Behaviour of a natural laminar flow aerofoil in flight through atmospheric turbulence

2015 ◽  
Vol 767 ◽  
pp. 394-429 ◽  
Author(s):  
Andreas D. Reeh ◽  
C. Tropea
Keyword(s):  
Atmospheric Turbulence ◽  
Base Flow ◽  
Boundary Layer Transition ◽  
Linear Stability Theory ◽  
Oncoming Flow ◽  
Layer Transition ◽  
Weakly Nonlinear ◽  
Free Stream Turbulence ◽  
Wing Section ◽  
Insight Into

AbstractAtmospheric turbulence is encountered frequently in flight and it creates oncoming flow disturbances of varying direction and magnitude for aircraft passing through turbulent zones. The unique measurement set-up on a motorised glider enables the investigation of the flow processes acting on a laminar wing section in flight through atmospheric turbulence. The expected quasi-steady aerofoil characteristics are deduced from an investigation of boundary-layer transition under calm flight conditions. Spanwise frequency–wavenumber spectra and comparisons with linear stability theory (LST) yield insight into the linear and weakly nonlinear stages of transition. Simultaneous measurement of the oncoming flow, characteristic flow quantities on the wing section and the motion of the aerofoil enables correlations between these quantities and provides insight into the unsteady flight physics. Emphasis is placed on the response of laminar–turbulent transition to moderate free-stream turbulence on both sides of the wing section. On the lower side of the aerofoil significant and rapid upstream fluctuations of transition are observed, which correspond closely to variations in the pressure distribution. Wavelet analysis is applied to gain insight into the composition of these streamwise excursions of the transition front in the time-pseudo-frequency domain. It is shown that they are driven by rapid transient base-flow changes and that transition is initiated by a short growth stage of Tollmien–Schlichting (TS) waves.

Effects of Reynolds Number and Free-Stream Turbulence on Boundary Layer Transition in a Compressor Cascade

2000 ◽  
Author(s):  
Heinz-Adolf Schreiber ◽  
Wolfgang Steinert ◽  
Bernhard Küsters
Keyword(s):  
Boundary Layer ◽  
Free Stream ◽  
Reynolds Numbers ◽  
Boundary Layer Transition ◽  
Bypass Transition ◽  
Layer Transition ◽  
Free Stream Turbulence ◽  
High Reynolds Numbers ◽  
High Turbulence ◽  
High Reynolds

An experimental and analytical study has been performed on the effect of Reynolds number and free-stream turbulence on boundary layer transition location on the suction surface of a controlled diffusion airfoil (CDA). The experiments were conducted in a rectilinear cascade facility at Reynolds numbers between 0.7 and 3.0×106 and turbulence intensities from about 0.7 to 4%. An oil streak technique and liquid crystal coatings were used to visualize the boundary layer state. For small turbulence levels and all Reynolds numbers tested the accelerated front portion of the blade is laminar and transition occurs within a laminar separation bubble shortly after the maximum velocity near 35–40% of chord. For high turbulence levels (Tu > 3%) and high Reynolds numbers transition propagates upstream into the accelerated front portion of the CDA blade. For those conditions, the sensitivity to surface roughness increases considerably and at Tu = 4% bypass transition is observed near 7–10% of chord. Experimental results are compared to theoretical predictions using the transition model which is implemented in the MISES code of Youngren and Drela. Overall the results indicate that early bypass transition at high turbulence levels must alter the profile velocity distribution for compressor blades that are designed and optimized for high Reynolds numbers.

Highly Loaded Low-Pressure Turbine: Design, Numerical, and Experimental Analysis

2010 ◽  
Author(s):  
J. T. Schmitz ◽  
S. C. Morris ◽  
R. Ma ◽  
T. C. Corke ◽  
J. P. Clark ◽  
...  
Keyword(s):  
High Speed ◽  
Numerical Solutions ◽  
Pressure Ratio ◽  
Low Pressure ◽  
Boundary Layer Transition ◽  
Layer Transition ◽  
Free Stream Turbulence ◽  
Low Pressure Turbine ◽  
The Mean ◽  
Highly Loaded

The performance and detailed flow physics of a highly loaded, transonic, low-pressure turbine stage has been investigated numerically and experimentally. The mean rotor Zweifel coefficient was 1.35, with dh/U2 = 2.8, and a total pressure ratio of 1.75. The aerodynamic design was based on recent developments in boundary layer transition modeling. Steady and unsteady numerical solutions were used to design the blade geometry as well as to predict the design and off-design performance. Measurements were acquired in a recently developed, high-speed, rotating turbine facility. The nozzle-vane only and full stage characteristics were measured with varied mass flow, Reynolds number, and free-stream turbulence. The efficiency calculated from torque at the design speed and pressure ratio of the turbine was found to be 90.6%. This compared favorably to the mean line target value of 90.5%. This paper will describe the measurements and numerical solutions in detail for both design and off-design conditions.

Effects of Concave Curvature on Boundary Layer Transition Under High Free-Stream Turbulence Conditions

2001 ◽  
Author(s):  
Michael P. Schultz ◽  
Ralph J. Volino
Keyword(s):  
Boundary Layer ◽  
Free Stream ◽  
Turbulent Transport ◽  
Boundary Layer Transition ◽  
Transitional Flow ◽  
Turbulent Shear ◽  
Radius Of Curvature ◽  
Layer Transition ◽  
Free Stream Turbulence ◽  
Turbulent Shear Stress

An experimental investigation has been carried out on a transitional boundary layer subject to high (initially 9%) free-stream turbulence, strong acceleration K=ν/Uw2dUw/dxas high as9×10-6, and strong concave curvature (boundary layer thickness between 2% and 5% of the wall radius of curvature). Mean and fluctuating velocity as well as turbulent shear stress are documented and compared to results from equivalent cases on a flat wall and a wall with milder concave curvature. The data show that curvature does have a significant effect, moving the transition location upstream, increasing turbulent transport, and causing skin friction to rise by as much as 40%. Conditional sampling results are presented which show that the curvature effect is present in both the turbulent and non-turbulent zones of the transitional flow.

Boundary Layer Transition Under High Free-Stream Turbulence and Strong Acceleration Conditions: Part 1—Mean Flow Results

1997 ◽  
Vol 119 (3) ◽  
pp. 420-426 ◽  
Author(s):  
R. J. Volino ◽  
T. W. Simon
Keyword(s):  
Boundary Layer ◽  
Skin Friction ◽  
Free Stream ◽  
Boundary Layer Transition ◽  
Temperature Profiles ◽  
Mean Flow ◽  
Transfer Coefficients ◽  
Mean Velocity ◽  
Layer Transition ◽  
Free Stream Turbulence

Measurements from heated boundary layers along a concave-curved test wall subject to high (initially 8 percent) free-stream turbulence intensity and strong (K = (ν/U∞2) dU∞/dx) as high as 9 × 10−6) acceleration are presented and discussed. Conditions for the experiments were chosen to roughly simulate those present on the downstream half of the pressure side of a gas turbine airfoil. Mean velocity and temperature profiles as well as skin friction and heat transfer coefficients are presented. The transition zone is of extended length in spite of the high free-stream turbulence level. Transitional values of skin friction coefficients and Stanton numbers drop below flat-plate, low-free-stream-turbulence, turbulent flow correlations, but remain well above laminar flow values. The mean velocity and temperature profiles exhibit clear changes in shape as the flow passes through transition. To the authors’ knowledge, this is the first detailed documentation of a high-free-stream-turbulence boundary layer flow in such a strong acceleration field.

Effects of Weak Free Stream Nonuniformity on Boundary Layer Transition (Keynote Paper)

2003 ◽  
Author(s):  
Jonathan H. Watmuff
Keyword(s):  
Boundary Layer ◽  
Free Stream ◽  
Leading Edge ◽  
Boundary Layer Transition ◽  
Mean Flow ◽  
Layer Transition ◽  
Free Stream Turbulence ◽  
Tollmien Schlichting ◽  
Distorted Waves ◽  
Thickness Variations

Experiments are described in which well-defined FSN (Free Stream Nonuniformity) distributions are introduced by placing fine wires upstream of the leading edge of a flat plate. Large amplitude spanwise thickness variations are present in the downstream boundary layer resulting from the interaction of the laminar wakes with the leading edge. Regions of elevated background unsteadiness appear on either side of the peak layer thickness, which share many of the characteristics of Klebanoff modes, observed at elevated Free Stream Turbulence (FST) levels. However, for the low background disturbance level of the free stream, the layer remains laminar to the end of the test section (Rx ≈ l.4×106) and there is no evidence of bursting or other phenomena associated with breakdown to turbulence. A vibrating ribbon apparatus is used to demonstrate that the deformation of the mean flow is responsible for substantial phase and amplitude distortion of Tollmien-Schlichting (TS) waves. Pseudo-flow visualization of hot-wire data shows that the breakdown of the distorted waves is more complex and occurs at a lower Reynolds number than the breakdown of the K-type secondary instability observed when the FSN is not present.

A Note on the Transition Observations on an Axisymmetric Body and Some Related Fluctuating Wall Pressure Measurements

1975 ◽  
Vol 97 (1) ◽  
pp. 82-86 ◽  
Author(s):  
V. H. Arakeri
Keyword(s):  
Pressure Transducer ◽  
Critical Frequency ◽  
Dominant Frequency ◽  
Axisymmetric Body ◽  
Boundary Layer Transition ◽  
Linear Stability Theory ◽  
Pressure Measurements ◽  
Schlieren Method ◽  
Layer Transition ◽  
Transducer Signal

Boundary layer transition on an axisymmetric body up to Reynolds number of 1.26 × 106 was observed by schlieren method of flow visualization developed for water tunnel use. The spectrum of the flush mounted pressure transducer signal showed a dominant frequency to exist at transition and further, this frequency was in close agreement with the predicted critical frequency by Smith’s approximate method of transition calculation based on linear stability theory.

Sign in / Sign up

Export Citation Format

Share Document