Initial growth of a disturbance in a boundary layer influenced by a circular cylinder wake

2013 ◽  
Vol 718 ◽  
pp. 116-130 ◽  
Author(s):  
Guosheng He ◽  
Jinjun Wang ◽  
Chong Pan
Keyword(s):  
Boundary Layer ◽  
Circular Cylinder ◽  
Growth Stage ◽  
Plate Boundary ◽  
Dynamic Mode Decomposition ◽  
Dynamic Mode ◽  
Wall Region ◽  
Initial Growth ◽  
Cylinder Wake ◽  
Near Wall

AbstractThe initial growth of a disturbance induced by a near-wall circular cylinder in a flat-plate boundary layer is experimentally investigated using both particle image velocimetry and hydrogen bubble visualization techniques. The secondary spanwise vortices appear in the near-wall region as a direct response to the outside passing wake vortices, consistent with previous studies on similar models (Pan et al., J. Fluid Mech., vol. 603, 2008, pp. 367–389; Mandal & Dey, J. Fluid Mech., vol. 684, 2011, pp. 60–84). The streamwise variation of the total disturbance energy within the boundary layer shows a two-stage growth, which characterizes the initial transition process: the first exponential growth stage, followed by a region with slower growth rate. It is revealed that these two stages of growth are related to the formation and the destabilization of the secondary vortex in the near-wall region. The technique of dynamic mode decomposition is used to decompose the total disturbance into temporally orthogonalized modes, and it shows that the first growth stage largely results from the increased disturbance at the same frequency as that of the wake vortex shedding, while the second growth stage comprises the disturbance growth in a number of frequencies, especially the lower ones.

The Effects of Adverse Pressure Gradients on Momentum and Thermal Structures in Transitional Boundary Layers: Part 2—Fluctuation Quantities

1996 ◽  
Vol 118 (4) ◽  
pp. 728-736 ◽  
Author(s):  
S. P. Mislevy ◽  
T. Wang
Keyword(s):  
Boundary Layer ◽  
Shear Stress ◽  
Transition Region ◽  
Boundary Layers ◽  
Reynolds Shear Stress ◽  
Turbulent Shear ◽  
Wall Region ◽  
Pressure Gradients ◽  
Baseline Case ◽  
Near Wall

The effects of adverse pressure gradients on the thermal and momentum characteristics of a heated transitional boundary layer were investigated with free-stream turbulence ranging from 0.3 to 0.6 percent. Boundary layer measurements were conducted for two constant-K cases, K1 = −0.51 × 10−6 and K2 = −1.05 × 10−6. The fluctuation quantities, u′, ν′, t′, the Reynolds shear stress (uν), and the Reynolds heat fluxes (νt and ut) were measured. In general, u′/U∞, ν′/U∞, and νt have higher values across the boundary layer for the adverse pressure-gradient cases than they do for the baseline case (K = 0). The development of ν′ for the adverse pressure gradients was more actively involved than that of the baseline. In the early transition region, the Reynolds shear stress distribution for the K2 case showed a near-wall region of high-turbulent shear generated at Y+ = 7. At stations farther downstream, this near-wall shear reduced in magnitude, while a second region of high-turbulent shear developed at Y+ = 70. For the baseline case, however, the maximum turbulent shear in the transition region was generated at Y+ = 70, and no near-wall high-shear region was seen. Stronger adverse pressure gradients appear to produce more uniform and higher t′ in the near-wall region (Y+ < 20) in both transitional and turbulent boundary layers. The instantaneous velocity signals did not show any clear turbulent/nonturbulent demarcations in the transition region. Increasingly stronger adverse pressure gradients seemed to produce large non turbulent unsteadiness (or instability waves) at a similar magnitude as the turbulent fluctuations such that the production of turbulent spots was obscured. The turbulent spots could not be identified visually or through conventional conditional-sampling schemes. In addition, the streamwise evolution of eddy viscosity, turbulent thermal diffusivity, and Prt, are also presented.

scholarly journals Active control of multiscale features in wall-bounded turbulence

2019 ◽  
Vol 36 (1) ◽  
pp. 12-21 ◽  
Author(s):  
Xiaotong Cui ◽  
Nan Jiang ◽  
Xiaobo Zheng ◽  
Zhanqi Tang
Keyword(s):  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Turbulent Energy ◽  
Streamwise Velocity ◽  
Discrete Wavelet ◽  
Wall Region ◽  
Mean Velocity ◽  
Pzt Actuator ◽  
The Impact ◽  
Near Wall

Abstract This study experimentally investigates the impact of a single piezoelectric (PZT) actuator on a turbulent boundary layer from a statistical viewpoint. The working conditions of the actuator include a range of frequencies and amplitudes. The streamwise velocity signals in the turbulent boundary layer flow are measured downstream of the actuator using a hot-wire anemometer. The mean velocity profiles and other basic parameters are reported. Spectra results obtained by discrete wavelet decomposition indicate that the PZT vibration primarily influences the near-wall region. The turbulent intensities at different scales suggest that the actuator redistributes the near-wall turbulent energy. The skewness and flatness distributions show that the actuator effectively alters the sweep events and reduces intermittency at smaller scales. Moreover, under the impact of the PZT actuator, the symmetry of vibration scales’ velocity signals is promoted and the structural composition appears in an orderly manner. Probability distribution function results indicate that perturbation causes the fluctuations in vibration scales and smaller scales with high intensity and low intermittency. Based on the flatness factor, the bursting process is also detected. The vibrations reduce the relative intensities of the burst events, indicating that the streamwise vortices in the buffer layer experience direct interference due to the PZT control.

Direct numerical simulation of high-speed transition due to an isolated roughness element

2014 ◽  
Vol 748 ◽  
pp. 848-878 ◽  
Author(s):  
Pramod K. Subbareddy ◽  
Matthew D. Bartkowicz ◽  
Graham V. Candler
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
High Speed ◽  
Large Scale ◽  
Stokes Equations ◽  
Roughness Element ◽  
Dynamic Mode Decomposition ◽  
Large Reynolds Number ◽  
Dynamic Mode ◽  
Low Dissipation

AbstractWe study the transition of a Mach 6 laminar boundary layer due to an isolated cylindrical roughness element using large-scale direct numerical simulations (DNS). Three flow conditions, corresponding to experiments conducted at the Purdue Mach 6 quiet wind tunnel are simulated. Solutions are obtained using a high-order, low-dissipation scheme for the convection terms in the Navier–Stokes equations. The lowest Reynolds number ($Re$) case is steady, whereas the two higher $Re$ cases break down to a quasi-turbulent state. Statistics from the highest $Re$ case show the presence of a wedge of fully developed turbulent flow towards the end of the domain. The simulations do not employ forcing of any kind, apart from the roughness element itself, and the results suggest a self-sustaining mechanism that causes the flow to transition at a sufficiently large Reynolds number. Statistics, including spectra, are compared with available experimental data. Visualizations of the flow explore the dominant and dynamically significant flow structures: the upstream shock system, the horseshoe vortices formed in the upstream separated boundary layer and the shear layer that separates from the top and sides of the cylindrical roughness element. Streamwise and spanwise planes of data were used to perform a dynamic mode decomposition (DMD) (Rowley et al., J. Fluid Mech., vol. 641, 2009, pp. 115–127; Schmid, J. Fluid Mech., vol. 656, 2010, pp. 5–28).

scholarly journals Recursive dynamic mode decomposition of transient and post-transient wake flows

2016 ◽  
Vol 809 ◽  
pp. 843-872 ◽  
Author(s):  
Bernd R. Noack ◽  
Witold Stankiewicz ◽  
Marek Morzyński ◽  
Peter J. Schmid
Keyword(s):  
Dynamic Mode Decomposition ◽  
Attractive Alternative ◽  
Dynamic Mode ◽  
Cylinder Wake ◽  
Frequency Content ◽  
Mode Decomposition ◽  
Nonlinear Transient ◽  
Galerkin Models ◽  
Nonlinear Transient Dynamics ◽  
Proper Orthogonal

A novel data-driven modal decomposition of fluid flow is proposed, comprising key features of proper orthogonal decomposition (POD) and dynamic mode decomposition (DMD). The first mode is the normalized real or imaginary part of the DMD mode that minimizes the time-averaged residual. The $N$th mode is defined recursively in an analogous manner based on the residual of an expansion using the first $N-1$ modes. The resulting recursive DMD (RDMD) modes are orthogonal by construction, retain pure frequency content and aim at low residual. Recursive DMD is applied to transient cylinder wake data and is benchmarked against POD and optimized DMD (Chen et al., J. Nonlinear Sci., vol. 22, 2012, pp. 887–915) for the same snapshot sequence. Unlike POD modes, RDMD structures are shown to have purer frequency content while retaining a residual of comparable order to POD. In contrast to DMD, with exponentially growing or decaying oscillatory amplitudes, RDMD clearly identifies initial, maximum and final fluctuation levels. Intriguingly, RDMD outperforms both POD and DMD in the limit-cycle resolution from the same snapshots. Robustness of these observations is demonstrated for other parameters of the cylinder wake and for a more complex wake behind three rotating cylinders. Recursive DMD is proposed as an attractive alternative to POD and DMD for empirical Galerkin models, in particular for nonlinear transient dynamics.

Sign in / Sign up

Export Citation Format

Share Document