Odd-viscosity-induced stabilization of viscous thin liquid films

2019 ◽  
Vol 878 ◽  
pp. 169-189
Author(s):  
E. Kirkinis ◽  
A. V. Andreev

Thin viscous liquid films sitting on a solid substrate support nonlinear capillary waves, driven by surface shear stresses at a liquid–gas interface. When surface tension is spatially dependent other mechanisms, such as the thermocapillary effect, influence the dynamics of thin films. In this article we show that in liquids with broken time-reversal symmetry the character of the aforementioned waves and of the thermocapillary effect are significantly modified due to the presence of odd or Hall viscosity in the liquid. This is because odd viscosity gives rise to new terms in the pressure gradient of the flow thus modifying the evolution equation of the liquid–gas interface accordingly. These terms in turn break the reflection symmetry of the evolution equation leading the system to evolve from a pitchfork to a Hopf bifurcation. The odd-viscosity incipient waves can stabilize unstable thin liquid films. For instance, we show that they can suppress the thermocapillary instability. We establish the parameter ranges that odd viscosity has to satisfy in order to initiate those waves that will lead to stability.

2019 ◽  
Vol 872 ◽  
pp. 308-326 ◽  
Author(s):  
E. Kirkinis ◽  
A. V. Andreev

Thin liquid films sitting on a heated solid substrate and surrounded by a colder ambient gas phase are strongly affected by surface-shear stresses induced by surface tension and temperature gradients, as well as by viscous and capillary forces. The temperature dependence of surface tension may lead to thinning of liquid-film depressions promoting instability which takes place when a critical temperature difference $\unicode[STIX]{x0394}\unicode[STIX]{x1D717}_{cr}$ between the substrate and the ambient gas phase is exceeded. In this article we show theoretically that viscous heating, previously neglected in related literature, may delay or suppress the thermocapillary instability and leads to film healing. The viscous heating effect, by inhibiting heat transfer, prevents the system from reaching the critical value $\unicode[STIX]{x0394}\unicode[STIX]{x1D717}_{cr}$ required to bring about instability. As a consequence, the system remains within the stability region, suppressing film rupture. The presence of the viscous heating effect leads to a persistent circulating motion of two counter-rotating vortices lying diametrically opposite to a depression of the liquid–gas interface reducing the wavelength of disturbances to one half of its initial value. This effect has yet to be observed in experiment.


Langmuir ◽  
1995 ◽  
Vol 11 (7) ◽  
pp. 2806-2814 ◽  
Author(s):  
Rachel Yerushalmi-Rozen ◽  
Jacob Klein

2004 ◽  
Vol 14 (12) ◽  
pp. 4117-4141 ◽  
Author(s):  
O. GOTTLIEB ◽  
ALEXANDER ORON

We investigate the stability and bifurcations of parametrically excited thin liquid films. A recently derived nonlinear evolution equation for the two-dimensional spatio-temporal dynamics of falling liquid films on an oscillating vertical wall is expanded to low order Fourier modes. A fourth-order modal dynamical system is validated to yield the primary bifurcation structure of the fundamental falling film dynamics described by the Benney equation, and accurately predicts the quasi-periodic structure of the temporally modulated Benney equation (TMBE). The stability of fundamental steady and periodic solutions is analytically and numerically investigated so as to reveal the threshold for nonstationary and chaotic solutions corresponding to aperiodic modulated traveling waves. The reduced modal dynamical system enables construction of a comprehensive bifurcation structure, which is verified by numerical simulation of the evolution equation.


2010 ◽  
Vol 22 (2) ◽  
pp. 022002 ◽  
Author(s):  
A. M. Willis ◽  
J. B. Freund

2015 ◽  
Vol 17 (5) ◽  
pp. 1301-1319 ◽  
Author(s):  
A. L. Kupershtokh ◽  
E. V. Ermanyuk ◽  
N. V. Gavrilov

AbstractThis paper presents a numerical and experimental study on hydrodynamic behavior of thin liquid films in rectangular domains. Three-dimensional computer simulations were performed using the lattice Boltzmann equation method (LBM). The liquid films laying on solid and liquid substrates are considered. The rupture of liquid films in computations is initiated via the thermocapillary (Marangoni) effect by applying an initial spatially localized temperature perturbation. The rupture scenario is found to depend on the shape of the temperature distribution and on the wettability of the solid substrate. For a wettable solid substrate, complete rupture does not occur: a residual thin liquid film remains at the substrate in the region of pseudo-rupture. For a non-wettable solid substrate, a sharp-peaked axisymmetric temperature distribution induces the rupture at the center of symmetry where the temperature is maximal. Axisymmetric temperature distribution with a flat-peaked temperature profile initiates rupture of the liquid film along a circle at some distance from the center of symmetry. The outer boundary of the rupture expands, while the inner liquid disk transforms into a toroidal figure and ultimately into an oscillating droplet.We also apply the LBM to simulations of an evolution of one or two holes in liquid films for two-layer systems of immiscible fluids in a rectangular cell. The computed patterns are successfully compared against the results of experimental visualizations. Both the experiments and the simulations demonstrate that the initially circular holes evolved in the rectangular cell undergoing drastic changes of their shape under the effects of the surface tension and gravity. In the case of two interacting holes, the disruption of the liquid bridge separating two holes is experimentally observed and numerically simulated.


1979 ◽  
Vol 101 (4) ◽  
pp. 712-717 ◽  
Author(s):  
E. Ihnatowicz ◽  
S. Gumkowski ◽  
J. Mikielewicz

An experimental investigation of a thin water film driven by steam, its evaporation and breakdown, was carried out. The shear stresses, the main factor influencing the film motion, were calculated as a function of the “blowing parameter”. The influence of the blowing parameter on evaporation and breakdown of the film was investigated. The results obtained are in agreement with a theoretical analysis which included the effects of the evaporating mass stream and of small droplets within the vapor boundary layer.


Author(s):  
E. Kirkinis ◽  
S. H. Davis

In recent years, there has been great interest in using control theory to alter the stability regimes of fluid systems. A flow property is measured at a point and relayed back to a control that alters a condition that opposes the instability, thereby postponing its onset. Here, we discuss an alternative to postponing and even eliminating instabilities without the need for measuring properties or designing control strategies: a shear flow imposed upon a system produces an interfacial viscous-capillary wave which, in the nonlinear regime, is capable of postponing or even eliminating the incipient instability. The literature shows several examples, whereby Rayleigh break-up of capillary jets is eliminated, van der Waals dry-out of a film is removed and thermocapillary instability is avoided by the application of a suitable surface shear or an imposed fluid flow. The stabilization mechanism is closely linked to the behaviour of the lower-order terms governing the evolution of the liquid–gas interface profile, providing an estimate for the time scales and shear strength involved. Our intention here is to develop a unified theoretical framework for the study of a large number of thin liquid-film configurations and related systems.


Author(s):  
Hongyi Yu ◽  
Karsten Loffler ◽  
Tatiana Gambaryan-Roisman ◽  
Peter Stephan

2019 ◽  
Vol 4 (3) ◽  
Author(s):  
Mariana Rodríguez-Hakim ◽  
Joseph M. Barakat ◽  
Xingyi Shi ◽  
Eric S. G. Shaqfeh ◽  
Gerald G. Fuller

Sign in / Sign up

Export Citation Format

Share Document