Polynomial approach for modeling a piezoelectric disc resonator partially covered with electrodes

Wave Motion ◽  
2016 ◽  
Vol 64 ◽  
pp. 79-91 ◽  
Author(s):  
L. Elmaimouni ◽  
J.E. Lefebvre ◽  
F.E. Ratolojanahary ◽  
J.G. Yu ◽  
P.M. Rabotovao ◽  
...  
Keyword(s):  
Piezoelectric Disc

scholarly journals Collimated acoustic beams from radial modes of piezoelectric disc transducers

2019 ◽  
Author(s):  
Vamshi Krishna Chillara ◽  
Eric S. Davis ◽  
Cristian Pantea ◽  
Dipen N. Sinha
Keyword(s):  
Acoustic Beams ◽  
Piezoelectric Disc

scholarly journals Development of an assembly for the realization of a transducer able to operate at very high temperatures

2019 ◽  
Vol 283 ◽  
pp. 07011
Author(s):  
Didier Flotté ◽  
David Macel ◽  
Abd Ennour Bouzenad ◽  
Frédéric Navacchia
Keyword(s):  
Stainless Steel ◽  
High Temperatures ◽  
Nuclear Reactor ◽  
New Technology ◽  
Operating Conditions ◽  
Equivalent Diameter ◽  
Assembly Technique ◽  
The One ◽  
Piezoelectric Disc ◽  
Very High

Monitoring the operation of the latest-generation nuclear reactor requires ultrasonic transducers able to operate at very high temperatures (> 600°C). To achieve this, CEA has requested from “Institut de Soudure” to help developing a new technology for these transducers compared to the one previously developed. This began with the development of a reliable assembly technique between a lithium niobate piezoelectric disc whose Curie temperature exceeds 1100°C and stainless steel discs. The chosen solution was to braze the niobate disc between two stainless steel discs. Parallel to this development, it was also necessary to develop a NDE procedure to verify the quality of the brazing assemblies. This development began with a simulation of immersion ultrasonic testing of the assemblies. The constraints were to be able to control the two brazed interfaces from the same access face, with the possibility of detecting and dimensioning defects with an equivalent diameter of 0.25 mm. This phase is important to define the optimal transducer with the associated operating conditions. The first assemblies validated the preliminary choices. To exploit the cartographies obtained, a signal processing procedure was developed. This enabled an automatic characterization of the indications observed. However, the analysis of the signals observed proved to be more complex than the one predicted by the simulation. Once the origin of the various observed signals was identified it was then possible to define windows allowing the construction of the cartographies to analyze. In case of a good quality assembly, it was possible to qualify the generated beam and to image it in the focal plane but with an observed signal having a very low damping. These first encouraging results, however, show that there is still some validation and development work to increase the sensitivity of the developed translator and its damping.

Sign in / Sign up

Export Citation Format

Share Document