Experiments on localized secondary instability in bypass boundary layer transition

2017 ◽  
Vol 817 ◽  
pp. 217-263 ◽  
Author(s):  
G. Balamurugan ◽  
A. C. Mandal
Keyword(s):  
Boundary Layer ◽  
Shear Layer ◽  
Free Stream ◽  
Secondary Instability ◽  
Boundary Layer Transition ◽  
Convection Velocity ◽  
Layer Transition ◽  
Time Resolved ◽  
Piv Measurements ◽  
Low Speed

An experimental study on localized secondary instability of unsteady streamwise streaks in bypass boundary layer transition under an elevated level of free-stream turbulence has been carried out mainly using the particle image velocimetry (PIV) technique. Simultaneous orthogonal dual-plane PIV measurements were performed for a concurrent examination of the transitional flow features in both wall-normal and spanwise planes. These quantitative and simultaneous visualizations clearly show the wall-normal view of a low-speed streak undergoing sinuous/varicose motion in the spanwise plane. An oscillating shear layer in the wall-normal plane is found to be associated with the sinuous/varicose streak oscillation in the spanwise plane. Further, these measurements indicate that a localized secondary instability wavepacket can originate near the boundary layer edge. The time-resolved PIV measurements in the wall-normal plane clearly show how an instability develops on a lifted-up inclined shear layer and leads to flow breakdown. The estimated wavelength and convection velocity of such instabilities are found to compare well with those calculated from the one-dimensional linear stability analysis of the spatially averaged velocity profiles associated with the lifted-up shear layers. The time-resolved PIV measurements in the spanwise plane also facilitate quantitative visualizations of sinuous and varicose instabilities. These measurements experimentally confirm that a varicose instability at the juncture of an incoming high-speed streak and a downstream low-speed streak can eventually lead to the formation of lambda structures. The estimated convection velocity, wavelength and growth rate of these instabilities are found to be consistent with the numerical results reported in the literature. Moreover, the streak secondary instability is found to be apparent in the velocity contours, while the estimated streak amplitude is approximately 30 % of the free-stream velocity.

scholarly journals A study on boundary-layer transition induced by free-stream turbulence

2010 ◽  
Vol 660 ◽  
pp. 114-146 ◽  
Author(s):  
A. C. MANDAL ◽  
L. VENKATAKRISHNAN ◽  
J. DEY
Keyword(s):  
Boundary Layer ◽  
Shear Layer ◽  
Free Stream ◽  
Decomposition Analysis ◽  
Velocity Profiles ◽  
Boundary Layer Transition ◽  
Bypass Transition ◽  
Turbulent Spot ◽  
Layer Transition ◽  
Free Stream Turbulence

Boundary-layer transition at different free-stream turbulence levels has been investigated using the particle-image velocimetry technique. The measurements show organized positive and negative fluctuations of the streamwise fluctuating velocity component, which resemble the forward and backward jet-like structures reported in the direct numerical simulation of bypass transition. These fluctuations are associated with unsteady streaky structures. Large inclined high shear-layer regions are also observed and the organized negative fluctuations are found to appear consistently with these inclined shear layers, along with highly inflectional instantaneous streamwise velocity profiles. These inflectional velocity profiles are similar to those in the ribbon-induced boundary-layer transition. An oscillating-inclined shear layer appears to be the turbulent spot-precursor. The measurements also enabled to compare the actual turbulent spot in bypass transition with the simulated one. A proper orthogonal decomposition analysis of the fluctuating velocity field is carried out. The dominant flow structures of the organized positive and negative fluctuations are captured by the first few eigenfunction modes carrying most of the fluctuating energy. The similarity in the dominant eigenfunctions at different Reynolds numbers suggests that the flow prevails its structural identity even in intermittent flows. This analysis also indicates the possibility of the existence of a spatio-temporal symmetry associated with a travelling wave in the flow.

Effects of Reynolds Number and Free-Stream Turbulence on Boundary Layer Transition in a Compressor Cascade

2000 ◽  
Author(s):  
Heinz-Adolf Schreiber ◽  
Wolfgang Steinert ◽  
Bernhard Küsters
Keyword(s):  
Boundary Layer ◽  
Free Stream ◽  
Reynolds Numbers ◽  
Boundary Layer Transition ◽  
Bypass Transition ◽  
Layer Transition ◽  
Free Stream Turbulence ◽  
High Reynolds Numbers ◽  
High Turbulence ◽  
High Reynolds

An experimental and analytical study has been performed on the effect of Reynolds number and free-stream turbulence on boundary layer transition location on the suction surface of a controlled diffusion airfoil (CDA). The experiments were conducted in a rectilinear cascade facility at Reynolds numbers between 0.7 and 3.0×106 and turbulence intensities from about 0.7 to 4%. An oil streak technique and liquid crystal coatings were used to visualize the boundary layer state. For small turbulence levels and all Reynolds numbers tested the accelerated front portion of the blade is laminar and transition occurs within a laminar separation bubble shortly after the maximum velocity near 35–40% of chord. For high turbulence levels (Tu > 3%) and high Reynolds numbers transition propagates upstream into the accelerated front portion of the CDA blade. For those conditions, the sensitivity to surface roughness increases considerably and at Tu = 4% bypass transition is observed near 7–10% of chord. Experimental results are compared to theoretical predictions using the transition model which is implemented in the MISES code of Youngren and Drela. Overall the results indicate that early bypass transition at high turbulence levels must alter the profile velocity distribution for compressor blades that are designed and optimized for high Reynolds numbers.

Effects of Concave Curvature on Boundary Layer Transition Under High Free-Stream Turbulence Conditions

2001 ◽  
Author(s):  
Michael P. Schultz ◽  
Ralph J. Volino
Keyword(s):  
Boundary Layer ◽  
Free Stream ◽  
Turbulent Transport ◽  
Boundary Layer Transition ◽  
Transitional Flow ◽  
Turbulent Shear ◽  
Radius Of Curvature ◽  
Layer Transition ◽  
Free Stream Turbulence ◽  
Turbulent Shear Stress

An experimental investigation has been carried out on a transitional boundary layer subject to high (initially 9%) free-stream turbulence, strong acceleration K=ν/Uw2dUw/dxas high as9×10-6, and strong concave curvature (boundary layer thickness between 2% and 5% of the wall radius of curvature). Mean and fluctuating velocity as well as turbulent shear stress are documented and compared to results from equivalent cases on a flat wall and a wall with milder concave curvature. The data show that curvature does have a significant effect, moving the transition location upstream, increasing turbulent transport, and causing skin friction to rise by as much as 40%. Conditional sampling results are presented which show that the curvature effect is present in both the turbulent and non-turbulent zones of the transitional flow.

Boundary Layer Transition Under High Free-Stream Turbulence and Strong Acceleration Conditions: Part 1—Mean Flow Results

1997 ◽  
Vol 119 (3) ◽  
pp. 420-426 ◽  
Author(s):  
R. J. Volino ◽  
T. W. Simon
Keyword(s):  
Boundary Layer ◽  
Skin Friction ◽  
Free Stream ◽  
Boundary Layer Transition ◽  
Temperature Profiles ◽  
Mean Flow ◽  
Transfer Coefficients ◽  
Mean Velocity ◽  
Layer Transition ◽  
Free Stream Turbulence

Measurements from heated boundary layers along a concave-curved test wall subject to high (initially 8 percent) free-stream turbulence intensity and strong (K = (ν/U∞2) dU∞/dx) as high as 9 × 10−6) acceleration are presented and discussed. Conditions for the experiments were chosen to roughly simulate those present on the downstream half of the pressure side of a gas turbine airfoil. Mean velocity and temperature profiles as well as skin friction and heat transfer coefficients are presented. The transition zone is of extended length in spite of the high free-stream turbulence level. Transitional values of skin friction coefficients and Stanton numbers drop below flat-plate, low-free-stream-turbulence, turbulent flow correlations, but remain well above laminar flow values. The mean velocity and temperature profiles exhibit clear changes in shape as the flow passes through transition. To the authors’ knowledge, this is the first detailed documentation of a high-free-stream-turbulence boundary layer flow in such a strong acceleration field.

Effects of Weak Free Stream Nonuniformity on Boundary Layer Transition (Keynote Paper)

2003 ◽  
Author(s):  
Jonathan H. Watmuff
Keyword(s):  
Boundary Layer ◽  
Free Stream ◽  
Leading Edge ◽  
Boundary Layer Transition ◽  
Mean Flow ◽  
Layer Transition ◽  
Free Stream Turbulence ◽  
Tollmien Schlichting ◽  
Distorted Waves ◽  
Thickness Variations

Experiments are described in which well-defined FSN (Free Stream Nonuniformity) distributions are introduced by placing fine wires upstream of the leading edge of a flat plate. Large amplitude spanwise thickness variations are present in the downstream boundary layer resulting from the interaction of the laminar wakes with the leading edge. Regions of elevated background unsteadiness appear on either side of the peak layer thickness, which share many of the characteristics of Klebanoff modes, observed at elevated Free Stream Turbulence (FST) levels. However, for the low background disturbance level of the free stream, the layer remains laminar to the end of the test section (Rx ≈ l.4×106) and there is no evidence of bursting or other phenomena associated with breakdown to turbulence. A vibrating ribbon apparatus is used to demonstrate that the deformation of the mean flow is responsible for substantial phase and amplitude distortion of Tollmien-Schlichting (TS) waves. Pseudo-flow visualization of hot-wire data shows that the breakdown of the distorted waves is more complex and occurs at a lower Reynolds number than the breakdown of the K-type secondary instability observed when the FSN is not present.

Effects of Weak Free Stream Nonuniformity on Boundary Layer Transition

2005 ◽  
Vol 128 (2) ◽  
pp. 247-257 ◽  
Author(s):  
Jonathan H. Watmuff
Keyword(s):  
Boundary Layer ◽  
Layer Thickness ◽  
Free Stream ◽  
Leading Edge ◽  
Boundary Layer Transition ◽  
Bypass Transition ◽  
Mean Flow ◽  
Low Speed ◽  
Free Stream Turbulence ◽  
Thickness Variations

Experiments are described in which well-defined weak Free Stream Nonuniformity (FSN) is introduced by placing fine wires upstream of the leading edge of a flat plate. Large amplitude spanwise thickness variations form in the boundary layer as a result of the interaction between the steady laminar wakes from the wires and the leading edge. The centerline of a region of elevated layer thickness is aligned with the centerline of the wake in the freestream and the response is shown to be remarkably sensitive to the spanwise length-scale of the wakes. The region of elevated thickness is equivalent to a long narrow low speed streak in the layer. Elevated Free Stream Turbulence (FST) levels are known to produce randomly forming arrays of long narrow low speed streaks in laminar boundary layers. Therefore the characteristics of the streaks resulting from the FSN are studied in detail in an effort to gain some insight into bypass transition that occurs at elevated FST levels. The shape factors of the profiles in the vicinity of the streak appear to be unaltered from the Blasius value, even though the magnitude of the local thickness variations are as large as 60% of that of the undisturbed layer. Regions of elevated background unsteadiness appear on either side of the streak and it is shown that they are most likely the result of small amplitude spanwise modulation of the layer thickness. The background unsteadiness shares many of the characteristics of Klebanoff modes observed at elevated FST levels. However, the layer remains laminar to the end of the test section (Rx≈1.4×106) and there is no evidence of bursting or other phenomena associated with breakdown to turbulence. A vibrating ribbon apparatus is used to examine interactions between the streak and Tollmien-Schlichting (TS) waves. The deformation of the mean flow introduced by the streak is responsible for substantial phase and amplitude distortion of the waves and the breakdown of the distorted waves is more complex and it occurs at a lower Reynolds number than the breakdown of the K-type secondary instability that is observed when the FSN is not present.

Unsteady Transition in an Axial-Flow Turbine: Part 1—Measurements on the Turbine Rotor

1990 ◽  
Vol 112 (2) ◽  
pp. 206-214 ◽  
Author(s):  
J. S. Addison ◽  
H. P. Hodson
Keyword(s):  
Boundary Layer ◽  
Cross Sections ◽  
Axial Flow ◽  
Transition Process ◽  
Turbine Rotor ◽  
Boundary Layer Transition ◽  
Surface Boundary ◽  
Suction Surface ◽  
Layer Transition ◽  
Time Resolved

Previously published measurements in a low-speed, single-stage, axial-flow turbine have been reanalyzed in the light of more recent understanding. The measurements include time-resolved hot-wire traverses and surface hot film gage measurements at the midspan of the rotor suction surface with three different rotor-stator spacings. Part 1 investigates the suction surface boundary layer transition process, using surface-distance time plots and boundary layer cross sections to demonstrate the unsteady and two-dimensional nature of the process. Part 2 of the paper will describe the results of supporting experiments carried out in a linear cascade together with a simple transition model, which explains the features seen in the turbine.

Sign in / Sign up

Export Citation Format

Share Document