scholarly journals Structure of high Reynolds number boundary layers over cube canopies

2019 ◽  
Vol 870 ◽  
pp. 460-491 ◽  
Author(s):  
Jérémy Basley ◽  
Laurent Perret ◽  
Romain Mathis
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Boundary Layers ◽  
Coherent Structures ◽  
High Reynolds Number ◽  
Stereoscopic Particle Image Velocimetry ◽  
Roughness Sublayer ◽  
Large Field ◽  
Normal Velocity ◽  
High Reynolds

The influence of a cube-based canopy on coherent structures of the flow was investigated in a high Reynolds number boundary layer (thickness $\unicode[STIX]{x1D6FF}\sim 30\,000$ wall units). Wind tunnel experiments were conducted considering wall configurations that represent three idealised urban terrains. Stereoscopic particle image velocimetry was employed using a large field of view in a streamwise–spanwise plane ($0.55\unicode[STIX]{x1D6FF}\times 0.5\unicode[STIX]{x1D6FF}$) combined to two-point hot-wire measurements. The analysis of the flow within the inertial layer highlights the independence of its characteristics from the wall configuration. The population of coherent structures is in agreement with that of smooth-wall boundary layers, i.e. consisting of large- and very-large-scale motions, sweeps and ejections, as well as smaller-scale vortical structures. The characteristics of vortices appear to be independent of the roughness configuration while their spatial distribution is closely linked to large meandering motions of the boundary layer. The canopy geometry only significantly impacts the wall-normal exchanges within the roughness sublayer. Bi-dimensional spectral analysis demonstrates that wall-normal velocity fluctuations are constrained by the presence of the canopy for the densest investigated configurations. This threshold in plan area density above which large scales from the overlying boundary layer can penetrate the roughness sublayer is consistent with the change of the flow regime reported in the literature and constitutes a major difference with flows over vegetation canopies.

Subgrid-scale modelling for the large-eddy simulation of high-Reynolds-number boundary layers

1997 ◽  
Vol 336 ◽  
pp. 151-182 ◽  
Author(s):  
BRANKO KOSOVIĆ
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Large Eddy Simulation ◽  
Boundary Layers ◽  
Nonlinear Model ◽  
High Reynolds Number ◽  
Subgrid Scale ◽  
Eddy Simulation ◽  
Large Eddy ◽  
High Reynolds

It has been recognized that the subgrid-scale (SGS) parameterization represents a critical component of a successful large-eddy simulation (LES). Commonly used linear SGS models produce erroneous mean velocity profiles in LES of high-Reynolds-number boundary layer flows. Although recently proposed approaches to solving this problem have resulted in significant improvements, questions about the true nature of the SGS problem in shear-driven high-Reynolds-number flows remain open.We argue that the SGS models must capture inertial transfer effects including backscatter of energy as well as its redistribution among the normal SGS stress components. These effects are the consequence of nonlinear interactions and anisotropy. In our modelling procedure we adopt a phenomenological approach whereby the SGS stresses are related to the resolved velocity gradients. We show that since the SGS stress tensor is not frame indifferent a more general nonlinear model can be applied to the SGS parameterization. We develop a nonlinear SGS model capable of reproducing the effects of SGS anisotropy characteristic for shear-driven boundary layers. The results obtained using the nonlinear model for the LES of a neutral shear-driven atmospheric boundary layer show a significant improvement in prediction of the non-dimensional shear and low-order statistics compared to the linear Smagorinsky-type models. These results also demonstrate a profound effect of the SGS model on the flow structures.

The wall-pressure spectrum of high-Reynolds-number turbulent boundary-layer flows over rough surfaces

2015 ◽  
Vol 768 ◽  
pp. 261-293 ◽  
Author(s):  
Timothy Meyers ◽  
Jonathan B. Forest ◽  
William J. Devenport
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Boundary Layers ◽  
High Reynolds Number ◽  
Wall Pressure ◽  
Boundary Layer Flows ◽  
High Frequency Region ◽  
Pressure Drag ◽  
Roughness Elements ◽  
High Reynolds

Experiments have been performed on a series of high-Reynolds-number flat-plate turbulent boundary layers formed over rough and smooth walls. The boundary layers were fully rough, yet the elements remained a very small fraction $({<}1.4\,\%)$ of the boundary-layer thickness, ensuring conditions free of transitional effects. The wall-pressure spectrum and its scaling were studied in detail. One of the major findings is that the rough-wall turbulent pressure spectrum at vehicle relevant conditions is comprised of three scaling regions. These include a newly discovered high-frequency region where the pressure spectrum has a viscous scaling controlled by the friction velocity, adjusted to exclude the pressure drag on the roughness elements.

Double large field stereoscopic PIV in a high Reynolds number turbulent boundary layer

2009 ◽  
Vol 50 (1) ◽  
pp. 1-12 ◽  
Author(s):  
S. Coudert ◽  
J. M. Foucaut ◽  
J. Kostas ◽  
M. Stanislas ◽  
P. Braud ◽  
...  
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Turbulent Boundary Layer ◽  
High Reynolds Number ◽  
Large Field ◽  
Stereoscopic Piv ◽  
High Reynolds

scholarly journals Modelling high Reynolds number wall–turbulence interactions in laboratory experiments using large-scale free-stream turbulence

2017 ◽  
Vol 375 (2089) ◽  
pp. 20160091 ◽  
Author(s):  
Eda Dogan ◽  
R. Jason Hearst ◽  
Bharathram Ganapathisubramani
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Turbulent Boundary Layer ◽  
Boundary Layers ◽  
High Reynolds Number ◽  
Free Stream ◽  
Wall Turbulence ◽  
Scale Interactions ◽  
Free Stream Turbulence ◽  
High Reynolds

A turbulent boundary layer subjected to free-stream turbulence is investigated in order to ascertain the scale interactions that dominate the near-wall region. The results are discussed in relation to a canonical high Reynolds number turbulent boundary layer because previous studies have reported considerable similarities between these two flows. Measurements were acquired simultaneously from four hot wires mounted to a rake which was traversed through the boundary layer. Particular focus is given to two main features of both canonical high Reynolds number boundary layers and boundary layers subjected to free-stream turbulence: (i) the footprint of the large scales in the logarithmic region on the near-wall small scales, specifically the modulating interaction between these scales, and (ii) the phase difference in amplitude modulation. The potential for a turbulent boundary layer subjected to free-stream turbulence to ‘simulate’ high Reynolds number wall–turbulence interactions is discussed. The results of this study have encouraging implications for future investigations of the fundamental scale interactions that take place in high Reynolds number flows as it demonstrates that these can be achieved at typical laboratory scales. This article is part of the themed issue ‘Toward the development of high-fidelity models of wall turbulence at large Reynolds number’.

Free-stream coherent structures in parallel boundary-layer flows

2014 ◽  
Vol 752 ◽  
pp. 602-625 ◽  
Author(s):  
Kengo Deguchi ◽  
Philip Hall
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Coherent Structures ◽  
Free Stream ◽  
Stokes Equations ◽  
Navier Stokes ◽  
Homotopy Continuation ◽  
Boundary Layer Flows ◽  
Navier Stokes Equations ◽  
High Reynolds

AbstractOur concern in this paper is with high-Reynolds-number nonlinear equilibrium solutions of the Navier–Stokes equations for boundary-layer flows. Here we consider the asymptotic suction boundary layer (ASBL) which we take as a prototype parallel boundary layer. Solutions of the equations of motion are obtained using a homotopy continuation from two known types of solutions for plane Couette flow. At high Reynolds numbers, it is shown that the first type of solution takes the form of a vortex–wave interaction (VWI) state, see Hall & Smith (J. Fluid Mech., vol. 227, 1991, pp. 641–666), and is located in the main part of the boundary layer. On the other hand, here the second type is found to support an equilibrium solution of the unit-Reynolds-number Navier–Stokes equations in a layer located a distance of $\def \xmlpi #1{}\def \mathsfbi #1{\boldsymbol {\mathsf {#1}}}\let \le =\leqslant \let \leq =\leqslant \let \ge =\geqslant \let \geq =\geqslant \def \Pr {\mathit {Pr}}\def \Fr {\mathit {Fr}}\def \Rey {\mathit {Re}}O(\ln \mathit{Re})$ from the wall. Here $\mathit{Re}$ is the Reynolds number based on the free-stream speed and the unperturbed boundary-layer thickness. The streaky field produced by the interaction grows exponentially below the layer and takes its maximum size within the unperturbed boundary layer. The results suggest the possibility of two distinct types of streaky coherent structures existing, possibly simultaneously, in disturbed boundary layers.

Characterization of the Custom-Designed, High Reynolds Number Water Tunnel

2016 ◽  
Author(s):  
Yasaman Farsiani ◽  
Brian R. Elbing
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Test Section ◽  
High Reynolds Number ◽  
Layer Growth ◽  
Water Tunnel ◽  
Freestream Velocity ◽  
Section Design ◽  
High Reynolds

This paper reports on the characterization of the custom-designed high-Reynolds number recirculating water tunnel located at Oklahoma State University. The characterization includes the verification of the test section design, pump calibration and the velocity distribution within the test section. This includes an assessment of the boundary layer growth within the test section. The tunnel was designed to achieve a downstream distance based Reynolds number of 10 million, provide optical access for flow visualization and minimize inlet flow non-uniformity. The test section is 1 m long with 15.2 cm (6-inch) square cross section and acrylic walls to allow direct line of sight at the tunnel walls. The verification of the test section design was accomplished by comparing the flow quality at different location downstream of the flow inlet. The pump was calibrated with the freestream velocity with three pump frequencies and velocity profiles were measured at defined locations for three pump speeds. Boundary layer thicknesses were measured from velocity profile results and compared with analytical calculations. These measurements were also compared against the facility design calculations.

scholarly journals Wall-attached structures of velocity fluctuations in a turbulent boundary layer

2018 ◽  
Vol 856 ◽  
pp. 958-983 ◽  
Author(s):  
Jinyul Hwang ◽  
Hyung Jin Sung
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
High Reynolds Number ◽  
Wall Turbulence ◽  
Velocity Fluctuations ◽  
Moderate Reynolds Number ◽  
Wide Range ◽  
Logarithmic Region ◽  
High Reynolds ◽  
Attached Eddies

Wall turbulence is a ubiquitous phenomenon in nature and engineering applications, yet predicting such turbulence is difficult due to its complexity. High-Reynolds-number turbulence arises in most practical flows, and is particularly complicated because of its wide range of scales. Although the attached-eddy hypothesis postulated by Townsend can be used to predict turbulence intensities and serves as a unified theory for the asymptotic behaviours of turbulence, the presence of coherent structures that contribute to the logarithmic behaviours has not been observed in instantaneous flow fields. Here, we demonstrate the logarithmic region of the turbulence intensity by identifying wall-attached structures of the velocity fluctuations ($u_{i}$) through the direct numerical simulation of a moderate-Reynolds-number boundary layer ($Re_{\unicode[STIX]{x1D70F}}\approx 1000$). The wall-attached structures are self-similar with respect to their heights ($l_{y}$), and in particular the population density of the streamwise component ($u$) scales inversely with $l_{y}$, reminiscent of the hierarchy of attached eddies. The turbulence intensities contained within the wall-parallel components ($u$ and $w$) exhibit the logarithmic behaviour. The tall attached structures ($l_{y}^{+}>100$) of $u$ are composed of multiple uniform momentum zones (UMZs) with long streamwise extents, whereas those of the cross-stream components ($v$ and $w$) are relatively short with a comparable width, suggesting the presence of tall vortical structures associated with multiple UMZs. The magnitude of the near-wall peak observed in the streamwise turbulent intensity increases with increasing $l_{y}$, reflecting the nested hierarchies of the attached $u$ structures. These findings suggest that the identified structures are prime candidates for Townsend’s attached-eddy hypothesis and that they can serve as cornerstones for understanding the multiscale phenomena of high-Reynolds-number boundary layers.

Sign in / Sign up

Export Citation Format

Share Document