Analytical linear theory for the shock and re-shock of isotropic density inhomogeneities

2012 ◽  
Vol 700 ◽  
pp. 214-245 ◽  
Author(s):  
C. Huete ◽  
J. G. Wouchuk ◽  
B. Canaud ◽  
A. L. Velikovich

AbstractWe present an analytical model that describes the linear interaction of two successive shocks launched into a non-uniform density field. The re-shock problem is important in different fields, inertial confinement fusion among them, where several shocks are needed to compress the non-uniform target. At first, we present a linear theory model that studies the interaction of two successive shocks with a single-mode density perturbation field ahead of the first shock. The second shock is launched after the sonic waves emitted by the first shock wave have vanished. Therefore, in the case considered in this work, the second shock only interacts with the entropic and vortical perturbations left by the first shock front. The velocity, vorticity and density fields are later obtained in the space behind the second shock. With the results of the single-mode theory, the interaction with a full spectrum of random-isotropic density perturbations is considered by decomposing it into Fourier modes. The model describes in detail how the second shock wave modifies the turbulent field generated by the first shock wave. Averages of the downstream quantities (kinetic energy, vorticity, acoustic flux and density) are easily obtained either for two-dimensional or three-dimensional upstream isotropic spectra. The asymptotic limits of very strong shocks are discussed. The study shown here is an extension of previous works, where the interaction of a planar shock wave with random isotropic vorticity/entropy/acoustic spectra were studied independently. It is also a preliminary step towards the understanding of the re-shock of a fully turbulent flow, where all three of the modes, vortical, entropic and acoustic, might be present.

2019 ◽  
Vol 59 (10) ◽  
pp. 106016 ◽  
Author(s):  
Xin-Xin Yan ◽  
Hong-Bo Cai ◽  
Wen-Shuai Zhang ◽  
Liang Hao ◽  
Pei-Lin Yao ◽  
...  

Science ◽  
2008 ◽  
Vol 322 (5909) ◽  
pp. 1822-1825 ◽  
Author(s):  
M. D. Knudson ◽  
M. P. Desjarlais ◽  
D. H. Dolan

The high–energy density behavior of carbon, particularly in the vicinity of the melt boundary, is of broad scientific interest and of particular interest to those studying planetary astrophysics and inertial confinement fusion. Previous experimental data in the several hundred gigapascal pressure range, particularly near the melt boundary, have only been able to provide data with accuracy capable of qualitative comparison with theory. Here we present shock-wave experiments on carbon (using a magnetically driven flyer-plate technique with an order of magnitude improvement in accuracy) that enable quantitative comparison with theory. This work provides evidence for the existence of a diamond-bc8-liquid triple point on the melt boundary.


Author(s):  
Erik S. Proano ◽  
Bertrand Rollin

This work presents simulations of a heavy gas, SF6, immersed within a light gas, air, under the effect of a converging shock wave. Upon interaction of the shock wave with the perturbed interface between air and SF6, Richtmyer-Meshkov instability (RMI) and, later, Rayleigh-Taylor instability (RTI) take place. More precisely, a succession of RMI and RTI occurs due to multiple shock and rarefaction waves, and gives rise to mixing between the heavy and light fluids. The problem of hydrodynamic instability-induced mixing in converging geometry is particularly relevant to engineering applications such as the process of nuclear fusion by the inertial confinement approach. This study is motivated by the need to better understand the relation between the initial perturbations at the interface between the fluids and the development of the instabilities and mixing in a converging geometry. Using the Flash Code, a PPM hydrodynamic solver developed by the ASC center at the University of Chicago [1], this study focuses on the growth rate of instabilities and the subsequent mixing associated with various carefully designed initial interfacial perturbations in the implosion configuration described above. In cylindrical geometry, comparisons between the growth of high and low frequency single mode perturbations are presented. It is found that at later times, after RMI and RTI take place, the width of the mixing layer is the largest for the low-wavenumber initial interface perturbation. Also, simulations show that the SF6 target with the highest wavenumber perturbation presents the most mixing at the later times but the lowest wavenumber initial interface perturbation presents the most mixing before reshock.


2018 ◽  
Vol 36 (3) ◽  
pp. 405-426 ◽  
Author(s):  
T. Pisarczyk ◽  
S.Yu. Gus'kov ◽  
R. Dudzak ◽  
O. Renner ◽  
D. Batani ◽  
...  

AbstractThis paper provides a summary of recent research connected with the shock ignition (SI) concept of the inertial confinement fusion which was carried out at PALS. In the experiments, Cu planar targets coated with a thin CH layer were used. Two-beam irradiation experiment was applied to investigate the effect of preliminary produced plasma to shock-wave generation. The 1ω or 3ω main beam with a high intensity >1015 W/cm2 generates shock wave, while the other 1ω beam with the intensity below 1014 W/cm2 creates CH pre-plasma simulating the pre-compressed plasma related to SI. Influence of laser wavelength on absorbed energy transfer to shock wave was studied by means of femtosecond interferometry and measuring the crater volume. To characterize the hot electron and ion emission, two-dimensional (2D) Kα-imaging of Cu plasma and grid collector measurements were used. In single 1ω beam experiments energy transport by fast electrons produced by resonant absorption made a significant contribution to shock-wave pressure. However, two-beam experiments with 1ω main beam show that the pre-plasma is strongly degrading the scalelength which leads to decreasing the fast electron energy contribution to shock pressure. In both the single 3ω beam experiments and the two-beam experiments with the 3ω main beam, do not show any clear influence of fast electron transport on shock-wave pressure. The non-monotonic behavior of the scalelength at changing the laser beam focal radius in both presence and absence of pre-plasma reflects the competition of plasma motion and electron heat conduction under the conditions of one-dimensional and 2D plasma expansion at large and small focal radii, respectively.


Author(s):  
C. W. Price ◽  
E. F. Lindsey

Thickness measurements of thin films are performed by both energy-dispersive x-ray spectroscopy (EDS) and x-ray fluorescence (XRF). XRF can measure thicker films than EDS, and XRF measurements also have somewhat greater precision than EDS measurements. However, small components with curved or irregular shapes that are used for various applications in the the Inertial Confinement Fusion program at LLNL present geometrical problems that are not conducive to XRF analyses but may have only a minimal effect on EDS analyses. This work describes the development of an EDS technique to measure the thickness of electroless nickel deposits on gold substrates. Although elaborate correction techniques have been developed for thin-film measurements by x-ray analysis, the thickness of electroless nickel films can be dependent on the plating bath used. Therefore, standard calibration curves were established by correlating EDS data with thickness measurements that were obtained by contact profilometry.


2020 ◽  
Vol 36 ◽  
pp. 100749 ◽  
Author(s):  
R.E. Olson ◽  
R.J. Leeper ◽  
S.H. Batha ◽  
R.R. Peterson ◽  
P.A. Bradley ◽  
...  

2021 ◽  
Vol 28 (3) ◽  
pp. 032713
Author(s):  
Dongguo Kang ◽  
Huasen Zhang ◽  
Shiyang Zou ◽  
Wudi Zheng ◽  
Shaoping Zhu ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document