The effect of shear-thinning behaviour on rod orientation in filled fluids

2016 ◽  
Vol 798 ◽  
pp. 350-370 ◽  
Author(s):  
Julien Férec ◽  
Erwan Bertevas ◽  
Boo Cheong Khoo ◽  
Gilles Ausias ◽  
Nhan Phan-Thien

In the present article, the cell model (or self-consistent scheme) is used to derive constitutive equations for rod suspensions in non-Newtonian viscous matrices such as power-law, Ellis and Carreau fluids. It is found that the shear-thinning character of the matrix influences considerably the rod contribution to the stress tensor, but has no impact on the rod orientation dynamics: the same microstructure evolution as the one encountered in Newtonian fluids is obtained. The rod suspension behaves differently than the unfilled matrix in the sense that, depending on rod orientation, the onset of shear thinning in the composite occurs at lower or higher shear rates. Our analysis also provides a semi-analytical model for rod suspensions in an Ellis fluid, which appears to be suitable for predicting a Newtonian plateau at low shear rates and a shear-thinning behaviour at high shear rates. In addition, the model predictions are in good agreement with the shear viscosity measurements of glass-fibre-filled polystyrene melts (Chan et al., J. Rheol., vol. 22 (5), 1978, pp. 507–524), demonstrating its ability to describe the rheological behaviour of such polymer composites. Finally, the proposed approach is extended to a Carreau fluid although its solution requires the numerical solution of a set of partial differential equations.

1992 ◽  
Vol 289 ◽  
Author(s):  
John R. Melrose

AbstractAn overview is given of theories of aggregates under flow. These generally assume some sort of structural breakdown as the shear rate is increased. Models vary with both the rigidity of the bonding and the level of treatment of hydrodynamics. Results are presented for simulations of a Rouse model of non-rigid, (i.e. central force) weakly bonded aggregates. In large scale simulations different structures are observed at low and high shear rates. The change from one structure to another is associated with a change in the rate of shear thinning. The model captures low shear rate features of real systems absent in previous models: this feature is ascribed to agglomerate deformations. Quantitatively, the model is two orders of magnitude out from experiment but some scaling is possible.


2006 ◽  
Vol 953 ◽  
Author(s):  
Sameer Sharad Rahatekar ◽  
Jeffrey W Gilman ◽  
K K Koziol ◽  
Simon Butler ◽  
James A Elliott ◽  
...  

ABSTRACTIn this pape effect of nanotube aggrates on the rheological properties of multiwall carbonanntube abd epoxy suspension in epoxy resin.The base epoxy resin was found to be essentially Newtonian, and the progressive incorporation of nanotubes enhanced the low shear rate viscosity of the suspension by nearly two decades. At higher shear rates, the suspension viscosity asymptotically thinned to the viscosity of the matrix alone. The low shear rate viscosity enhancement was correlated with the optical observations of interconnected aggregates of carbon nanotubes, which themselves were induced by the low shear conditions. Intermediate shear rates resulted in a reduction in the size of the aggregates. High shear rates appeared to cause near complete dispersal of the aggregates. From these results it is conjectured that for this suspension, shear thinning is connected with the breaking of the interconnected network between aggregates of nanotubes, and not by nanotube alignment.


2002 ◽  
Vol 10 (6) ◽  
pp. 427-432 ◽  
Author(s):  
Amit K. Naskar ◽  
S. K. De ◽  
Anil K. Bhowmick

The thermorheological behaviour of thermoplastic elastomeric blends based on both ground rubber tyre (GRT) and maleic anhydride grafted GRT (m-GRT) has been studied. The blend composition based on m-GRT exhibits a higher melt viscosity than the corresponding control blend based on GRT. The former exhibits lower die swell and less melt fracture at low shear rates than the latter, when extruded at 180°C through a capillary rheometer. At high shear rates, however, both the blends exhibit melt fracture. There is apparently some interaction between m-GRT and the matrix, which is evident from dynamic mechanical analysis. The m-GRT causes a significant lowering in tanδ at temperatures higher than the Tg of the blend.


Blood ◽  
2014 ◽  
Vol 124 (21) ◽  
pp. 2716-2716
Author(s):  
Vivien A. Sheehan ◽  
Sheryl Nelson ◽  
Caroline Yappan ◽  
Bogdan R. Dinu ◽  
Danielle Guffey ◽  
...  

Abstract Background: Sickle cell disease (SCD) patients have altered blood rheology due to erythrocyte abnormalities, including increased aggregation and reduced deformability, which together affect microcirculatory blood flow and tissue perfusion. At equal hematocrit, sickle cell blood viscosity is increased compared to normal individuals. The hematocrit to viscosity ratio (HVR) is a measure of red blood cell (RBC) oxygen carrying capacity, and is reduced in SCD with clinical consequences related to altered blood flow and reduced tissue oxygenation. Erythrocyte transfusions reduce HVR at low shear rates that mimic venous circulation, and do not change HVR at high shear rates that mimic arterial blood flow. Hydroxyurea is a safe and effective therapy for SCD; however, its effects on sickle cell rheology and HVR have not been fully investigated. Evaluating the effects of hydroxyurea on viscosity is especially critical, before its use is extended widely to patients with cerebrovascular disease or genotypes with higher hematocrit and higher viscosity such as Hemoglobin SC (HbSC). Methods: To determine the effects of hydroxyurea on viscosity and HVR, we designed a prospective study to measure whole blood viscosity at 45 s-1 (low shear) and 225 s-1(high shear) rates in pediatric patients with SCD using a Brookfield cone and plate viscometer under oxygenated conditions. Venous blood samples (1-3mL) were collected in EDTA and analyzed no more than 4 hours after phlebotomy; samples were run in duplicate by persons blinded to the patient’s sickle genotype and treatment status. Laboratory values were obtained using an ADVIA hematology analyzer. Samples were analyzed from three non-overlapping cohorts of patients with SCD and HbAA individuals for comparison: untreated HbSS patients (n= 43), HbSS patients treated with hydroxyurea at maximum tolerated dose (n=98), untreated HbSC patients (n=53) and HbAA patients (n=19). Laboratory parameters that differed significantly among the SCD groups were analyzed by simple linear regression. Results: Patient characteristics and viscosity measurements are shown in the Table. Within the SCD population, the viscosity was lowest among the untreated HbSS patients, presumably due to their low hematocrit, while viscosity was higher in HbSS patients on hydroxyurea and HbSC patients. When the HVR was calculated for each group, no significant difference was identified between untreated HbSS and untreated HbSC patients. However, hydroxyurea treatment significantly increased HVR at both 45s-1 and 225 s-1 (p<0.001), indicating that the slightly increased viscosity in this cohort was more than compensated by a higher hematocrit. Correlations were tested for hemoglobin (Hb), mean corpuscular volume (MCV), white blood cell count (WBC), absolute neutrophil count (ANC), absolute reticulocyte count (ARC), % fetal hemoglobin (HbF), and average red cell density in g/dL with HVR, at both shear rates. The hydroxyurea-associated HVR increase at both shear rates was independent of %HbF or MCV, but the increased HVR at 225 s-1was associated with lower WBC (p<0.001), lower ANC (p=0.002), and lower red cell density (p=.009). Conclusions: We provide prospective data on whole blood viscosity measurements in a large cohort of children with SCD. Hydroxyurea increases the hematocrit in HbSS patients more than the viscosity, and thus improves HVR. These findings imply that hydroxyurea improves RBC oxygen transport at both high and low shear rates, which should confer clinical benefits, and these effects are independent of HbF induction. Concerns about hydroxyurea increasing whole blood viscosity and reducing tissue oxygenation in children with cerebrovascular disease or HbSC patients may not be warranted, if the same beneficial HVR effects are achieved. Abstract 2717. Table 1. Patient characteristics. Viscosity was typically measured in duplicate and averaged for each patient. HVR at 45 s-1 and 225s-1 was calculated as hematocrit/viscosity. Results are presented as mean ± 2SD. HbAAn=19 HbSS, untreatedn=43 HbSS, on Hydroxyurean=98 HbSCn=53 Age (years) 15.4 ± 3.8 10.4 ± 5.1 10.7 ± 3.4 10.5 ± 4.3 Hemoglobin (gm/dL) 13.5 ± 1.7 8.5 ± 1.0 9.9 ± 1.4 11.0 ± 1.2 Hematocrit (%) 40.9 ± 5.3 25.5 ± 3.1 28.4 ± 3.7 31.3 ± 3.2 Viscosity (cP) at 45s-1 5.3 ± 0.9 4.6 ± 1.2 4.3 ± 0.9 5.5 ±0.9 HVR at 45s-1 7.5 ± 0.9 5.8 ± 1.1 6.75 ± 1.0 5.77 ± 0.7 Viscosity (cP) at 225s-1 3.8 ± 0.5 3.3 ± 0.5 3.4 ± 0.5 4.1 ± 0.5 HVR at 225s-1 10.3 ± 0.7 7.7 ± 0.8 8.53 ± 0.8 7.72 ± 0.6 Disclosures Off Label Use: Hydroxyurea is not FDA approved for use in pediatric sickle cell patients.


Lubricants ◽  
2018 ◽  
Vol 6 (4) ◽  
pp. 100 ◽  
Author(s):  
F. Borras ◽  
Matthijn de Rooij ◽  
Dik Schipper

The use of Environmentally Acceptable Lubricants (EALs) for stern tube lubrication is increasing. Although the machine components of a sailing vessel are designed to operate together with mineral oil-based lubricants, these are being replaced by the less environmentally harmful EALs. Little is known about the rheological performance of EALs in particular at the high shear rates that occur in stern tube seals. In this study, the viscosity and wetting properties of a set of different EALs is analysed and compared to traditional mineral oil-based lubricants using a set of experimental techniques. Some of the EALs present Newtonian behavior whereas other show shear thinning. No significant difference in surface tension was observed between the different lubricants.


2014 ◽  
Vol 53 (3) ◽  
pp. 555-567 ◽  
Author(s):  
Shintaro Itoh ◽  
Koki Ishii ◽  
Kenji Fukuzawa ◽  
Hedong Zhang

2010 ◽  
Vol 105-106 ◽  
pp. 833-836
Author(s):  
Xiang Yang Lu ◽  
Li Ming Zhang ◽  
Yong Huang

The rheological behavior of alumina suspension stabilized with Tri-ammonia citrate (TAC) was studied. It was thought that there would form some particle clusters due to the collisions between particles caused by their relative motion in the suspension, and such particle clusters are classified as thermodynamic clusters and hydrodynamic clusters by their origin. Shear thinning is the result of decomposition of the thermodynamic clusters, while shear thickening is the result of formation of the hydrodynamic clusters. From the view of cluster-forming potential barrier, it was deemed that the viscosities of alumina suspensions at low and high shear rates are respectively determined by zeta potential and Stern potential on the particle surface, and shear thickening behavior can be suppressed with some excessive TAC.


2009 ◽  
Vol 630 ◽  
pp. 267-298 ◽  
Author(s):  
JOONTAEK PARK ◽  
JASON E. BUTLER

We use slender-body theory to simulate a rigid fibre within simple shear flow and parabolic flow at zero Reynolds number and high Péclet numbers (weak Brownian motion). Hydrodynamic interactions of bulk fibres with the bounding walls are included using previously developed methods (Harlen, Sundararajakumar & Koch, J. Fluid Mech., vol. 388, 1999, pp. 355–388; Butler & Shaqfeh, J. Fluid Mech., vol. 468, 2002, pp. 205–237). We also extend a previous analytic theory (Park, Bricker & Butler, Phys. Rev. E, vol. 76, 2007, 04081) predicting the centre-of-mass distribution of rigid fibre suspensions undergoing rectilinear flow near a wall to compare the steady and transient distributions. The distributions obtained by the simulation and theory are in good agreement at sufficiently high shear rates, validating approximations made in the theory which predicts a net migration of the rigid fibres away from the walls due to a hydrodynamic lift force. The effect of the inhomogeneous distribution on the effective stress is also investigated.


2009 ◽  
Vol 419-420 ◽  
pp. 53-56
Author(s):  
Bao Yu Song ◽  
Qing Xiang Yang ◽  
Feng Zhang ◽  
Dai Zhong Su

The apparent viscosity of aircraft grease with different nano-particles content, temperature and shear rates were studied using a rotational viscometer. The rheological properties of two types of aircraft grease, the basic grease and the one with nano-particles additives, were investigated using a rheometer. The results indicated that the apparent viscosity increases with the increase of nanoparticle concentration with the given ratio of nano-particles added. It was also found that the grease with and without the nano-particles both have yield stresses and clear shear-thinning properties. The shear-thinning phenomenon of the grease containing nano-particles is more evident than that of the basic grease. The experimental results also reveal that the rheological characteristics of both types of grease fall in Herschel-Bulkley class, and the nano-particles have a significant influence on the rheological parameters. At the end, the rheology mechanism was discussed based on the entanglement and orientation theories.


Sign in / Sign up

Export Citation Format

Share Document