(s):  
Chul-Un Ro ◽  
Keun-Young Oh ◽  
HyeKyeong Kim ◽  
Youngsin Chun ◽  
János Osán ◽  
...  

1998 ◽  
Vol 4 (S2) ◽  
pp. 184-185
Author(s):  
J. A. Small ◽  
J. A. Armstrong ◽  
D. S. Bright ◽  
B. B. Thorne

The addition of the Si-Li detector to the electron probe, the scanning electron microscope, and more recently the transmission electron microscope (resulting in the analytical electron microscope) has made it possible to obtain elemental analysis on individual “particles” with dimensions less than 1 nm using EDS. Although some initial particle studies on micrometer-sized particles were done on the electron probe using wavelength dispersive spectrometers, WDS, the variability and complexity of many particle compositions coupled with the high currents necessary for WDS made elemental analysis of particles by WDS difficult at best. In addition, the use of multiple spectrometers, each with a different view of the particle and therefore different particle geometry as shown in Fig. 1, limited the quantitative capabilities of the technique. With the introduction of the Si-Li detector, there was only one spectrometer with a single geometry resulting in the development of various procedures for obtaining quantitative elemental analysis of the individual particles.


2006 ◽  
Vol 157 (3-4) ◽  
pp. 121-126 ◽  
Author(s):  
Mikhail Y. Semenov ◽  
Zoya Spolnik ◽  
René Van Grieken

Micron ◽  
2003 ◽  
Vol 34 (1) ◽  
pp. 49-55 ◽  
Author(s):  
O.Yu. Belozerova ◽  
A.L. Finkelshtein ◽  
L.A. Pavlova

2001 ◽  
Vol 30 (6) ◽  
pp. 419-426 ◽  
Author(s):  
J. Osán ◽  
J. de Hoog ◽  
P. Van Espen ◽  
I. Szalóki ◽  
C.-U. Ro ◽  
...  

2006 ◽  
Vol 21 (2) ◽  
pp. 140-144 ◽  
Author(s):  
Chul-Un Ro

An electron probe X-ray microanalysis (EPMA) technique using an energy-dispersive X-ray detector with an ultrathin window, designated low-Z particle EPM, has been developed. The low-Z particle EPMA allows the quantitative determination of concentrations of low-Z elements, such as C, N, and O, as well as higher-Z elements that can be analyzed by conventional energy-dispersive EPMA. The quantitative determination of low-Z elements (using full Monte Carlo simulations, from the electron impact to the X-ray detection) in individual environmental particles has improved the applicability of single-particle analysis, especially in atmospheric environmental aerosol research; many environmentally important atmospheric particles, e.g. sulfates, nitrates, ammonium, and carbonaceous particles, contain low-Z elements. The low-Z particle EPMA was applied to characterize loess soil particle samples of which the chemical compositions are well defined by the use of various bulk analytical methods. Chemical compositions of the loess samples obtained from the low-Z particle EPMA turn out to be close to those from bulk analyses. In addition, it is demonstrated that the technique can also be used to assess the heterogeneity of individual particles.


Sign in / Sign up

Export Citation Format

Share Document